Examples of Lamp Lumens in a sentence
Notes: • Light Source efficacy shall be determined by the following equation: Light Source efficacy [Lumens per Watt] = Measured Lamp Lumens [Lumens]Measured Input Power [Watts] • Lamp Lumens: Lamp lumens must be measured using the lamp and ballast that are shipped with the residential ventilating fan.
Notes: Light Source efficacy shall be determined by the following equation: Light Source efficacy [Lumens per Watt] = Measured Lamp Lumens [Lumens]Measured Input Power [Watts] • Lamp Lumens: Lamp lumens must be measured using the lamp and ballast that are shipped with the residential ventilating fan.
Lamp sockets cannot accept incandescent lamps.Maximum Night Light Wattage# 4 Watts.Notes:• Light Source efficacy shall be determined by the following equation: Light Source efficacy [Lumens per Watt] = Measured Lamp Lumens [Lumens]Measured Input Power [Watts] • Lamp Lumens: Lamp lumens must be measured using the lamp and ballast that are shipped with the residential ventilating fan.
Light Source efficacy shall be determined by the following equation: Light Source efficacy [Lumens per Watt] = Measured Lamp Lumens [Lumens]Measured Input Power [Watts] • Lamp Lumens: Lamp lumens must be measured using the lamp and ballast that are shipped with the residential ventilating fan.
Lamp Lumens: lamp lumens must be measured using the lamp and ballast that are shipped with the fixture.For fixtures shipped without lamps, efficacy shall be determined using an "off the shelf” lamp; at least one of the lamp types listed on the fixture package.
The output figure is Lamp Lumens per circuit watts (ll/cW).Table 2 — Minimum efficiencies table for lighting units.
Efficacy shall be determined with the following equation:Efficacy [Lumens per Watt] = Measured Lamp Lumens [Lumens]Measured Input Power [Watts] Lamp Lumens: Lamp lumens must be measured using the lamp and ballast that are shipped with the fixture.
The equipment is selected as follows: Light Source = 1000-W HPS (Section 78-7.0)Mounting Height (MH) = 100 ft (assumed)Luminaire Distribution = Short Distribution, Type V, Cutoff glare control (S-C-V) Effective Mounting Height = 100 ftInitial Lamp Lumens (LL) = 140,000Lamp Lumen Depreciation Factor (LLD) = 0.90 (Section 78-6.03(04)) Luminaire Dirt Depreciation Factor (LDD) = 0.87 (Section 78-6.03(04)) 5.
Unshielded floodlights are not acceptable.Full Cutoff Light Fixtures allow no light at 90 degrees, and 100 cd per 1000 Lamp Lumens at 80 degrees.Cutoff Light Fixtures allow 25 cd per 1000 Lamp Lumens at 90 degrees, and 100 cd per 1000 Lamp Lumens at 80 degrees.
Not to exceed a measured level of 24 dBA when measured in a room with ambient noise no greater than 20 dBA.Maximum Total Lamp Wattage (excluding night lights)≤ 50 Watts.Maximum Night Light Wattage≤ 4 Watts.Notes: Light Source efficacy shall be determined by the following equation: Light Source efficacy [Lumens per Watt] = Measured Lamp Lumens [Lumens]Measured Input Power [Watts] • Lamp Lumens: Lamp lumens must be measured using the lamp and ballast that are shipped with the residential ventilating fan.