Method of Letting and Award Sample Clauses

Method of Letting and Award. Upon completion of all required bid documents, the Local Project Sponsor shall submit them to the Department for review and approval. The Department, subject to reimbursement by the Local Project Sponsor for its costs, shall be responsible for letting and award of the contract for construction of the Project, as provided below in Section 10, and, after satisfaction of the conditions set forth in subsection (d) below, shall populate the Engineering and Construction Management System (“ECMS”) with all required bid documents (except for those limited instances where the Local Project Sponsor has requested and received the Department’s approval to conduct a paper let instead of having the Project administered through ECMS, in which case Department policies and procedures for projects not administered in ECMS shall apply).
Sample 1
AutoNDA by SimpleDocs

Related to Method of Letting and Award

  • Method of Compensation It is understood by the parties that, insofar as pay is concerned, employees temporarily filling a position in a higher broadband level shall be paid according to the same compensation method as promoted employees pursuant to the Rules of the State Personnel System.

  • METHOD OF AWARD AND PROCEDURE FOR AWARDING A SOW AGREEMENT 5.1. Contractor selection, or the determination to terminate the SOW-RFP without award, shall be done in the best interest of the State.

  • METHOD OF AWARD Select a method of award below for vehicles built to specifications at the OEM factory, and/or pre-existing inventory, as applicable. Method of Award for Vehicles Built to Specifications at the OEM Factory: Lowest price to a single contractor that can meet the specified delivery date, and supply the total number of vehicles requested. Method of Award for Pre-Existing Inventory Vehicles: Lowest price to a single contractor that can meet the specified delivery date, and provide the total number of vehicles requested. Lowest price for each contractor responding to the mini-bid will be determined by calculating the sum of the Total NYS Contract Price for Mini-Bid for all vehicles bid (i.e., the Grand Total NYS Contract Price of Vehicles Bid). Lowest price, per vehicle (i.e., the Total NYS Contract Price for Mini-Bid), to multiple Contractors that can meet the specified delivery date.

  • Method of Service A Notice may be given by:

  • Method of Exercise Holder may exercise this Warrant by delivering a duly executed Notice of Exercise in substantially the form attached as Appendix 1 to the principal office of the Company. Unless Holder is exercising the conversion right set forth in Article 1.2, Holder shall also deliver to the Company a check, wire transfer (to an account designated by the Company), or other form of payment acceptable to the Company for the aggregate Warrant Price for the Shares being purchased.

  • Method of Payment Payment of the aggregate Exercise Price shall be by any of the following, or a combination thereof, at the election of the Optionee:

  • Method of Payback The employee must choose one (1) of the following options for paying back the overpayment:

  • Method of Measurement The harmonics emission on AC power lines generated by the vehicle representative of its type shall be measured using the method described in Annex 11. The method of measurement shall be defined by the vehicle manufacturer in accordance with the Technical Service.

  • Method of Notice All notices shall be given (i) by delivery in person (ii) by a nationally recognized next day courier service, (iii) by first class, registered or certified mail, postage prepaid, (iv) by facsimile, or (v) by electronic mail] to the address of the OETC Contract Administrator or Contractor's Contract Coordinator or such other address as either party may specify in writing.

  • Method of Selection Bidder will be selected under Cost Based Selection-L1 (CBS) and procedures described in this Tender Document.

Time is Money Join Law Insider Premium to draft better contracts faster.