LAB CONDITIONS Sample Clauses

LAB CONDITIONS. Student will NOT work on any energized equipment without supervision or instructor approval. Energized equipment includes pneumatic, electric, hydraulic or other powered device. Immediately report any broken or damaged equipment to instructor.
AutoNDA by SimpleDocs

Related to LAB CONDITIONS

  • WORK CONDITIONS The Contractor agrees to accept sole responsibility to comply with all federal, provincial and municipal legislation which may have application to the Work and agrees to comply with all provincial and federal legislation affecting conditions of work and wage rates including the Employment Standards Act R.S.P.E.I. 1988, Cap. E-6.2, the Workers Compensation Act R.S.P.E.I. 1988, Cap. W-7.1, or any other laws that impose obligations in the nature of employers’ obligations. The Contractor agrees to follow the Public Service Commission Human Resource Policies 9.05 Violence in the Workplace Policy; 9.08 Drug, Alcohol, and Medication Policy, and 11.01 Policy for the Prevention and Resolution of Harassment in the Workplace while working on Government sites, in Government vehicles or alongside Government staff. xxxxx://xxx.xxxx.xx/sites/xxx.xxxx.xx/files/HRPolicy/HRManual_9.05.pdf xxxxx://xxx.xxxx.xx/sites/xxx.xxxx.xx/files/9.08%20DrugAlcoholAndMedicationPolicy.pdf xxxxx://xxx.xxxx.xx/files/PDF%20Files/hrp-manual/hrppm_11.01.pdf The Contractor agrees to accept the full cost of doing those things required under this paragraph and will not charge or seek reimbursement from the Owner in any way, such costs having been taken into consideration and included in the rates of payment stipulated in this Agreement.

  • Specific Conditions If applicable, specific conditions required after a risk assessment will be included in Exhibit G. Grantee shall adhere to the specific conditions listed therein.

  • BASIC CONDITIONS The State shall have no obligation to disburse money for the Project under this Grant Agreement until the Grantee has satisfied the following conditions:

  • Safe Conditions Whenever an employee reports a condition which the employee feels represents a violation of safety or health rules and regulations or which is an unreasonable hazard to persons or property, such conditions shall be promptly investigated. The appropriate administrator shall reply to the concern, in writing, if the employee's concern is communicated in writing.

  • PROJECT CONDITIONS A. The Grantee agrees to the following Project Conditions:

  • Contract Conditions This section contains conditions which shall be complied with during the performance of this contract. The conditions come in two parts, general conditions and special contract requirements.

  • Unsafe Conditions In accordance with 29 CFR § 1977, occasions might arise when an employee is confronted with a choice between not performing assigned tasks or subjecting himself/herself to serious injury or death arising from a hazardous condition at the workplace. If the employee, with no reasonable alternative, refuses in good faith to expose himself/herself to the dangerous condition, he/she would be protected against subsequent discrimination. The condition causing the employee's apprehension of death or injury must be of such a nature that a reasonable person, under the circumstances then confronting the employee, would conclude that there is a real danger of death or serious injury and that there is insufficient time, due to the urgency of the situation, to eliminate the danger by resorting to regular statutory enforcement channels. In addition, in such circumstances, the employee, where possible, must also have sought from his Employer, and been unable to obtain, a correction of the dangerous condition.

  • Space Conditions All pipes passing through floors, walls, and ceilings shall be installed with sufficient space between them to permit installation of pipe insulation and floor, wall, and ceiling plates without cutting of insulation or plates. Roughed-in dimensions shall be prepared by the Contractor to accomplish this requirement. The Contractor shall locate all equipment that must be serviced, operated, or maintained in fully accessible positions. This provision includes but is not limited to valves, traps, cleanouts, motors, controllers, switchgear, drain points, filter, access doors, and fire dampers. If spaces, dimensions, or other design conditions do not permit compliance with the present article, the Contractor shall file a request in writing with the Design Professional for additional instructions, furnishing a copy to the Owner.

  • Training Conditions 3.1 The Trainee shall attend an approved training course or training program prescribed in the Training Agreement or as notified to the trainee by the relevant State or Territory Training Authority in accredited and relevant Traineeship Schemes.

  • SAFETY CONDITIONS 1.0 The responsibility for providing for safe working conditions that are in conformance with applicable law and which are within fiscal constraints shall be the District’s. Employees shall be responsible for complying with safety procedures and practices and for reporting any unsafe condition, facility, or equipment of which he/she is aware. The District shall be responsible for informing employees of necessary safety procedures and practices. There shall be no reprisal against an employee for reporting any real or potentially unsafe condition, facility, or equipment.

Time is Money Join Law Insider Premium to draft better contracts faster.