Design Criteria and Standards All PROJECTS/SERVICES shall be performed in accordance with instructions, criteria and standards set forth by the DIRECTOR.
Objectives and Scope 1. The Parties confirm their joint objective of strengthening their relations by developing their political dialogue and reinforcing their cooperation.
LICENSES AND STANDARDS 17 5.1 CONTRACTOR warrants that it has all necessary licenses and permits 18 required by the laws of the United States, State of California, County of 19 Orange and all other appropriate governmental agencies to perform the services 20 described in this Agreement, and agrees to maintain these licenses and permits 21 in effect for the duration of this Agreement. Further, CONTRACTOR warrants 22 that its employees shall conduct themselves in compliance with such laws and 23 licensure requirements including, without limitation, compliance with laws 24 applicable to sexual harassment and ethical behavior.
Standards for Determining Commercial Reasonableness Borrower and Silicon agree that a sale or other disposition (collectively, "sale") of any Collateral which complies with the following standards will conclusively be deemed to be commercially reasonable: (i) Notice of the sale is given to Borrower at least seven days prior to the sale, and, in the case of a public sale, notice of the sale is published at least seven days before the sale in a newspaper of general circulation in the county where the sale is to be conducted; (ii) Notice of the sale describes the collateral in general, non-specific terms; (iii) The sale is conducted at a place designated by Silicon, with or without the Collateral being present; (iv) The sale commences at any time between 8:00 a.m. and 6:00 p.m; (v) Payment of the purchase price in cash or by cashier's check or wire transfer is required; (vi) With respect to any sale of any of the Collateral, Silicon may (but is not obligated to) direct any prospective purchaser to ascertain directly from Borrower any and all information concerning the same. Silicon shall be free to employ other methods of noticing and selling the Collateral, in its discretion, if they are commercially reasonable.
Technical Objections to Grievances It is the intent of both parties to this agreement that no grievance shall be defeated merely because of a technical error other than time limitations in processing the grievance through the grievance procedure. To this end an arbitration board shall have the power to allow all necessary amendments to the grievance and the power to waive formal procedural irregularities in the processing of a grievance in order to determine the real matter in dispute and to render a decision according to equitable principles and the justice of the case.
Minimum Standards (a) It is intended that the provisions contained in the Employment Standards Act and Regulations (Act), presently in effect and from time to time amended, are minimum requirements only.
Policies, Guidelines, Directives and Standards Either the LHIN or the MOHLTC will give the HSP Notice of any amendments to the manuals, guidelines or policies identified in Schedule C. An amendment will be effective in accordance with the terms of the amendment. By signing a copy of this Agreement the HSP acknowledges that it has a copy of the documents identified in Schedule C.
Applicable Standards The requirements and guidelines of NERC, the Applicable Regional Entity, and the Control Area in which the Customer Facility is electrically located; the PJM Manuals; and Applicable Technical Requirements and Standards.
Scope and Objectives 1. This Partnership Agreement (hereinafter referred to as the “Agreement”) defines the rights and obligations of the Parties and sets forth the terms and conditions of their cooperation in the implementation of the Project.
Quality Standards Each Party agrees that the nature and quality of its products and services supplied in connection with the other Party's Marks will conform to quality standards set by the other Party. Each Party agrees to supply the other Party, upon request, with a reasonable number of samples of any Materials publicly disseminated by such Party which utilize the other Party's Marks. Each Party will comply with all applicable laws, regulations, and customs and obtain any required government approvals pertaining to use of the other Party's marks.
