Active Carbon Scope and Application Sample Clauses

Active Carbon Scope and Application. Active carbon is the nickname of the method that seeks to quantify the amount of readily oxidizable carbon in a soil, which is the carbon most energetically favorable for the microbial community to use for food and energy. It has been selected as an indicator of soil health and is considered a leading indicator, meaning it is one of the first parameters to change due to management. In studies done in CAL, this single parameter has the best correlation to overall soil health scores. This makes sense when considering that most soil functions are mediated by the soil microbial community. If they have enough food, they will be able to perform their functions and so the soil will be able to perform its functions. Many other measures of soil health, such as organic matter, aggregate stability, respiration, and biomass are correlated to active carbon. Summary Soil is weighed and shaken for two minutes with a solution with a known concentration of potassium permanganate. The soil is allowed to settle for eight minutes and the supernatant is diluted and measured colorimetrically to determine the amount of permanganate that was reduced during the oxidation of carbon. Materials  Balance  Falcon tubes  Shaker  Pipettes  Spectrophotometer  Stopwatch Reagents  Potassium permanganate KMnO4  DI water Procedure
Sample 1
AutoNDA by SimpleDocs

Related to Active Carbon Scope and Application

  • Scope and Application This Appendix will apply to all work undertaken within the Employer’s Workshop(s) by employees mainly engaged at the Workshop.

  • Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.

  • Solicitations for Subcontractors, Including Procurements of Materials and Equipment In all solicitations either by competitive bidding or negotiation made by the contractor for work to be performed under a subcontract, including procurements of materials or leases of equipment, each potential subcontractor or supplier shall be notified by the contractor of the contractor's obligations under this contract and the Regulations relative to nondiscrimination on the grounds of race, color, or national origin, sex, age, and disability/handicap.

  • COVID-19 Protocols Contractor will abide by all applicable COVID-19 protocols set forth in the District’s Reopening and COVID-19 Mitigation Plan and the safety guidelines for COVID-19 prevention established by the California Department of Public Health and the Ventura County Department of Public Health.

  • Solicitations for Subcontracts, Including Procurement of Materials and Equipment In all solicitation, either by competitive bidding or negotiation, made by the Contractor for work to be performed under a subcontract, including procurement of materials or leases of equipment, each potential Subcontractor or supplier shall be notified by the Contractor of the Contractor’s obligations under this Agreement and the Regulations relative to non-discrimination on the grounds of race, color, or national origin.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.

  • Solicitations for Subcontracts, Including Procurements of Materials and Equipment In all solicitations either by competitive bidding or negotiation made by the Engineer for work to be performed under a subcontract, including procurements of materials or leases of equipment, each potential subcontractor or supplier shall be notified by the Engineer of the Engineer's obligations under this contract and the Regulations relative to nondiscrimination on the grounds of race, color, or national origin.

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where InterGlobe has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to InterGlobe. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for InterGlobe (e.g. hairpinning):

  • In-Scope Projects Project Based Information Technology (IT) Consulting Services required by an Authorized User must be obtained via a Mini-Bid process under this Contract. The Authorized User shall issue a Mini-Bid with a SOW for the required Project Based IT Consulting Services. A Mini-Bid may include, but will not be limited to, projects requiring: analysis, data classification, design, development, testing, quality assurance, security and associated customized training for IT based applications. Additional examples of in-scope projects include, but are not limited to:  Technical architecture advisory services;  Business analysis for project development;  Proprietary software application development/customization, programming and integration;  Data information management (including data migration, data conversion, data manipulation, data integration);  Project management project support services - including, but not limited to; project management, project quality assurance and control, and Independent Verification & Validation (IV&V);  Disaster recovery/business continuity and testing;  Quality assurance;  Continuity of operations planning (COOP);  Data categorization; and  Open-source software implementation. Out-of-Scope Work There are service offerings expressly excluded from the scope of these contracts. In many instances, such services and/or offerings are (or will be) covered by another OGS Centralized Contract. Examples include:  Staff augmentation services;  Time and material services;  Web hosting;  Automated network monitoring or any other service provided principally through an automated process;  Hardware maintenance and support;  Software maintenance and support;  Ongoing maintenance and support;  Services priced on a per asset basis;  Services priced on a contingency basis;  Equipment maintenance;  Prepackaged training courses;  E-Learning;  Managed services;  Acquisition of equipment (hardware)  Acquisition of software, either Commercial off-the-shelf (COTS) software or pre-existing software;  Acquisition of non-consulting services, such as network provisioning, voice services (local, long- distance), or video bridging;  Cloud based or “As a Service” offerings, including but not limited to SaaS, IaaS, PaaS, and XaaS;  Any offering that is a combination of equipment, hardware, software, cloud or “as a service offerings”; and  Consulting or other installation work which is considered Public Works is excluded from purchase under the scope of this Contract. Historically, the New York State Bureau of Public Works has maintained that installation, maintenance and repair of equipment attached to any wall, ceiling or floor or affixed by hard wiring or plumbing is public work. In contrast, installation of a piece of equipment which is portable or a “plug-in” free-standing unit would not be considered public work. Thus, this Contract does not authorize installation where the equipment becomes a permanent part of the building structure, or is otherwise incorporated into the fabric of the building (i.e. installation on a wall, ceiling or floor in a fixed location, or affixed by hard- wiring or plumbing). See Appendix A, Clause 6, Wage and Hours Provisions. For questions about whether a proposed work constitutes public work, please contact the New York State Department of Labor’s Bureau of Public Work District Office in a specific area. A listing of district offices and contact information is available at xxxx://xxx.xxxxx.xx.xxx/workerprotection/publicwork/PWContactUs.shtm. Definitions Additional definitions applicable to this Contract can be found in Appendix B. Term Definition Authorized User Agreement The document resulting from the transactional Mini-Bid process, which sets forth the specifics regarding the services to be provided by the Contractor to the Authorized User, under the Project Based Information Technology Consulting Contract. Best Value The basis for awarding all service and technology contracts to the offerer that optimizes quality, cost and efficiency, among responsive and responsible offerers. Such basis shall be, wherever possible, quantifiable (State Finance Law §163 (1) (j)). Billing Contact The name, phone number, e-mail, and billing address a customer uses on a xxxx for contact information. Consultant Disclosure Legislation Chapter 10 of the Laws of 2006 amends State Finance Law § 8 and § 163 by requiring: that the Office of the State Comptroller (OSC) include in the Consulting Services Report it compiles annually on contracts issued by state agencies for consulting services during the previous fiscal year. xxxx://xxx.xxx.xxxxx.xx.xx/agencies/guide/MyWebHelp/Content/XI/18/C.htm Deliverables All services or products created during the performance or provision of Services hereunder or identified as a “Deliverable” in an applicable Mini-Bid. A Deliverable is a building block of an overall project. For the purposes of this Solicitation and the resulting Contract, a deliverable shall not be set forth as a status report, meeting attendance, a block of staff hours, or an invoice submission. Fixed Price Authorized User Agreement An agreement pursuant to the Centralized Contract that provides for a fix cost for a defined project. Government Contract A contract let by a Federal, State, or Local governmental body within the continental United States. Government Entity An entity at the federal, state, county, city or provincial level. Joint Venture A contractual agreement joining together two or more business enterprises for the purpose of performing on a State Contract. Knowledge Transfer The transfer of knowledge from the Contractor to the Authorized User. Knowledge Transfer can include full written system documentation including all system changes, training classes, manuals and other items. Depending on the scope of the transaction, there may or may not be a deliverable cost associated. All materials will be the property of the Authorized User unless specifically negotiated during the award process. May Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “Should”. Mini-Bid A type of Bid Document used by the Authorized User to obtain Services under the Project Based IT Consulting Services Contracts. Not To Exceed Rates (NTE) Refers to the New York State contract price set forth in Appendix D. Amounts proposed by the Contractor at the transactional level shall not exceed the hourly rates provided under this Contract (which will be defined values in US Dollars). Prime Contractor For the purposes of Technical qualifications, the business entity with whom a government entity directly has a contract. Project Based IT Consulting Services An OGS Centralized Contract which will provide a set of standardized terms and conditions, guidelines, processes, and templates for the development, distribution and award of specific deliverable-based and fixed-price Information Technology projects. Project Plan A formal, approved document used to guide both project execution and project control. The primary uses of the project plan are to document planning assumptions and decisions, facilitate communication among stakeholders, and document approved scope, cost, and schedule baselines. Retainage A portion of the Authorized User and Contractor fixed-price agreement amount that is held back by the Authorized User until the deliverable or project is satisfactorily finished. Should Denotes the permissive in a contract clause or specification. Refers to items or information that the State has deemed are worthy of obtaining, but not required or obligatory. Also see “May”. Term Definition Solicitation A non-competitive periodic recruitment solicitation (“Solicitation”) for vendors that provide Project Based Information Technology Consulting Services. Vendor An enterprise that sells goods or services. Vendor Submission The complete response to this Solicitation submitted by a Vendor to provide, as applicable , the Product and services described in the Solicitation

  • MSAA Indicator Technical Specification Document This Agreement shall be interpreted with reference to the MSAA Indicator Technical Specifications document.

Time is Money Join Law Insider Premium to draft better contracts faster.