ROAD SHOULDER BERM INSTALLATION Sample Clauses

ROAD SHOULDER BERM INSTALLATION. On the following road(s), the Purchaser shall construct berms on the road shoulders as listed below. Road Stations Left or Right Comments P-2100 21+60 – 24+25 Right Rock Berm P-2100 22+95 – 24+25 Left Rock Berm P-2100 30+90 – 32+65 Left & Right Rock Berm SUBSECTION REVEGETATION 8-15 REVEGETATION Purchaser shall grass seed and hay mulch all exposed soils including, but not limited to, stream culverts, waste areas, sidecast pull back areas, stream crossing removals, bridge installations, and other areas directed by the Contract Administrator. Revegetation of exposed soils shall be accomplished by manual dispersal of grass seed unless otherwise detailed in this Road Plan. Other methods of revegetation must be approved in writing by the Contract Administrator.
AutoNDA by SimpleDocs
ROAD SHOULDER BERM INSTALLATION. On the following roads, Purchaser shall construct berms on the road shoulders as shown on the ROAD SURFACE SHOULDER BERM DETAIL. Road Stations Remarks D‐5000 19+50 to 20+20 Both sides 24+80 to 25+30 Both sides 34+55 to 35+65 On left 41+10 to 41+60 Both sides 57+00 to 57+50 On left 72+60 to 73+00 On left
ROAD SHOULDER BERM INSTALLATION. On the following road(s), Purchaser shall construct berms on the road shoulders as shown on the ROAD SURFACE SHOULDER BERM DETAIL. Road Stations Remarks WO-100 13+72 to 15+21, 35+43 to 26+28, 38+09 to 39+50, 42+31 to 43+71 - 8-15 REVEGETATION Purchaser shall spread grass seed on all exposed soils resulting from road work activities. Cover all exposed soils using manual dispersion. Other methods of covering must be approved in writing by the Contract Administrator. Required seed not spread by the termination of this contract will become the property of the state. Road Location Qty (lbs)* Type Comments B-100 0+00 to 38+33 13 Grass seed Pre-haul maintenance B-120 0+00 to 4+77 13 Grass seed Reconstruction B-120 4+77 to 6+28 4 Grass seed Construction B-120 4+77 to 6+28 7 Grass seed Abandonment B-120 6+28 to 8+04 5 Grass seed Construction B-120 6+28 to 8+04 8 Grass seed Abandonment WO-100 0+00 to 56+99 196 Grass seed Pre-haul maintenance WO-100 56+99 to 80+94 110 Grass seed Abandonment WO-101 0+00 to 2+67 9 Grass seed Pre-haul maintenance WO-102 0+00 to 3+37 12 Grass seed Pre-haul maintenance WO-103 0+00 to 6+68 10 Grass seed Pre-haul maintenance WO-103 0+00 to 10+35 48 Grass seed Abandonment WO-103A 0+00 to 1+27 6 Grass seed Abandonment WO-104 0+00 to 2+88 13 Grass seed Abandonment *Quantities are estimates only. Actual quantities may vary and are the responsibility of the Purchaser.
ROAD SHOULDER BERM INSTALLATION. Purchaser may construct berms on the road shoulders as approved in writing by the contract administrator.
ROAD SHOULDER BERM INSTALLATION. On the following road(s), the Purchaser shall construct berms on the road shoulders. Road Stations G-3010 58+50 – 60+50 L, 58+50 – 63+80 R, 62+70 – 63+80 L, 108+60 – 109+60 L&R SUBSECTION REVEGETATION Purchaser shall grass seed and hay mulch all exposed soils including, but not limited to, stream culverts, waste areas, sidecast pull back areas, stream crossing removals, bridge installations, and other areas directed by the Contract Administrator. Revegetation of exposed soils shall be accomplished by manual dispersal of grass seed unless otherwise detailed in this Road Plan. Other methods of revegetation must be approved in writing by the Contract Administrator.
ROAD SHOULDER BERM INSTALLATION. On the following road(s), the Purchaser shall construct berms on the road shoulders as listed below. Road Stations Remarks C-1200 274+20 – 276+20 Maintain existing Berms SUBSECTION SLOPE STABILIZATION
ROAD SHOULDER BERM INSTALLATION. On the following road(s), the Purchaser shall construct berms on the road shoulders. Road Stations Remarks P-1000 202+50 – 203+50 L&R, 225+25 – 226+25 L&R, 246+80 – 247+80 L&R, 263+50 – 264+50 L&R, 304+70 – 305+70 L&R, 366+10 – 367+10 L&R, 383+30 – 384+30 L&R, 386+90 – 387+90 L&R, 388+10 – 389+10 L&R, 420+15 – 421+15 L, 428+40 – 429+40 L&R, 436+50 – 437+50 L, 445+00 – 446+00 L, 472+75 – 473+75 L P-1900 4+80 – 5+80 L&R SUBSECTION REVEGETATION Purchaser shall grass seed and hay mulch all exposed soils including, but not limited to, stream culverts, waste areas, sidecast pull back areas, stream crossing removals, bridge installations, and other areas directed by the Contract Administrator. Revegetation of exposed soils shall be accomplished by manual dispersal of grass seed unless otherwise detailed in this Road Plan. Other methods of revegetation must be approved in writing by the Contract Administrator.
AutoNDA by SimpleDocs

Related to ROAD SHOULDER BERM INSTALLATION

  • Delivery & Installation a) Subject to the conditions of the contract, the delivery of the goods and completion of the related services shall be in accordance with the delivery and completion schedule specified in the bidding document. The details of supply/ shipping and other documents to be furnished by the successful/ selected bidder are specified in the bidding document and/ or contract.

  • Equipment Installation In order to meet its obligations under this Agreement, a Party that owns, rents, or leases equipment (the equipment owner) may require installation of such equipment on property owned by another Party (the property owner), provided that the property is being used for an electric utility purpose and that the property owner shall not be required to do so if it would thereby be prevented from performing its own obligations or exercising its rights under this Agreement.

  • Software Installation The AGENCY shall request approval in writing from the COUNTY prior to installation of any software on COUNTY computer equipment. All software installations must be supervised by COUNTY technical support staff and proof of licensing is required. Upon completion, the AGENCY is responsible for reconfiguring the computers back to the original state.

  • Installation Waiver Company will waive the one-time installation charges associated with the implementation of Services within the 48 contiguous States of the U.S. provided under this Agreement except for the following services: (i) eDSL, (ii) VPN, (iii) Internet Dedicated OC3, OC12, OC48, Gig-E, (iv) PTT / third party services (including International Access and Company International), (v) Data Center, (vi) Paging, (vii) Managed Services, (viii) CPE, (ix) Enhanced Call Routing, (x) Local Disaster Recovery, (xi) Audio, Video and Net Conferencing, (xii) Voice over IP Services, (xiii) Security Services, (xiv) Non-Listing/Non-Published Service, (xv) Telecommunications Service Priority, and (xvi) Services provided by Company incumbent local exchange carriers (“ILECs”) or by Cellco Partnership and its affiliates d/b/a Company Wireless. Usage charges, monthly recurring charges, expedite charges, change charges, surcharges, charges for an unlisted or non-published number, any charges imposed by third parties (including access, egress, jack, or wiring charges), taxes or tax-like surcharges, or other Governmental Charges will not be waived.

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.

  • Electrical Installations 3.1 Wiring and accessories for lighting of Common Areas.

  • Licenses for Permanent Installation The contractor must comply with all State mandatory licensing requirements prior to installation. Questions on licensing requirements should be directed to the State Licensing Board. Contractor must furnish and install all furniture and materials in compliance with all applicable codes, whether local, state, or federal; and that all permits or licenses required for installation will be obtained without cost to the State.

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Delivery/Installation Instructions Due to the varying locations and circumstances involved in deliveries and installations, all deliveries and installations will be quoted on a project by project basis. All installation, labor, and or delivery charges must be shown as a separate line item on quotes and invoices. One of the following delivery methods must be specified on every Agency Purchase Order:

  • No Renovation or Installation The alteration or renovation of the Residence facilities, furniture, fixtures, or equipment supplied in the Room is not permitted. The lock(s) provided by the Institution are the only locks to be used to secure the door to the Room. No other locks may be installed by the Resident and the Resident may not change the keying of the lock(s) which are provided. Unauthorized changes to temperature settings or duct or diffuser settings in the Room, and any attempt to make changes to the heating system in the Room are prohibited. The Resident may not install any electrical equipment which will overload the capacity of a circuit. Altering or otherwise tampering with electrical systems is prohibited. The Resident may not install furnishings or equipment of any kind (including and not limited to; shelving, light fixtures, audio or visual equipment, satellite dishes and radio or television antenna(e)), without the prior written consent of the Manager. If any such furnishing or equipment is installed without the Manager’s consent, the Resident will immediately remove it after notice from the Manager, failing which the Manager may remove the furnishing or equipment at the expense of the Resident without further notice and without liability to the Resident for any damage to the furnishing or equipment so removed. The Resident is responsible to pay the costs of repairing all damage to the Room or Residence caused by the installation and removal of any furnishing or equipment installed by the Resident, whether installed with or without the Manager’s consent. The Resident also is liable for any damage to property of others and for any injury to or death of any person caused by the installation, existence or removal of any furnishing or equipment installed by the Resident, whether installed with or without the Manager’s consent.

Time is Money Join Law Insider Premium to draft better contracts faster.