FIRM’S OBLIGATIONS 3.1 Firm shall comply with the Rules and this Agreement at all times and shall timely pay all fees established in accordance with the Rules.
Conditions to Each Party’s Obligations The respective obligations of each Party to consummate the Merger are subject to the satisfaction of the following conditions:
RESIDENT’S OBLIGATIONS Resident agrees as follows:
Processor’s Obligations Except where expressly permitted by Article 28 (3)(a) GDPR, Processor shall process data subjects’ Data only within the scope of the Agreement and the instructions issued by Controller. Where Processor believes that an instruction would be in breach of applicable law, Processor shall notify Controller of such belief without undue delay. Processor shall be entitled to suspend performance on such instruction until Controller confirms or modifies such instruction. Processor shall, within Processor’s scope of responsibility, organize Processor’s internal organization so it satisfies the specific requirements of data protection. Processor shall implement technical and organizational measures to ensure the adequate protection of Controller’s Data, which measures shall fulfil the requirements of the GDPR and specifically its Article 32. Processor shall implement technical and organizational measures and safeguards that ensure ongoing confidentiality, integrity, availability and resilience of processing systems and services and shall implement a process for regularly testing, assessing and evaluating the effectiveness of technical and organizational measures for ensuring the security of the processing. Controller is familiar with these technical and organizational measures, and it shall be Controller’s responsibility that such measures ensure a level of security appropriate to the risk. The parties agree to refer to the existing certification of Processor by Kiwa International Cert GmbH in accordance with DIN ISO/IEC 27001:2015 which is considered sufficient evidence for these purposes by Controller and which is available on the website of Processor (xxx.xxxxxxx.xxx). Processor reserves the right to modify the measures and safeguards implemented, provided, however, that that the level of security shall not be less protective than initially agreed upon. Processor shall support Controller, insofar as is agreed upon by the parties, and where possible for Processor, in fulfilling data subjects’ requests and claims, as detailed in chapter III of the GDPR and in fulfilling the obligations enumerated in Articles 33 to 36 GDPR. Processor shall ensure that all employees involved in Contract Processing of Controller’s Data and other such persons as may be involved in Contract Processing within Processor’s scope of responsibility shall only do so within the scope of the instructions. Furthermore, Processor shall ensure that any person entitled to process Data on behalf of Controller has undertaken a commitment to confidentiality under terms similar to the confidentiality terms of the Agreement. All such confidentiality obligations shall survive the termination or expiration of such Contract Processing. Processor shall notify Controller without undue delay if Processor becomes aware of any Data breaches within Processor’s scope of responsibility. Processor shall implement the measures necessary for securing Data and for mitigating potential negative consequences for the data subject; the Processor shall coordinate such efforts with Controller without undue delay. Processor shall notify to Controller the point of contact for any issues related to data protection arising out of or in connection with the Agreement. The Exhibit provides for a list of the initially designated persons. Processor shall correct or erase Data if so instructed by Controller and where covered by the scope of the instructions permissible. Where an erasure, consistent with data protection requirements, or a corresponding restriction of processing is impossible, Processor shall, based on Controller’s instructions, and unless agreed upon differently in the Agreement, destroy, in compliance with data protection requirements, all carrier media and other material or return the same to Controller. In specific cases designated by Controller, such Data shall be stored or handed over. The associated cost for doing so and protective measures to put in place shall be agreed upon separately, unless already agreed upon in the Agreement. Processor shall, upon termination of Contract Processing and upon Controller’s instruction, return all Data, carrier media and other materials to Controller or delete the same. Where a data subject asserts any claims against Controller in accordance with Article 82 of the GDPR, Processor shall support Controller in defending against such claims, where possible at Controller’s cost as set out in Section 6 para. 3. § 4Controller’s Obligations Controller shall notify Processor without undue delay, and comprehensively, of any defect or irregularity with regard to provisions on data protection detected by Controller in the results of Processor’s work.
The Supplier's Obligations The Supplier will in writing, by the time and date specified by the Contracting Body in accordance with paragraph 3.1.3(b) provide the Contracting Body with either:
Supplier’s Obligations on Termination Unless otherwise specified by Buyer, upon Supplier’s receipt of a notice of termination of this Order, Supplier shall promptly: (a) stop work as directed in the notice; (b) place no further subcontracts/orders related to the terminated portion of this Order; (c) terminate, or if requested by Buyer assign, all subcontracts/orders to the extent they relate to work terminated; (d) deliver all completed work, work in process, designs, drawings, specifications, documentation and material required and/or produced in connection with such work; and (e) return or destroy all Confidential Information as set forth in Section 16(d).
Customer’s Obligations 8.1 The Customer shall:
Vendor’s Obligations Vendor shall incur no further obligations in connection with the terminated work and on the date set in the notice of termination Vendor will stop work to the extent specified. Vendor shall also terminate outstanding orders and subcontracts as they relate to the terminated work. Vendor shall settle the liabilities and claims arising out of the termination of subcontracts and orders connected with the terminated work. The MTC or designee may direct Vendor to assign Vendor’s right, title, and interest under terminated orders or subcontracts to the MTC. Vendor must still complete the work not terminated by the notice of termination and may incur obligations as are necessary to do so.
CAISO and Participating TO Obligations The CAISO and Participating TO shall cause the Participating TO’s Transmission System to be operated and controlled in a safe and reliable manner and in accordance with this LGIA. The Participating TO at the Interconnection Customer’s expense shall cause the Participating TO’s Interconnection Facilities to be operated, maintained and controlled in a safe and reliable manner and in accordance with this LGIA. The CAISO and Participating TO may provide operating instructions to the Interconnection Customer consistent with this LGIA and Participating TO and CAISO operating protocols and procedures as they may change from time to time. The Participating TO and CAISO will consider changes to their operating protocols and procedures proposed by the Interconnection Customer.
THE CUSTOMER’S OBLIGATIONS The Customer agrees that it will:-
