Fitness For Work – Guideline For Supervisors. 1. Supervisor to discuss the matter with the employee discreetly
Fitness For Work – Guideline For Supervisors Sample Clauses
Related to Fitness For Work – Guideline For Supervisors
Fitness for Work 6.2.1 The parties to this Agreement agree that the maintenance of a safe and healthy working environment will be enhanced by adopting a pro-active approach to addressing fitness for work issues, including the misuse of drugs and alcohol in the workplace, workplace stress and fatigue. The management of these occupational health and safety issues will assist to eliminate a contributing factor to workplace injuries and accidents.
Fitness for Duty When question exists related to appropriate leave administration or work safety to individuals, co-workers or others, the EMPLOYER may require employees to undergo a medical evaluation that will enable the EMPLOYER to determine the employee’s fitness for performance of his/her duties. When the EMPLOYER requires an evaluation or report from a medical authority, either the employee’s personal or treating authority or the medical authority of the EMPLOYER’s selection, the EMPLOYER shall:
Fitness for Duty Examination A. In directing employees to undergo a fitness for duty examination, the Agency will observe applicable rules and regulations.
WORKLOAD STANDARDS One (1) Direct Service Hour (DSH) will be equal to sixty (60) minutes of direct services.
Standards for Network Elements 1.8.1 BellSouth shall comply with the requirements set forth in the technical references, as well as any performance or other requirements identified in this Agreement, to the extent that they are consistent with the greater of BellSouth’s actual performance or applicable industry standards.
Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.
Service Level Standards In addition to all other requirements in this Agreement, and in accordance with the Best Claims Practices & Estimating Guidelines, Vendor shall use reasonable and good faith efforts to meet the Service Level Standards set forth below.
Customer Service Standards The Franchising Authority hereby adopts the customer service standards set forth in Part 76, §76.309 of the FCC’s rules and regulations, as amended. The Grantee shall comply in all respects with the customer service requirements established by the FCC.
CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.
Requirement for Project Planning No physical work will begin on the construction site until the receipt of a Proceed Order issued by the Owner. The Contract assumes that a Proceed Order will be issued in not more than sixty days from the Effective Date of the Contract. Failure of the Contractor to provide the necessary documentation for the issuance of a Proceed Order shall not entitle the Contractor to any extension of time. If a Proceed Order is not issued within sixty days from the award of the Contract and non-issuance is due to nonperformance by the Contractor, the Contractor may be in default.
