Minimum Purchase and Sales Requirements
Minimum Purchase and Sales Requirements Sample Clauses
Related to Minimum Purchase and Sales Requirements
Minimum Purchase Requirements Distributor shall make the minimum annual purchase of Products established in Exhibit B, unless the Agreement has become coexclusive. In the period within the fixed term and extension, if applicable, of the Agreement under Section 10(a) subsequent to [ * ], the parties shall meet in San Francisco at least [ * ] prior to the beginning of each of respective year to discuss market conditions and appropriate minimum purchases for such year. In the event that the parties fail to agree on an appropriate minimum any year subsequent to [ * ], the minimum annual purchase requirement for such year shall be calculated increasing or decreasing (as the case may be) the minimum purchase requirement for the preceding year in proportion to the increase or decrease in the [ * ] (based on data from mutually acceptable data provider) of the applicable product in the Territory. In the event Supplier is unable to deliver Products ordered by Distributor in an amount consistent with the most recent forecast, then the minimum annual purchase requirement shall be reduced by the quantity of Products that Supplier is unable to deliver when requested. In the event Distributor fails in any year (a “Shortfall Year”) to make the annual minimum purchase of Agreement Products required by Exhibit B, Supplier shall have the right to give Distributor written notice of default, and if such failure to make the minimum purchase is not cured (through the purchase of an amount of Agreement Product equal to the entire shortfall in the Shortfall Year, which amount shall not be counted towards any minimum purchase requirements for the year of purchase) within [ * ] of receipt of the notice, then Supplier shall have the right, in Supplier’s sole discretion and as Supplier’s sole remedy for Distributor’s failure to meet the minimum purchase requirements hereunder, either to convert the appointment of Distributor from exclusive to non-exclusive or to terminate this Agreement. In the event of either conversion to non-exclusive or termination of this Agreement pursuant to this Section 3(e), the Supplier shall pay Distributor a conversion fee equal to [ * ], and Distributor shall transfer all Regulatory Approvals relating to BMS or DES in the Territory to Supplier.
Minimum Purchase Broker-Dealer shall not sell fewer than $5,000 in Notes to any purchaser without the prior written consent of Issuer.
Minimum Vendor License Requirements Vendor shall maintain, in current status, all federal, state, and local licenses, bonds and permits required for the operation of the business conducted by Vendor. Vendor shall remain fully informed of and in compliance with all ordinances and regulations pertaining to the lawful provision of goods or services under the TIPS Agreement. TIPS and TIPS Members reserve the right to stop work and/or cancel a TIPS Sale or terminate this or any TIPS Sale Supplemental Agreement involving Vendor if Vendor’s license(s) required to perform under this Agreement or under the specific TIPS Sale have expired, lapsed, are suspended or terminated subject to a 30‐day cure period unless prohibited by applicable statue or regulation.
Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.
Minimum Requirements Consultant shall, at its expense, procure and maintain for the duration of the Agreement insurance against claims for injuries to persons or damages to property which may arise from or in connection with the performance of the Agreement by the Consultant, its agents, representatives, employees or subconsultants. Consultant shall also require all of its subconsultants to procure and maintain the same insurance for the duration of the Agreement. Such insurance shall meet at least the following minimum levels of coverage:
MINIMUM ORDER QUANTITY The State makes no commitment to purchase any minimum or maximum quantity, or dollar volume of products from the selected suppliers. Utilization of this agreement will be on an as needed basis by State Agencies and/or Cooperative Participants, Cities, Counties, Schools K-12, Colleges and Universities. The State will award to multiple suppliers; however, the State reserves the right to purchase like and similar products from other suppliers as necessary to meet operational requirements. Note: Issuance of an award does not guarantee an order.
Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.
Minimum Orders Client may order Manufacturing Services for batches of Products only in multiples of the Minimum Order Quantities as set out in Schedule B to a Product Agreement.
Required Vendor Sales Reporting By responding to this Solicitation, you agree to report to TIPS all sales made under any awarded Agreement with TIPS. Vendor is required to report all sales under the TIPS contract to TIPS. If the TIPS Member entity requesting a price from the awarded Vendor requests the TIPS contract, Vendor must include the TIPS Contract number on any communications with the TIPS Member entity. If awarded, you will be provided access to the Vendor Portal. To report sales, login to the TIPS Vendor Portal and click on the PO’s and Payments tab. Pages 3-7 of the Vendor Portal User Guide will walk you through the process of reporting sales to TIPS. Please refer to the TIPS Accounting FAQ’s for more information about reporting sales and if you have further questions, contact the Accounting Team at xxxxxxxxxx@xxxx-xxx.xxx. The Vendor or vendor assigned dealers are responsible for keeping record of all sales that go through the TIPS Agreement and submitting same to TIPS.
Export Requirements The Program, Documentation and all related technical information or materials are subject to export controls and U.S. Government export regulations. You will comply strictly with all legal requirements established under these controls and will not, in connection with its limited evaluation rights hereunder, export, re-export, divert, transfer or disclose, directly or indirectly the Program, Documentation and any related technical information or materials without the prior approval of the U.S.
