EOTC and BMRC. One (1);
EOTC and BMRC Sample Clauses
Related to EOTC and BMRC
Secondary Schools a. Department Chairs (Department Heads) are primarily curricular. The job descriptions include but are not limited to the duties listed.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. Purchaser may buck out cull material when necessary to produce pieces meeting Utilization Standards. Such bucked out material shall contain a minimum amount of sound wood, not in excess of the net scale in percentage of gross scale, or based on the merchantability factor, whichever is stated in A2. If necessary to assess extent of defect, Purchaser shall make sample saw cuts or wedges. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Introduction and Background 1.1 The purpose of this Schedule 2 (Contract Services and Contract Supplies) is to set out the characteristics of the Contract Services and/or Contract Supplies (as the case may be) and Funding that the Provider will be required to make available to all Contracting Authorities in relation to Lot 1 and/or Lot 2 (as the case may be) and to provide a description of what the Contract Services and/or Contract Supplies (as the case may be) and Funding will entail.
Supplier Diversity Seller shall comply with Xxxxx’s Supplier Diversity Program in accordance with Appendix V.
Vendor’s Resellers as Related to This Agreement Vendor’s Named Resellers under this Agreement shall comply with all terms and conditions of this agreement and all addenda or incorporated documents. All actions related to sales by Authorized Vendor’s Resellers under this Agreement are the responsibility of the Awarded Vendor.
Marketing and Sales A. Provide a detailed plan beginning from award date of the Master Agreement describing the strategy to immediately implement the Master Agreement as supplier’s primary go to market strategy for Public Agencies to supplier’s teams, to include, but not limited to:
Vendors (a) Section 4.28(a) of the Company Disclosure Letter sets forth, as of the date of this Agreement, the top ten (10) vendors based on the aggregate Dollar value of the Company’s and its Subsidiaries’ transaction volume with such counterparty during the trailing twelve months for the period ending December 31, 2020 (the “Top Vendors”).
Program Monitoring and Evaluation (c) The Recipient shall prepare, or cause to be prepared, and furnish to the Association not later than six months after the Closing Date, a report of such scope and in such detail as the Association shall reasonably request, on the execution of the Program, the performance by the Recipient and the Association of their respective obligations under the Legal Agreements and the accomplishment of the purposes of the Financing.”
DISTRIBUTORS, VENDORS, RESELLERS Contractor agrees and acknowledges that any such designations of distributors, vendors, resellers or the like are for the convenience of the Contractor only and the awarded Contractor will remain responsible and liable for all obligations under the Contract and the performance of any designated distributor, vendor, reseller, etc. Contractor is also responsible for receiving and processing any Customer purchase order in accordance with the Contract and forwarding of the Purchase Order to the designated distributor, vendor, reseller, etc. to complete the sale or service. H-GAC reserves the right to reject any entity acting on the Contractor’s behalf or refuse to add entities after a contract is awarded.
Third Party Vendors Nothing herein shall impose any duty upon DST in connection with or make DST liable for the actions or omissions to act of the following types of unaffiliated third parties: (a) courier and mail services including but not limited to Airborne Services, Federal Express, UPS and the U.S. Mails, (b) telecommunications companies including but not limited to AT&T, Sprint, MCI and other delivery, telecommunications and other such companies not under the party’s reasonable control, and (c) third parties not under the party’s reasonable control or subcontract relationship providing services to the financial industry generally, such as, by way of example and not limitation, the National Securities Clearing Corporation (processing and settlement services), Fund custodian banks (custody and fund accounting services) and administrators (blue sky and Fund administration services), and national database providers such as Choice Point, Acxiom, TransUnion or Lexis/Nexis and any replacements thereof or similar entities, provided, if DST selected such company, DST shall have exercised due care in selecting the same. Such third party vendors shall not be deemed, and are not, subcontractors for purposes of this Agreement.
