Existing Coatings Sample Clauses

Existing Coatings. Remove surface irregularities by scraping or sanding to produce uniform substrate for coating application; apply one coat primer of type recommended by coating manufacturer for maximum coating adhesion. If presence of lead in existing coatings is suspected, cease surface preparation and notify Executive Director immediately.
AutoNDA by SimpleDocs

Related to Existing Coatings

  • Existing Agreements The Executive represents to the Company that he is not subject or a party to any employment or consulting agreement, non-competition covenant or other agreement, covenant or understanding which might prohibit him from executing this Agreement or limit his ability to fulfill his responsibilities hereunder.

  • Existing Contracts Billing terms and provisions contained in existing contracting entity agreements (existing as of the date this policy is approved by the Board of Supervisors) shall remain in effect for the life of the contract. However, when these existing contracts are renegotiated, they shall contain the billing provisions as set forth in this policy.

  • Existing Conditions Tenant accepts the Property in its condition as of the execution of the Lease, subject to all recorded matters, laws, ordinances, and governmental regulations and orders. Except as provided herein, Tenant acknowledges that neither Landlord nor any agent of Landlord has made any representation as to the condition of the Property or the suitability of the Property for Tenant's intended use. Tenant represents and warrants that Tenant has made its own inspection of and inquiry regarding the condition of the Property and is not relying on any representations of Landlord or any Broker with respect thereto. If Landlord or Landlord's Broker has provided a Property Information Sheet or other Disclosure Statement regarding the Property, a copy is attached as an exhibit to the Lease.

  • Business Partners Red Hat has entered into agreements with other organizations (“Business Partners”) to promote, market and support certain Software and Services. When Client purchases Software and Services through a Business Partner, Red Hat confirms that it is responsible for providing the Software and Services to Client under the terms of this Agreement. Red Hat is not responsible for (a) the actions of Business Partners, (b) any additional obligations Business Partners have to Client, or (c) any products or services that Business Partners supply to Client under any separate agreements between a Business Partner and Client.

  • Requirements Pertaining Only to Federal Grants and Subrecipient Agreements If this Agreement is a grant that is funded in whole or in part by Federal funds:

  • Measurements and Dimensions Before ordering material or doing work that is dependent upon coordination with building conditions, the Contractor shall verify all dimensions, elevations, grades, and pitch by taking measurements at the building and shall be responsible for the correctness of same. Any discrepancies between the drawings and/or specifications and the existing conditions shall be referred to the Design Professional for additional instructions before any work affected thereby is begun.

  • Project partners and partnership agreements 1. A project may be implemented in a partnership between the Project Promoter and project partners as defined in paragraph 1(w) of Article 1.6

  • BUILDINGS AND STRUCTURES 1. Repair or retrofit of buildings less than 45 years old.

  • GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.

  • Erosion and Sediment Control The Contractor shall install and maintain erosion and sediment control devices to prevent adjacent streets, storm drains and property from accumulations of soil, sediment, or dust which result from his work. Devices installed to control sediment and prevent erosion shall comply with the requirements of the Georgia Tech Project Superintendent. The Contractor is responsible for monitoring downstream conditions throughout the construction period and clearing any debris, sediment, and dust caused by the progress of the Work. The Contractor shall inspect, maintain, and clear erosion and sediment control devices at least weekly unless otherwise directed by the Georgia Institute of Technology Construction Manager. At the conclusion of the Work, the Contractor shall remove all installed devices and restoring the site to the satisfaction of the Georgia Tech Construction Manager.

Time is Money Join Law Insider Premium to draft better contracts faster.