Common use of PPAP Clause in Contracts

PPAP. Seller agrees to comply with all requirements of the industry-standard Production Part Approval Processes (“PPAP”) for all Products. ▇▇▇▇▇ ▇ PPAP is required for all Products unless (a) the parts supplied to Purchaser are in production on another automotive vehicle platform and have a prior Level 3 PPAP (100% production tooled/ 100% production process), in which case a copy of the part submission warrant is required and Purchaser reserves the right to request further proof of documentation and/or data; or (b) the Products are interim or prototype, in which case, and in lieu of a Level 3 submission, 100% inspection of all Products, material certification for each Product, and a control plan is required in advance of every shipment to Purchaser, and failure to supply this information will result in the rejection of Seller’s Products. The foregoing PPAP requirement applies only to the first shipments of new production parts, unless there is a production facility or tooling move, change of any supplier, design (by either Party), manufacturing facility, or tooling, and/or change of any manufacturing process. In the event of any conflict between quality requirements between express provisions of these Terms and Conditions and any part of the programs, requirements and/or standards referenced in this Section 5.2, the provisions that require higher quality standards shall control. Products may not be shipped from the Seller’s facility until PPAP approval is granted by Purchaser or written authorization is given by ▇▇▇▇▇▇▇▇▇. Seller is responsible for all costs incurred by Purchaser or for any Products shipped that do not conform to the requirements specified in this Section 5.2.

PPAP. Seller agrees to comply with all requirements of the industry-standard Production Part Approval Processes (“PPAP”) for all Products. ▇▇▇▇▇ ▇ PPAP is required for all Products unless (a) the parts supplied to Purchaser are in production on another automotive vehicle platform and have a prior Level 3 PPAP (100% production tooled/ 100% production process), in which case a copy of the part submission warrant is required and Purchaser reserves the right to request further proof of documentation and/or data; or (b) the Products are interim or prototype, in which case, and in lieu of a Level 3 submission, 100% inspection of all Products, material certification for each Product, and a control plan is required in advance of every shipment to Purchaser, and failure to supply this information will result in the rejection of Seller’s Products. The foregoing PPAP requirement applies only to the first shipments of new production parts, unless there is a production facility or tooling move, change of any supplier, design (by either Party), manufacturing facility, or tooling, and/or change of any manufacturing process. In the event of any conflict between quality requirements between express provisions of these Terms and Conditions and any part of the programs, requirements and/or standards referenced in this Section 5.2, the provisions that require higher quality standards shall control. Products may not be shipped from the Seller’s facility until PPAP approval is granted by Purchaser or written authorization is given by ▇▇▇▇▇▇▇▇▇Purchaser. Seller is responsible for all costs incurred by Purchaser or for any Products shipped that do not conform to the requirements specified in this Section 5.2.