Limits of Liability To the fullest extent permitted by applicable law, (1) You agree that We and HomeServe, and both of our respective parents, successors, affiliates, approved technicians and Our and their officers, directors, employees, affiliates, agents, contractors or similar parties acting on behalf of either Us or HomeServe shall not be liable to You or anyone else for: (a) any actual losses or direct damages that exceed the lowest applicable per repair Benefit Limit, or, if there is no maximum Benefit Limit, any actual losses or direct damages that exceed the cost of repairs provided for in the “What is a Covered Repair?” section(s) of this Service Agreement, relating to any repairs performed by Us, HomeServe or on behalf of either Us or HomeServe or services provided hereunder giving rise to such loss or damage; or (b) any amount of any form of indirect, special, punitive, incidental or consequential losses or damages, damages based on anticipated or lost profits, wages, or revenue, or damages based on diminution in value or a multiple of earnings, including those caused by any fault, failure, delay or defect in providing any repairs performed by Us, HomeServe or on behalf of either Us or HomeServe or services provided under this Service Agreement, regardless of whether such damages were foreseeable and whether or not We or HomeServe or anyone acting on behalf of either Us or HomeServe have been advised of the possibility of such damages (the damages listed in clauses (a) and (b), collectively the “Excluded Damages”); and (2) these limitations and waivers shall apply to all claims and all liabilities and shall survive the cancellation or expiration of this Service Agreement. You may have other rights that vary from state to state. Arbitration: YOU, NHRW AND HOMESERVE ALL AGREE TO RESOLVE DISPUTES BY BINDING ARBITRATION as follows:
Risks and Limits of Liability Contractor shall maintain the following insurance coverages in the following amounts:
Engineer Payment of Subproviders No later than ten (10) days after receiving payment from the State, the Engineer shall pay all subproviders for work performed under a subcontract authorized hereunder. The State may withhold all payments that have or may become due if the Engineer fails to comply with the ten-day payment requirement. The State may also suspend the work under this contract or any work authorization until subproviders are paid. This requirement also applies to all lower tier subproviders, and this provision must be incorporated into all subcontracts.
PAYMENT OF SUBCONTRACTORS Contractor shall pay any of its subcontractors not later than seven (7) days after receipt of any progress payment, unless otherwise agreed to in writing, the respective amounts allowed Contractor on account of the work performed by subcontractor(s), to the extent of each subcontractor’s interest therein, except as otherwise provided in Business and Professions Code Section 7108.5.
Use of sub-processors (a) The data importer has the data exporter’s general authorisation for the engagement of sub-processor(s) from an agreed list. The data importer shall specifically inform the data exporter in writing of any intended changes to that list through the addition or replacement of sub-processors at least thirty (30) days in advance, thereby giving the data exporter sufficient time to be able to object to such changes prior to the engagement of the sub-processor(s). The data importer shall provide the data exporter with the information necessary to enable the data exporter to exercise its right to object.
Use of Sub-Contractors A framework of practical business provisions. Edit as you require. This ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ - ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ .
Limits on Liability EXCEPT FOR THE INDEMNIFICATION PROVISIONS HEREIN THIS AGREEMENT, NEITHER PARTY IS LIABLE UNDER THIS AGREEMENT FOR ANY LOST PROFITS, LOSS OF DATA, OR ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES, EXCEPT FOR ANY WILLFUL UNAUTHORIZED DISCLOSURE OF CONFIDENTIAL INFORMATION OR LICENSEE’S WILLFUL BREACH. EXCEPT FOR THE INDEMNIFICATION PROVISIONS HEREIN, LICENSOR’S AGGREGATE LIABILITY IN CONNECTION WITH THIS AGREEMENT UNDER ANY THEORY OF LIABILITY (INCLUDING BREACH OF CONTRACT OR INDEMNITY) IS LIMITED TO THE AGGREGATE OF FEES PAID BY LICENSEE TO LICENSOR. UNDER NO CIRCUMSTANCES WILL LICENSOR (OR ITS AGENTS) HAVE LIABILITY RELATING TO PRODUCT USED OR DISTRIBUTED BY LICENSOR OR BY THIRD PARTIES.
Aggregate Limits of Liability The basic coverage limits of liability may be subject to annual aggregate limits. If this is the case the annual aggregate limits of liability must be at least two (2) times the limits required for each policy, or the aggregate may equal the limits required but must apply separately to this Agreement.
LIST OF SUB-PROCESSORS The controller has authorised the use of the following sub-processors:
Oversight of Subcontractors In the event that Vendor engages subcontractors or other authorized persons or entities to perform one or more of its obligations under the Master Agreement (including subcontracting hosting of the Protected Data to a hosting service provider), it will require those subcontractors or other authorized persons or entities to whom it will disclose the Protected Data to execute legally binding agreements acknowledging their obligation under Section 2-d of the New York Education Law to comply with all applicable data protection, privacy and security requirements required of Vendor under the Master Agreement and applicable state and federal law and regulations.
