Protection Against Loss of Future District Revenues Section 4.1. INTENT OF THE PARTIES. Subject only to the limitations contained in this Agreement (including Section 7.1 of this Agreement), it is the intent of the Parties that the District shall, in accordance with the provisions of Section 313.027(f)(l) of the TEXAS TAX CODE, be compensated by Applicant for any loss that District incurs in its Maintenance and Operations Revenue in each year of this Agreement for which this Agreement was, in any manner, a producing cause, resulting, at least in part because of or on account of, the execution of this Agreement. Such payments shall be independent of, and in addition to such other payments as set forth in Article V and Article VI in this Agreement. Subject only to the limitations contained in this Agreement (including Section 7.1 of this Agreement), it is the intent of the Parties that the risk of any and all negative financial consequences to the District’s total annual Maintenance and Operations Revenue, to which the execution of this Agreement contributed in any manner, will be borne solely by Applicant and not by the District. The Parties hereto expressly understand and agree that, for all Tax Years to which this Agreement may apply, the calculation of negative financial consequences will be defined for each applicable Tax Year in accordance with the Applicable School Finance Law, as defined in Section 1.2 above, and that such definition specifically contemplates that calculations made under this Agreement may well periodically change in accordance with changes made from time to time in the Applicable School Finance Law. The Parties further agree that the printouts and projections produced during the negotiations and approval of this Agreement are: (i) for illustrative purposes only, are not intended to be relied upon, and have not been relied upon by the Parties as a prediction of future consequences to either Party to the Agreement; (ii) are based upon current School Finance Law, which is subject to change by statute, by administrative regulation, or by judicial decision at any time; and (iii) may change in future years to reflect changes in the Applicable School Finance Law.
GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
Use of Basement and Service Areas The basement(s) and service areas, if any, as located within the (project name), shall be earmarked for purposes such as parking spaces and services including but not limited to electric sub-station, transformer, DG set rooms, underground water tanks, pump rooms, maintenance and service rooms, fire fighting pumps and equipment's etc. and other permitted uses as per sanctioned plans. The Allottee shall not be permitted to use the services areas and the basements in any manner whatsoever, other than those earmarked as parking spaces, and the same shall be reserved for use by the association of allottees formed by the Allottees for rendering maintenance services.
Please see the current Washtenaw Community College catalog for up-to-date program requirements Secondary / Post-Secondary Program Alignment Welding HIGH SCHOOL COURSE SEQUENCE 9th Grade 10th Grade 11th Grade 12th Grade English 9 Algebra I World History/Geography Biology World Language Phys Ed/Health English 10 Geometry U.S. History/Geography Physics or Chemistry World Language Visual/Performing/Applied Arts English 11 Algebra II Civics/Economics Welding English 12 Math Credit Science Credit Welding WASHTENAW COMMUNITY COLLEGE Welding Associate in Applied Science Semester 1 Math Elective(s)* 3 WAF 105 Introduction to Welding Processes 2 WAF 111 Oxy-fuel Welding 4 WAF 112 Shielded Metal Arc Welding 4 Semester Total 13 Semester 2 Speech Elective(s) 3 WAF 106 Blueprint Reading for Welders 3 WAF 123 Advanced Oxy-fuel Welding 4 WAF 124 Advanced Shielded Metal Arc Welding 4 Semester Total 14 Semester 3 Arts/Human. Elective(s) 3 Computer Lit. Elective(s) 3 WAF 215 Advanced Gas Tungsten Arc Welding 4 WAF 288 Gas Metal Arc Welding 4 Semester Total 14 Semester 4 WAF 200 Layout Theory Welding 3 WAF 210 Welding Metallurgy 3 Soc. Sci. Elective(s) 3 WAF 226 Specialized Welding Procedures 4 Semester Total 13 Semester 5 Nat. Sci. Elective(s) 4 WAF 227 Basic Fabrication 3 WAF 229 Shape Cutting Operations 3 Writing Elective(s) 3 Semester Total 13 Program Totals 67
No Warranty Regarding Goods or Services as Applicable We are not responsible for the quality, safety, legality, or any other aspect of any goods or services you purchase with the Card. Arbitration Any claim, dispute, or controversy (“Claim”) arising out of or relating in any way to: i) this Agreement; ii) the Card; iii) your acquisition of the Card; iv) your use of the Card; v) the amount of available funds in the Card Account; vi) advertisements, promotions or oral or written statements related to the Card, as well as goods or services purchased with the Card; vii) the benefits and services related to the Card; or viii) transactions on the Card, no matter how described, pleaded or styled, shall be FINALLY and EXCLUSIVELY resolved by binding individual arbitration conducted by the American Arbitration Association (“AAA”) under its Consumer Arbitration Rules. This arbitration agreement is made pursuant to a transaction involving interstate commerce, and shall be governed by the Federal Arbitration Act (9 U.S.C. 1-16). We will pay the initial filing fee to commence arbitration and any arbitration hearing that you attend shall take place in the federal judicial district of your residence. ARBITRATION OF YOUR CLAIM IS MANDATORY AND BINDING. NEITHER PARTY WILL HAVE THE RIGHT TO LITIGATE THAT CLAIM THROUGH A COURT. IN ARBITRATION, NEITHER PARTY WILL HAVE THE RIGHT TO A JURY TRIAL OR TO ENGAGE IN DISCOVERY, EXCEPT AS PROVIDED FOR IN THE AAA CODE OF PROCEDURE. For a copy of the procedures, to file a Claim or for other information about this organization, contact it at: AAA, 000 Xxxxxxx Xxxxxx, Xxx Xxxx, XX 00000, or at xxx.xxx.xxx. All determinations as to the scope, interpretation, enforceability and validity of this Agreement shall be made final exclusively by the arbitrator, which award shall be binding and final. Judgment on the arbitration award may be entered in any court having jurisdiction. NO CLASS ACTION, OR OTHER REPRESENTATIVE ACTION OR PRIVATE ATTORNEY GENERAL ACTION OR JOINDER OR CONSOLIDATION OF ANY CLAIM WITH A CLAIM OF ANOTHER PERSON OR CLASS OF CLAIMANTS SHALL BE ALLOWABLE. This arbitration provision shall survive: i) the termination of the Agreement; ii) the bankruptcy of any party; iii) any transfer, sale or assignment of the Card, or any amounts owed on the Card, to any other person or entity; or iv) expiration of the Card. If any portion of this arbitration provision is deemed invalid or unenforceable, the remaining portions shall remain in force. IF YOU DO NOT AGREE TO THE TERMS OF THIS ARBITRATION AGREEMENT, DO NOT ACTIVATE OR USE THE CARD. CALL 0-000-000-0000 TO CANCEL THE CARD AND MAKE ALTERNATE ARRANGEMENTS TO RECEIVE THE FUNDS ASSOCIATED WITH THE CARD ACCOUNT.
Application of General Conditions These General Conditions set forth the terms and conditions generally applicable to the Development Grant Agreement to the extent and subject to any modifications set forth in such agreement.”
Additional Procedures Applicable to High Value Accounts 1. If a Preexisting Individual Account is a High Value Account as of December 31, 2013, the Reporting [FATCA Partner] Financial Institution must complete the enhanced review procedures described in paragraph D of this section with respect to such account by December 31, 2014. If based on this review, such account is identified as a U.S. Reportable Account, the Reporting [FATCA Partner] Financial Institution must report the required information about such account with respect to 2013 and 2014 in the first report on the Account. For all subsequent years, information about the account should be reported on an annual basis.
Specific Order Processes and Requirements 1. Distributor will order Software from SAP using and filling out completely such forms and minimum order requirements as SAP may prescribe from time to time and must comply with any then-current order process for the specific Software product. Where applicable, Distributor agrees to use the electronic means provided by SAP for placing orders.
Agreement with Respect to Data Processing Equipment and Leases (a) The Receiver hereby grants to the Assuming Institution an exclusive option for the period of ninety (90) days commencing the day after Bank Closing to: (i) accept an assignment from the Receiver of all leased Data Processing Equipment and (ii) purchase at Fair Market Value from the Receiver all owned Data Processing Equipment. The Assuming Institution’s election under this option applies to both owned and leased Data Processing Equipment.
Description of Goods or Services and Additional Terms and Conditions The Contractor shall perform as set forth in Exhibit A. For purposes of this Contract, to perform and the performance in Exhibit A is referred to as “Perform” and the “Performance.”
