Codes and Standards Under the various sections of the specifications, where reference is made to specific codes or standards governing the installation of specified items, installation shall in all cases be in strict accordance with the referenced codes and standards. Where no reference is made to specific codes or standards, installation shall conform to the generally recognized applicable standards for first-class installation of the specific item to be installed. Contractors are expected to be proficient and skilled in their respective trades and knowledgeable of the National Fire Protection Association (NFPA), the current edition of the Virginia Uniform Statewide Building Code (USBC) and its referenced technical codes and standards, Occupational Safety and Health Act (OSHA) and other codes and standards applicable to installations and associated work by its trade and/or that are applicable to the Work.
Policies, Guidelines, Directives and Standards Either the LHIN or the MOHLTC will give the HSP Notice of any amendments to the manuals, guidelines or policies identified in Schedule C. An amendment will be effective in accordance with the terms of the amendment. By signing a copy of this Agreement the HSP acknowledges that it has a copy of the documents identified in Schedule C.
COMPLIANCE WITH APPLICABLE LAWS AND STANDARDS 9.1.1 Each party must comply with all Applicable Laws in performing their obligations under this Agreement.
WORKLOAD STANDARDS One (1) Direct Service Hour (DSH) will be equal to sixty (60) minutes of direct services.
Compliance with Laws, Rules and Regulations Tenant, at its sole cost and expense, shall comply with all laws, ordinances, orders, rules and regulations of state, federal, municipal, or other agencies or bodies having jurisdiction over use, condition, and occupancy of the Leased Premises. Tenant must use and maintain the Leased Premises in a clean, careful, safe, and proper manner and in compliance with all Applicable Laws, including Applicable Laws pertaining to health, safety, disabled persons, and the environment; provided, however, that Tenant shall not be required to make any structural changes or repairs to the Leased Premises unless the need for such structural changes or repairs is caused by Tenant, its agents, employees, invitees, or others for whom Tenant is responsible pursuant to the terms and provisions of this Lease. Notwithstanding anything to the contrary contained elsewhere in this section, it is expressly agreed and understood that Tenant’s obligation to comply with all Applicable Laws does not apply to any violations of Applicable Laws that (a) were in effect and (b) were being violated or with which the Leased Premises was not in compliance immediately prior to the time Tenant accepted the Leased Premises, including without limitation any existing environmental contamination. Tenant will comply with the rules and regulations of the Leased Premises adopted by Landlord in its reasonable discretion. All such rules and regulations and changes and amendments thereto will be sent by Landlord to Tenant in writing and shall thereafter be carried out and observed by Tenant.
CODES AND REGULATIONS The Contractor shall strictly comply with all Federal, State and local codes and regulations.
Laws, Rules and Regulations You agree to comply with all existing and future operating procedures used by the Bank for processing of transactions. You further agree to comply with, and be bound by, all applicable state or federal laws, rules, regulations, orders, guidelines, operating circulars and pronouncements, affecting checks and drafts, including, but not limited to, all rules and procedural guidelines established by the Board of Governors of the Federal Reserve and the Electronic Check Clearing House Organization ("ECCHO") and any other clearinghouse or other organization in which Bank is a member or to which rules Bank has agreed to be bound. These procedures, rules, and regulations (collectively the "Rules") and laws are incorporated herein by reference. In the event of conflict between the terms of this Agreement and the Rules, the Rules will control.
Specifications and Standards a) All articles supplied shall strictly conform to the specifications, trademark laid down in the bidding document and wherever articles have been required according to ISI/ ISO/ other applicable specifications/ certifications/ standards, those articles should conform strictly to those specifications/ certifications/ standards. The supply shall be of best quality and description. The decision of the competent authority/ purchase committee whether the articles supplied conforms to the specifications shall be final and binding on the supplier/ selected bidder.
OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.
Compliance with Data Privacy and Security Laws and Standards Contractor shall comply with all applicable State and federal data privacy and data security laws, rules, and regulations.
