BUY AMERICA REQUIREMENT (Applies only to Federally Funded Highway and Transit Projects) With respect to products purchased by Customer for use in federally funded highway projects, Contractor shall comply with all federal procurement laws and regulations with respect to such projects, including the Buy American provisions set forth in 23 U.S.C. Section 313, 23 C.F.R. Section 635.410, as amended, and the Steel and Iron Preference provisions of Texas Transportation Code Section 223.045, to the extent applicable. Contractor agrees to provide all certifications required by Customer regarding such programs. With respect to products purchased by Customer for use in federally funded transit projects, Contractor shall comply with all federal procurement laws and regulations with respect to such projects, including the Buy American provisions set forth in 49 U.S.C. Section 5323(j)(1), 49 C.F.R. Sections 661.6 or 661.12, to the extent applicable. Contractor agrees to provide all certifications required by Customer regarding such programs.
Xxxx XXX-to-Xxxx XXX Rollovers Assets distributed from your Xxxx XXX may be rolled over to the same Xxxx XXX or another Xxxx XXX of yours if the requirements of IRC Sec. 408(d)(3) are met. A proper Xxxx XXX-to-Xxxx XXX rollover is completed if all or part of the distribution is rolled over not later than 60 days after the distribution is received. In the case of a distribution for a first-time homebuyer where there was a delay or cancellation of the purchase, the 60- day rollover period may be extended to 120 days. Xxxx XXX assets may not be rolled over to other types of IRAs (e.g., Traditional IRA, SIMPLE IRA), or employer-sponsored retirement plans. You are permitted to roll over only one distribution from an IRA (Traditional, Xxxx, or SIMPLE) in a 12-month period, regardless of the number of IRAs you own. A distribution may be rolled over to the same IRA or to another IRA that is eligible to receive the rollover. For more information on rollover limitations, you may wish to obtain IRS Publication 590-B, Distributions from Individual Retirement Arrangements (IRAs), from the IRS or refer to the IRS website at xxx.xxx.xxx.
Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.
Access to and Use of Content Customer has the right to access and use applicable Content subject to the terms of applicable Order Forms, this Agreement and the Documentation.
Limitation of Vendor Indemnification and Similar Clauses This is a requirement of the TIPS Contract and is non-negotiable TIPS, a department of Region 8 Education Service Center, a political subdivision, and local government entity of the State of Texas, is prohibited from indemnifying third-parties (pursuant to the Article 3, Section 52 of the Texas Constitution) except as otherwise specifically provided for by law or as ordered by a court of competent jurisdiction. Article 3, Section 52 of the Texas Constitution states that "no debt shall be created by or on behalf of the State … " and the Texas Attorney General has opined that a contractually imposed obligation of indemnity creates a "debt" in the constitutional sense. Tex. Att'y Gen. Op. No. MW-475 (1982). Thus, contract clauses which require TIPS to indemnify Vendor, pay liquidated damages, pay attorney's fees, waive Vendor's liability, or waive any applicable statute of limitations must be deleted or qualified with ''to the extent permitted by the Constitution and Laws of the State of Texas." Does Vendor agree? Yes, I Agree Alternative Dispute Resolution Limitations This is a requirement of the TIPS Contract and is non-negotiable. TIPS, a department of Region 8 Education Service Center, a political subdivision, and local government entity of the State of Texas, does not agree to binding arbitration as a remedy to dispute and no such provision shall be permitted in this Agreement with TIPS. Vendor agrees that any claim arising out of or related to this Agreement, except those specifically and expressly waived or negotiated within this Agreement, may be subject to non-binding mediation at the request of either party to be conducted by a mutually agreed upon mediator as prerequisite to the filing of any lawsuit arising out of or related to this Agreement. Mediation shall be held in either Camp or Titus County, Texas. Agreements reached in mediation will be subject to the approval by the Region 8 ESC's Board of Directors, authorized signature of the Parties if approved by the Board of Directors, and, once approved by the Board of Directors and properly signed, shall thereafter be enforceable as provided by the laws of the State of Texas. Does Vendor agree? Yes, Vendor agrees Does Vendor agree? Yes, Vendor agrees No Waiver of TIPS Immunity This is a requirement of the TIPS Contract and is non-negotiable. Vendor agrees that nothing in this Agreement shall be construed as a waiver of sovereign or government immunity; nor constitute or be construed as a waiver of any of the privileges, rights, defenses, remedies, or immunities available to Region 8 Education Service Center or its TIPS Department. The failure to enforce, or any delay in the enforcement, of any privileges, rights, defenses, remedies, or immunities available to Region 8 Education Service Center or its TIPS Department under this Agreement or under applicable law shall not constitute a waiver of such privileges, rights, defenses, remedies, or immunities or be considered as a basis for estoppel. 5 Does Vendor agree? Yes, Vendor agrees Payment Terms and Funding Out Clause This is a requirement of the TIPS Contract and is non-negotiable. Vendor agrees that TIPS and TIPS Members shall not be liable for interest or late-payment fees on past-due balances at a rate higher than permitted by the laws or regulations of the jurisdiction of the TIPS Member. Funding-Out Clause: Vendor agrees to abide by the applicable laws and regulations, including but not limited to Texas Local Government Code § 271.903, or any other statutory or regulatory limitation of the jurisdiction of any TIPS Member, which requires that contracts approved by TIPS or a TIPS Member are subject to the budgeting and appropriation of currently available funds by the entity or its governing body. 2
Application of General Conditions These General Conditions set forth the terms and conditions generally applicable to the Development Grant Agreement to the extent and subject to any modifications set forth in such agreement.”
Scope of Application to Parties The Participating Generator and CAISO acknowledge that all Generators, except those specified in Section 2.2.1 of this Agreement, wishing to submit Bids to the CAISO through a Scheduling Coordinator must sign this Agreement in accordance with Section 4.6 of the CAISO Tariff.
APPLICABILITY TO SUBCONTRACTORS Respondent agrees that all contracts it awards pursuant to the contract awarded as a result of this Agreement will be bound by the foregoing terms and conditions.
Acceptance and Application of Partial Payments Lender may accept and either apply or hold in suspense Partial Payments in its sole discretion in accordance with this Section 2. Lender is not obligated to accept any Partial Payments or to apply any Partial Payments at the time such payments are accepted, and also is not obligated to pay interest on such unapplied funds. Lender may hold such unapplied funds until Borrower makes payment sufficient to cover a full Periodic Payment, at which time the amount of the full Periodic Payment will be applied to the Loan. If Borrower does not make such a payment within a reasonable period of time, Lender will either apply such funds in accordance with this Section 2 or return them to Borrower. If not applied earlier, Partial Payments will be credited against the total amount due under the Loan in calculating the amount due in connection with any foreclosure proceeding, payoff request, loan modification, or reinstatement. Lender may accept any payment insufficient to bring the Loan current without waiver of any rights under this Security Instrument or prejudice to its rights to refuse such payments in the future.
Limitations on subcontracting In performance of services awarded under OASIS SB, Limitations on Subcontracting, will be monitored and strictly enforced by the OASIS SB CO. References in this contract to the OASIS SB Prime Contractor or “concern” (per FAR 52.219- 14(c)(1)), with respect to limitations on subcontracting, are interpreted to include the prime contractor’s similarly situated subcontractors (under the NAICS code assigned to the contract) as defined in 13 CFR 125.6, unless otherwise specified by the OCO in their individual task order. The Contractor shall invoice to the customer the Total Labor Dollars Subcontracted under each task order. The amount of Labor Dollars Subcontracted must be based on invoiced or actual payments to subcontractors, NOT on proposed or estimated amounts. The Contractor’s Limitations on Subcontracting performance will be monitored in accordance with the following criteria for each type of set-aside: Total Small Business Set-Aside: In performance of all task orders combined as a Total Small Business Set-Aside, at least 50% of the cumulative average of all task order performance incurred for personnel shall be expended by the OASIS SB Prime Contractor. This requirement applies for each Pool the Contractor has an award under. (Note: For Total Small Business Set-Asides, each task order does not have to meet 50% unless otherwise specified by the OCO in their individual task order) In the event any Limitations on Subcontracting regulations change during the duration of OASIS SB, the OASIS SB CO reserves the right to unilaterally modify OASIS SB to reflect the change at no additional cost to the Government. The Contractor shall report Limitations on Subcontracting Data in the CPRM in accordance with Section G.3.2.1.4.
