Owner Reuse or Modification of Work Product Sample Clauses

Owner Reuse or Modification of Work Product. If the Owner reuses or modifies the Work Product without the Consultant’s involvement or prior written consent, to the extent permitted by Article XI, Section 7 of the Oregon Constitution and by the Oregon Tort Claims Act, the Owner shall indemnify, within the limits of the Tort Claims Act, the Consultant against liability for damage to life or property arising from the Owner's reuse or modification of the Work Product, provided the Owner shall not be required to indemnify the Consultant for any such liability arising out of the wrongful acts of the Consultant or the Consultant’s officers, employees, sub-consultants, subcontractors, or agents.
Sample 1Sample 2Sample 3See All (9)
AutoNDA by SimpleDocs
Owner Reuse or Modification of Work Product. If the Owner reuses or modifies the Work Product without the Design Professional's involvement or prior written consent, the Owner shall indemnify, in an amount up to two times the Maximum Compensation to be paid under this Agreement, the Design Professional against liability for damage to life or property arising from the Owner’s reuse or modification of the Work Product, provided the Owner shall not be required to indemnify the Design Professional for any such liability arising out of the wrongful acts of the Design Professional or the Design Professional's officers, employees, Consultants, subcontractors, or agents.
Sample 1Sample 2Sample 3See All (4)
Owner Reuse or Modification of Work Product. If Owner reuses or modifies the Work Product without Architect's involvement or prior written consent, to the extent permitted by Article XI, Section 7 of the Oregon Constitution and by the Oregon Tort Claims Act, Owner shall indemnify, within the limits of the Tort Claims Act, Architect against liability for damage to life or property arising from the State's reuse or modification of the Work Product, provided Owner shall not be required to indemnify Architect for any such liability arising out of the wrongful acts of Architect or Architect's officers, employees, Consultants, subcontractors, or agents.
Sample 1Sample 2

Related to Owner Reuse or Modification of Work Product

  • Modification of Work Schedule When a change of work schedule is requested by an employee and approved by the Agency, all forms of penalty pay and daily overtime compensation shall be waived by the employee for the requested change in schedule, but not for work over forty (40) hours per week.

  • Completion of Works Buildings will be considered complete on the issue of the City’s Certificate of Occupancy. Other structures will be considered complete on the issue of the Company’s engineers notification of the completion of construction, and by the City’s certification.

  • Statement of Work The Contractor shall provide the services and staff, and otherwise do all things necessary for or incidental to the performance of work, as set forth below:

  • USE OF WORK PRODUCTS 2.13.1 The City may use all Documents that Contractor prepares or obtains under this Agreement. In addition, Contractor shall provide the Director with supporting schedules, flow charts or other analysis necessary to understand the reported findings and recommendations. Generally, this information is attached as exhibits to the final report; however, if requested by the Director, Contractor shall provide this information from its work paper files.

  • CORRECTION OF WORK 13.2.1 The Contractor shall be responsible for correcting all Work which the Architect has found to be defective or which fails to conform to the Contract Documents whether observed be- fore or after Substantial Completion and whether or not fabricated, installed or completed. The Contractor shall bear all costs of correcting such rejected Work, including compensation for the Architect's and the State’s additional services made necessary thereby. The Architect, upon a finding of defect or failure to conform, shall immediately notify the State and Contractor, in writing, of the defect. The Contractor shall begin correcting the defective or non-conforming Work within ten (10) days unless the State agrees to a Change Order which reflects the reduction in Contract Sum due to the value of diminishment of the defective or nonconforming Work.

  • PROTECTION OF WORK 12.1 Subcontractor shall effectually secure and protect the work done hereunder and assume full responsibility for the condition thereof until final acceptance by the OWNER and Contractor. Subcontractor further agrees to provide such protection as is necessary to protect the work and the workmen of Contractor, the OWNER, and other subcontractors from its operations.

  • COMMENCEMENT OF WORK UNDER A SOW AGREEMENT Commencement of work as a result of the SOW-RFP process shall be initiated only upon issuance of a fully executed SOW Agreement and Purchase Order.

  • Work Order (s) means a detailed scope of work for a Service required by Transnet, including timeframes, Deliverable, Fees and costs for the supply of the Service to Transnet, which may be appended to this Agreement from time to time.

  • Xxxxx of Work The Contractor shall provide information technology (IT) independent verification and validation (IV&V) services to Customers in accordance with this Statement of Work (SOW). The Contractor shall provide the professional and technical staff necessary to perform the ((IT) IV&V services required by this Contract, and the staff shall have sufficient skill and experience to perform the services assigned to them. All of the (IT) IV&V services to be furnished by the Contractor under the Contract shall meet the professional standard and quality that prevail among IT professionals in the same discipline and of similar knowledge and skill engaged in related work under the same or similar circumstances. The Contractor shall maintain during the term of the Contract all licenses, permits, qualifications, insurance, and approvals of whatever nature that are legally required to perform the (IT) IV&V services.

  • Change Order Formats Formats for Lump Sum Change Orders and for Change Orders based upon either a force account or upon unit pricing with an indeterminate number of units are in Section 7, Forms.

Time is Money Join Law Insider Premium to draft better contracts faster.