Equipment Requirements No Equipment is provided to Customer as part of this Service.
Other Equipment Seller shall install, own and maintain the infrastructure associated with the Revenue Metering Package, including but not limited to all enclosures (meter cabinets, meter pedestals, meter sockets, pull boxes, and junction boxes, along with their grounding/bonding connections), CT/PT mounting structures, conduits and ductlines, enclosure support structures, ground buses, pads, test switches, terminal blocks, isolation relays, telephone surge suppressors, and analog phone lines (one per meter), subject to Company's review and approval.
Equipment Return You may use the Leased Equipment provided under this plan only while you remain an active customer in good standing and in compliance with this Agreement (including, without limitation, the RCA). You must return all Leased Equipment in good operating condition, normal wear and tear excepted, within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment. If you acquired your Leased Equipment from a retailer, then you must return all Leased Equipment to: (A) your original retailer, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming; or (B) DISH, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs after such 30-day period. You are responsible for and shall bear all costs, expenses and risk of returning your Leased Equipment, including, without limitation, risk of loss during shipment. You are not responsible under the terms and conditions of this Agreement for the return of equipment other than your Leased Equipment. Following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment (unless you acquired your Leased Equipment from a retailer and the cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming and you returned Leased Equipment to such retailer within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment), DISH will send you one or more return labels or empty boxes (depending on your Leased Equipment) to be used by you in returning your Leased Equipment and DISH will charge you up to $20.00 for each such return label or empty box (“Box Return Fee”). The Box Return Fee is subject to change at any time. Unless you are a resident of a Remote Area of Alaska, you also have the option of contacting DISH by calling 000-000-XXXX (000-000-0000) to request that DISH or our designee(s) perform an in-home service call to remove your Leased Equipment at DISH’s then-current in-home service call rate, which rate is subject to change at any time. Leased Equipment will not be deemed returned until received by DISH. DISH Protect ===> Signature: DISH Protect is an optional service program currently priced as set forth in the table below. DISH Protect is offered in two (2) plans: Dish Protect and Plus. The services offered in each plan can be viewed at xxxxxx.xxx/xxxxxxxxxxx. If you enroll in a DISH Protect plan, you will receive an initial six (6) month trial offer of DISH Protect if you are eligible and if such plans are otherwise available to you at the time you sign this Agreement. During the trial offer period, you will be charged the monthly Trial Offer Price set forth below. By signing above, you are accepting the terms of this trial offer and understand that you may cancel or change your DISH Protect plan at any time by calling 000- 000-XXXX (3474) or by emailing xxxxxxxxxxxxxxxxxxxxxxxx@xxxx.xxx. You also agree that if you do not cancel your DISH Protect plan during the initial six (6) month trial offer period, DISH will automatically begin billing you the then-current monthly Regular Price of your DISH Protect plan upon the expiration of the six (6) month trial offer period until you cancel your DISH Protect plan. Not all DISH Protect plans are available to all customers. DISH Protect is not available to residents of Remote Areas of Alaska and/or residents of some Shared Dish MDU Properties. If you reside in a Shared Dish MDU Property and you are not sure if you qualify for DISH Protect, then please call 000-000-0000 to determine if you qualify. Plan Regular Price/month Trial Offer Price/month DISH Protect $10.99 $0.00 DISH Protect Plus $10.99 $0.00
Furniture and Equipment and Certain Other Equipment The Receiver hereby grants to the Assuming Bank an option to purchase all Furniture and Equipment or any telecommunications, data processing equipment (including hardware and software) and check processing and similar operating equipment owned by the Failed Bank at Fair Market Value and located at any leased Bank Premises that the Assuming Bank elects to vacate or which it could have, but did not occupy, pursuant to this Section 4.6; provided, that, the Assuming Bank shall give the Receiver notice of its election to purchase such property at the time it gives notice of its intention to vacate such Bank Premises or within ten (10) days after Bank Closing for Bank Premises it could have, but did not, occupy.
Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Equipment and Software Requirements In order to view and retain electronic communications that we make available to you, you must have: • A PC or other device with an Internet browser that has “cookies” enabled and supports 128 bit encryption • An Internet connection • An email address • A PDF viewer (such as Adobe Reader) • A printer or computer with sufficient electronic storage space All communications shall be delivered to the last address we have on file for you. These notices will be sent through electronic delivery (email) and will be considered delivered the same day as sent. If you have opted out of electronic delivery, communications sent to you through the United States Postal Service are considered delivered 5 business days after the postmark date. It is your responsibility to notify the Custodian of any email address change or residential address change. We will not be held liable for any losses or damages if you have not provided Custodian with the most current address information. The electronically signed copy of this document should be considered equivalent to a printed hard copy form. It is considered a true and complete record of the document, admissible in arbitration and/or administrative hearings or proceedings. Your electronic signature on the Application and other electronic forms such as the Investment Direction are considered valid and the same as if the paper form or Application were signed.
Condition of the Contractor’s Property or Equipment The Contractor shall make the Property and/or equipment available to the Judicial Council, pursuant to the terms and conditions set forth in this Agreement. The Contractor shall immediately remedy any problem with the Property’s physical plant or equipment that impairs or diminishes the quality of the Program. The Contractor shall ensure the appropriate hot water, heating, and ventilation is provided at the Property during the Program, inclusive in the prices set forth herein.
Construction Equipment Construction Equipment means all tools, machinery and equipment, either operated or not operated, that is required for preparing, fabricating, conveying, erecting, or otherwise performing the Work but is not incorporated into the Work.
EQUIPMENT HIRE 3.1 Tardis shall hire the Equipment to the Customer for use at the Site subject to the terms and conditions of this agreement.
Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.
