SQC parameters Sample Clauses

SQC parameters. In this section, you can compare your measurement results with prescribed values from your quality xxxxxx.Xxx thereby define a reference value, warning limits, and intervention limits. Review of your weighings within predefined limits is equivalent to review of quality control results in a rule card. Based on mathematical evaluations, you can make statements regarding tendencies, and intervene promptly in processes if necessary. Target Value 0.8788 Limits SQC Limits in % Warning Limit High (T2+) 110 Control Limit High (T1+) 125 Control Limit Low (T1-) 75 Warning Limit Low (T2-) 90 For illustration, the comparison with a rule card: Dimension of the characteristic result Warning limit! Upper Warning limit T2+ Control limit! Upper Control limit T1+ Warning range Control area Reference value Lower Control limit T1- Control limit! Lower Warning limit T2- Warning limit!‌ Chronological sequence The limit value can be defined as follows: • As absolute values based on the target value • As relative values based on the target value • As calculated standard deviation factors These can be used for the following statistical evaluations: • Number of samples < warning limit low • Number of samples between warning limit low and control limit low • Number of samples between control limit low and target • Number of samples between target and control limit high • Number of samples between control limit high and warning limit high • Number of samples > warning limit high Note If no target value is entered, LabX takes the mean of the measured samples as reference.