Examples of Fuel Flow Rate in a sentence
Fuel Flow Rate for Pressure Regulated Systems Conduct these fuel-flow rate tests by placing the airplane in the same attitude as outlined in the procedure for gravity-feed fuel system tests.
The fuel flow for airplanes powered by a turbine engine(s) under part 23 should meet the requirements discussed under Fuel Flow Rate for Pressure Regulated Systems below.
Engine Post-Inspection Test Run Fuel System 1 Replace fuel filter(s) 2 Drain valves, carburettor bowl3 Electronic fuel boost pump and fittings4 Fuel lines, taps and connectors 5 Fire sleeves6 Fuel Flow Rate 8.6 Pre-Maintenance Inspections:• As all possible circumstances cannot be listed here, the following is provided as guidance only.
Minimum Fuel Flow Rate Default (DefaultPurposeCode "DM")Default minimum fuel flow rate (refer to the Part 75 Emissions Monitoring Policy Manual).
Fuel Flow Rate for Unregulated Fuel Injection Pump Systems Some fuel injection systems utilize an integral speed-sensing pump, approved as part of the engine type design, that delivers fuel at an unregulated pressure proportional to engine speed.
Engine Post-Inspection Test Run Fuel System 1 Replace fuel filter(s) 2 Drain valves, carburettor bowl3 Electronic fuel boost pump and fittings4 Fuel lines, taps and connectors 5 Fire sleeves6 Fuel Flow Rate 8.6 Pre-Maintenance Inspections: As all possible circumstances cannot be listed here, the following is provided as guidance only.
Fuel Flow Rate for Units P1, P2, P3, and P4 The Permittee shall calibrate, maintain, and operate fuel flow rate monitoring systems installed on Units P1, P2, P3 and P4 for determining the natural gas and/or distillate fuel oil input rate to each gas turbine unit for each operating hour.
Figure 3.11 - Part Load Engine Concepts Comparison - 2 Table 3.5 - Fuel Flow Rate comparison for different operating points at part load with respect to the Reference Engine Since it has been assumed that the combustion duration (MFB10-90) do not depend on the CR value and that therefore they have been kept unchanged for all engine concepts, the benefit of indicated efficiency could be underestimated for the engines featuring an increased compression ratio at part load operations.
For instance, changes in engine speed would produce oscillation in the intake and exhaust manifold pressures, thus affecting experiments repeatability.Engine Fuel and Fuel Flow Rate The fuel chosen for the Gasoline GM HCCI engine experiments was Iso-octane.
Oil or GasSubstitute Data Using Lookback Procedures 3Oil or GasMaximum Potential Fuel Flow Rate (simplified missing data procedure for peaking units, only)4Oil or GasEmergency Fuel (maximum unit fuel flow rate)5OilIgniter Oil from Tank Measurements6OilUncertified OFFM to Measure Igniter Oil9Oil or GasDefault Minimum Fuel Flow RateLeave this field blank only for Oil HFF records, where the fuel flow system measures mass flow rate of oil directly.Do not leave this field blank for gas fuel flow records.