WEIGHT/HEIGHT Sample Clauses

WEIGHT/HEIGHT. Each category will have matched up weight categories, these being micro, light, middle, heavy and hyper. The individual’s weight will be matched up as close as possible. E.g. A lower heavy weight won't be matched up against a larger heavy weight if avoidable. • An allowance maximum of 4kgs either side of an opponent’s individual weight is acceptable, anything higher must be confirmed and agreed by both participants and their respective coaches. • Weight is the main separation but as a secondary we also go by height in order to get the fairest draws possible. Male Weights: • MICRO: up to 54kg • LIGHT: 55 to 63kg • MIDDLE: 64 to 71kg • HEAVY: 72 to 80kg • HYPER: 81 to 89kg • HYPER X: 90kg + Female Weights: • MICRO: up to 52kg • LIGHT: 53 to 58kg • MIDDLE: 59 to 63kg • HEAVY: 64 to 70kg • HYPER: 71 to 80kg • HYPER X: 81kg +
Sample 1
AutoNDA by SimpleDocs

Related to WEIGHT/HEIGHT

  • Weight The percent of the Base Price subject to adjustment based on an index change.

  • Weights light, moderate and heavy, have their normal everyday meanings, and are to be applied consistently, regardless of the physical characteristics of the jobholder and whether the duties are normally carried out by women or by men; or by small people or large people; or by fit or unfit people. So, a sack of cement or a sack of potatoes is a heavy weight, even if it is lifted and carried without obvious exertion by a tall, fit, young person.

  • Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.

  • Temperature Measurement Temperature will be measured by the nearest automatic Melbourne Bureau of Meteorology Monitoring Station for example (but not limited to): Melbourne, Moorabbin, Dunns Hill, Melbourne Airport, Frankston, and Point Xxxxxx. At the commencement of each project, the onsite management and employee representatives shall agree which is to be the applicable automatic weather monitoring station.

  • Usage Measurement Usage measurement for calls shall begin when answer supervision or equivalent Signaling System 7 (SS7) message is received from the terminating office and shall end at the time of call disconnect by the calling or called subscriber, whichever occurs first.

  • CLASS SIZE/STAFFING LEVELS The board will make every effort to limit FDK/Grade 1 split grades where feasible. APPENDIX A – RETIREMENT GRATUITIES

  • Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.

  • Measuring EPP parameters Every 5 minutes, EPP probes will select one “IP address” of the EPP servers of the TLD being monitored and make an “EPP test”; every time they should alternate between the 3 different types of commands and between the commands inside each category. If an “EPP test” result is undefined/unanswered, the EPP service will be considered as unavailable from that probe until it is time to make a new test.

  • Brakes Master cylinder, wheel cylinders, hydraulic lines and fittings, power booster and brake callipers. Excludes linings, pads, drums and discs.

  • Temperature Where low temperature and/or self-service cases are used for any of such merchandise coming under the jurisdiction of the Union, such cases shall be served only by employees covered by this Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.