Iron and Manganese Removal definition

Iron and Manganese Removal means the process to remove soluble ferrous iron and manganese from ground water by oxidation. Oxidation can be accomplished by aeration, chlorine dioxide, or potassium permanganate. Aeration is followed by filtration through a mixed media filter for removal of solids. Wastewater generated in this process is from iron filter backwash, settling tank decant water preceding clean out, and KMO4 regeneration waste from batch regeneration.

Examples of Iron and Manganese Removal in a sentence

  • Iron and Manganese Removal Handbook, AWWA, Denver, CO.CHAPTER 10 Financial Viability‌ Chapter 10 covers the preparation of a realistic, balanced budget necessary to cover the total cost of operating and maintaining a safe and reliable water system.

  • The modules from the subjects “Geophysics” and “Electives” are weighted with their credit points and the module “Master Thesis” is weighted with twice the number of credit points.

  • Iron and Manganese Removal Handbook, AWWA, Denver, CO.CHAPTER 10 Financial Viability Chapter 10 covers the preparation of a realistic, balanced budget necessary to cover the total cost of operating and maintaining a safe and reliable water system.

  • Iron and Manganese Removal Process: The requirements of this table apply to permittees discharging to a low-flow stream (where the receiving water 7Q10 to discharge flow ratio is less than 1:1).

  • Since only United Water Conservation District’s Iron and Manganese Removal Project (Phase 1) has met the requirements for inclusion in the grant agreement, only that subgrant agreement needs to be executed at this time.

  • A licensee shall staff each group home with resident care staff in numbers sufficient to meet the staff to resident ratios specified in ss.

  • This item includes these services for the two projects included in the grant agreement, Calleguas’ Calleguas‐LVMWD Interconnection and United Water Conservation District’s Iron and Manganese Removal Project (Phase 1).

  • Iron and Manganese Removal Process: The requirements of this table apply to permittees discharging to high-flow streams (where the receiving water 7Q10 to discharge flow ratio is greater than or equal to 1:1).

  • Its emergency, rescue, and relief efforts were coordinated by the National Coordination Board for Disaster Management under the Vice President’s Office and the Coordinating Ministry for 2 People’s Welfare.

  • Project: Falcon Lake Water Treatment Plant – Innovative Iron and Manganese Removal Solution Category: Environmental Firm: TetrES Consultants Inc.

Related to Iron and Manganese Removal

  • Graffiti remover means a product labeled to remove spray paint, ink, marker, crayon, lipstick, nail polish, or shoe polish, from a variety of noncloth or nonfabric substrates. “Graffiti Remover” does not include “Paint Remover or Stripper,” “Nail Polish Remover,” or “Spot Remover.” Products labeled for dual use as both a paint stripper and graffiti remover are considered “Graffiti Removers.”

  • Emergency removal for purposes of this Policy shall mean removing a respondent from the District’s education program or activity on an emergency basis, provided that the District undertakes an individualized safety and risk analysis, determines that an immediate threat to the physical health or safety of any student or other individual arising from the allegations of sexual harassment justifies removal, and provides the respondent with notice and an opportunity to challenge the decision immediately following the removal. Emergency Removals as permitted by this Policy shall not be construed to modify any rights under the Individuals with Disabilities Education Act, Section 504 of the Rehabilitation Act of 1973, or the Americans with Disabilities Act.

  • General purpose adhesive remover means a product designed or labeled to remove cyanoacrylate adhesives as well as nonreactive adhesives or residue from a variety of substrates. “General Purpose Adhesive Remover” includes, but is not limited to, products that remove thermoplastic adhesives; pressure sensitive adhesives; dextrine or starch-based adhesives; casein glues; rubber or latex-based adhesives; as well as products that remove stickers; decals; stencils; or similar materials. “General Purpose Adhesive Remover” does not include “Floor or Wall Covering Adhesive Remover.”

  • Adhesive remover means a product designed to remove adhesive from either a specific substrate or a variety of substrates. “Adhesive Remover” does not include products that remove adhesives intended for use on humans or animals.

  • Direct filtration means a series of processes including coagulation and filtration but excluding sedimentation resulting in substantial particulate removal.

  • Nail polish remover means a product designed to remove nail polish and coatings from fingernails or toenails.

  • Removal means a removal for disciplinary reasons from the student’s current educational placement other than a suspension and change in placement to an interim alternative educational setting (IAES) ordered by an impartial hearing officer because the student poses a risk of harm to himself or herself or others.

  • Loose-fitting facepiece means a respiratory inlet covering that is designed to form a partial seal with the face.

  • Standard Methods for the Examination of Water and Wastewater means the most recent edition of Standard Methods for the Examination of Water and Wastewater published jointly by the American Public Health Association, the American Waterworks Association and the Water Environment Federation;

  • Pre-existing Medical Condition means any condition which:

  • Debilitating medical condition means one or more of the following:

  • Paint remover or stripper means any product designed to strip or remove paints or other related coatings, by chemical action, from a substrate without markedly affecting the substrate. “Paint Remover or Stripper” does not include “Multi-purpose Solvent,” paint brush cleaners, products designed and labeled exclusively as “Graffiti Remover,” and hand cleaner products that claim to remove paints and other related coatings from skin.

  • Initial appointment means appointment made otherwise than by promotion or transfer;

  • Safety-sensitive function means a job function or duty where a Covered Employee either:

  • Licensed site remediation professional means an individual who is licensed by the Site Remediation Professional Licensing Board pursuant to section 7 of P.L.2009, c.60 (C.58:10C-7) or the department pursuant to section 12 of P.L.2009, c.60 (C.58:10C-12).

  • sectional title scheme means a scheme defined in section 1 of the Sectional Titles Act;

  • Remediation waste means all solid and hazardous wastes, and all media (including groundwater, surface water, soils, and sediments) and debris that are managed for implementing cleanup.

  • Tight-fitting facepiece means a respiratory inlet covering that forms a complete seal with the face.

  • Complex or chronic medical condition means a physical,

  • Cannabis testing facility means an entity registered by

  • Demolition waste means that solid waste that is produced by the destruction of structures, or their foundations, or both, and includes the same materials as construction waste.

  • Containment means the installation of a backflow prevention assembly or a backflow prevention method at any connection to the public water system that supplies an auxiliary water system, location, facility, or area such that backflow from a cross connection into the public water system is prevented.

  • Bug and tar remover means a product labeled to remove either or both of the following from painted motor vehicle surfaces without causing damage to the finish:

  • Filtration means a process for removing particulate matter from water by passage through porous media.

  • Clean coal technology demonstration project means a project using funds appropriated under the heading “Department of Energy—Clean Coal Technology,” up to a total amount of $2,500,000,000 for commercial demonstration of clean coal technology, or similar projects funded through appropriations for the Environmental Protection Agency. The federal contribution for a qualifying project shall be at least 20 percent of the total cost of the demonstration project.

  • Remediation waste management site means a facility where an owner or operator is or will be treating, storing or disposing of hazardous remediation wastes. A remediation waste management site is not a facility that is subject to corrective action under § 264.101 of this regulation, but is subject to corrective action requirements if the site is located in such a facility.