Procedure for Width Measurement Sample Clauses

Procedure for Width Measurement. 2.1. The seat shall be adjusted such that its H-point coincides with the R-point; if the seat back is adjustable, it is set at the design seat back angle; both these adjustments shall be in accordance with the requirements of paragraph 2.1. of Annex 11.
AutoNDA by SimpleDocs

Related to Procedure for Width Measurement

  • Usage Measurement Usage measurement for calls shall begin when answer supervision or equivalent Signaling System 7 (SS7) message is received from the terminating office and shall end at the time of call disconnect by the calling or called subscriber, whichever occurs first.

  • Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.

  • Method of Measurement The emission of voltage changes, voltage fluctuations and flicker on AC power lines generated by the vehicle representative of its type shall be measured using the method described in Annex 12. The method of measurement shall be defined by the vehicle manufacturer in accordance with the Technical Service.

  • Sector Sub-Sector Industry Classification Level of Government Type of Obligation Description of Measure Source of Measure All sectors : : - : Central : National Treatment Senior Management and Board of Directors : National Treatment and the Senior Management and Board of Directors obligations shall not apply to any measure relating to small and medium sized domestic market enterprise2. Foreign equity is restricted to a maximum of 40% for domestic market enterprises with paid-in equity capital of less than the equivalent of USD 200,000 Note: Members of the Board of Directors or governing body of corporation or associations shall be allowed in proportion to their allowable participation or share in the capital of such enterprises. : -1987 Constitution of the Republic of the Philippines. - Foreign Investments Act of 1991 (R.A. No. 7042, as amended by R.A. No. 8179). -Presidential and Administrative Issuances. ∞ 2 The concept of a small and medium sized domestic market enterprise is an enterprise with paid in equity capital of less than the equivalent of USD 200,000.00.

  • Testing Procedure Limitations The Asset Representations Reviewer will only be required to perform the Tests, and will not be obligated to perform additional procedures on any Review Receivable or to provide any information other than a Review Report. However, the Asset Representations Reviewer may provide additional information in a Review Report about any Review Receivable that it determines in good faith to be material to the Asset Representations Review.

  • Temperature Measurement Temperature will be measured by the nearest automatic Melbourne Bureau of Meteorology Monitoring Station for example (but not limited to): Melbourne, Moorabbin, Dunns Hill, Melbourne Airport, Frankston, and Point Xxxxxx. At the commencement of each project, the onsite management and employee representatives shall agree which is to be the applicable automatic weather monitoring station.

  • Procedure for Notification To obtain indemnification under this Agreement in respect of an Indemnifiable Claim or Indemnifiable Loss, Indemnitee shall submit to the Company a written request therefor, including a brief description (based upon information then available to Indemnitee) of such Indemnifiable Claim or Indemnifiable Loss. If, at the time of the receipt of such request, the Company has directors’ and officers’ liability insurance in effect under which coverage for such Indemnifiable Claim or Indemnifiable Loss is potentially available, the Company shall give prompt written notice of such Indemnifiable Claim or Indemnifiable Loss to the applicable insurers in accordance with the procedures set forth in the applicable policies. The Company shall provide to Indemnitee a copy of such notice delivered to the applicable insurers, and copies of all subsequent correspondence between the Company and such insurers regarding the Indemnifiable Claim or Indemnifiable Loss, in each case substantially concurrently with the delivery or receipt thereof by the Company. The failure by Indemnitee to timely notify the Company of any Indemnifiable Claim or Indemnifiable Loss shall not relieve the Company from any liability hereunder unless, and only to the extent that, the Company did not otherwise learn of such Indemnifiable Claim or Indemnifiable Loss and such failure results in forfeiture by the Company of substantial defenses, rights or insurance coverage.

  • Procedure for taking possession - The Promoter, upon obtaining the occupancy certificate* from the competent authority shall offer in writing the possession of the [Apartment/Plot], to the Allottee in terms of this Agreement to be taken within two months from the date of issue of occupancy certificate. [Provided that, in the absence of local law, the conveyance deed in favour of the allottee shall be carried out by the promoter within 3 months from the date of issue of occupancy certificate]. The Promoter agrees and undertakes to indemnify the Allottee in case of failure of fulfilment of any of the provisions, formalities, documentation on part of the Promoter. The Allottee, after taking possession, agree(s) to pay the maintenance charges as determined by the Promoter/association of allottees, as the case may be after the issuance of the completion certificate for the project. The promoter shall hand over the occupancy certificate of the apartment/plot, as the case may be, to the allottee at the time of conveyance of the same.

  • Performance Measurement Satisfactory performance of this Contract will be measured by:

  • Benchmarks for Measuring Accessibility For the purposes of this Agreement, the accessibility of online content and functionality will be measured according to the W3C’s Web Content Accessibility Guidelines (WCAG) 2.0 Level AA and the Web Accessibility Initiative Accessible Rich Internet Applications Suite (WAI-ARIA) 1.0 for web content, which are incorporated by reference. Adherence to these accessible technology standards is one way to ensure compliance with the College’s underlying legal obligations to ensure that people with disabilities are able to acquire the same information, engage in the same interactions, and enjoy the same benefits and services within the same timeframe as their nondisabled peers, with substantially equivalent ease of use; that they are not excluded from participation in, denied the benefits of, or otherwise subjected to discrimination in any College programs, services, and activities delivered online, as required by Section 504 and the ADA and their implementing regulations; and that they receive effective communication of the College’s programs, services, and activities delivered online.

Time is Money Join Law Insider Premium to draft better contracts faster.