Power Up Sample Clauses

Power Up. Once the machine is assembled and set in place, connect the power cord to a wall outlet. Note: The outlet must have an earth ground and be wired for the correct polarity. The monitor and target lights are controlled by the switch on the back of the machine.
View SourceView Similar (9)
Power Up. 1. Attach the removable power cord to the external power supply. 2. Plug the removable power cord into a wall outlet or power conditioner, if applicable. 3. Plug the small connector attached to the cable that comes out of the power supply into the iScan VP30. The iScan VP30 should power on and display ‘DVDO iScan VP30 Powered by ABT’ on the FPD.
View SourceView Similar (2)
Power Up. Powered instrument subsystems are controlled via a remote power distribution unit. This unit allows the user to address individual power supplies within the instrument over Ethernet. So, once the AC power is supplied to this PDU and the Ethernet connected, the remaining power‐up procedure will all be conducted remotely. This will be done via a script run from the control computer console.
View Source
Power Up. The display will power up showing all 0’s. The power light on the bottom right corner will flash slowly when no data is received, and flicker when data is received.
View Source

Related to Power Up

  • Power Tools All time spent by Employees travelling to and from distant work will be paid as if worked during the time the travel is taken.

  • Power System Stabilizers The Developer shall procure, install, maintain and operate Power System Stabilizers in accordance with the requirements identified in the Interconnection Studies conducted for Developer’s Large Generating Facility. NYISO and Connecting Transmission Owner reserve the right to reasonably establish minimum acceptable settings for any installed Power System Stabilizers, subject to the design and operating limitations of the Large Generating Facility. If the Large Generating Facility’s Power System Stabilizers are removed from service or not capable of automatic operation, the Developer shall immediately notify the Connecting Transmission Owner and NYISO. The requirements of this paragraph shall not apply to wind generators.

  • Power and Capacity Each Shareholder has the power, authority and capacity to enter into this Agreement and to consummate the transactions contemplated hereby. This Agreement constitutes each Shareholder’s valid, legal and binding obligation and is enforceable against such Shareholder in accordance with its terms, subject, however, as to enforcement, to bankruptcy, insolvency, fraudulent transfer, moratorium and similar laws of general applicability relating to or affecting creditors’ rights;

  • Power Factor The Power Producer shall maintain the Power Factor as per the prevailing GERC regulations and as may be stipulated / specified by GETCO from time to time. The Power Producer shall provide suitable protection devices, so that the Electric Generators could be isolated automatically when grid supply fails. Connectivity criteria like short circuit level (for switchgear), neutral Grounding, fault clearance time, current unbalance (including negative and zero sequence currents), limit of harmonics etc. shall be as per Grid Code.

  • Power Supply The source of power for the VAS shall either be the vehicle battery or a rechargeable battery. Where provided, an additional rechargeable or non-rechargeable battery may be used. These batteries shall by no means supply energy to other parts of the vehicle electrical system.