High Voltage Sample Clauses

High Voltage in the context of tariff classification means a supply voltage exceeding the Medium Voltage.
Sample 1Sample 2Sample 3
AutoNDA by SimpleDocs
High Voltage. An employee assigned to and working at the Airport Division will 22 receive a premium of ten percent (10%) over their regular hourly rate of pay for working with high 23 voltage (600 volts or more).
Sample 1Sample 2
High Voltage. 15.01 When working on live circuits carrying 750 rated volts or more, at least two workers must be assigned to perform the work, one of whom shall be an experienced journeyman, the other to be an employee who is a competent worker in the opinion of the employee in charge of the work. The Superintendent is not to be considered a journeyman.
Sample 1Sample 2
High Voltage. As defined by the Alberta Electrical Utility Code.
Sample 1Sample 2
High Voltage. When Iron Workers are employed around high voltage on crane hot rails, the power shall be disconnected to a minimum distance of fifty (50) feet from the nearest Iron Worker. Safety lights will identify the work area and safety dogs secured to crane rails until completion of work.
Sample 1
High Voltage. 4.37.1 The Contractor will maintain the high voltage equipment systems to achieve continuity of operation and maintain essential services. Site based High Voltage Authorised Person is to form part of the contractors team.
Sample 1
High Voltage. Paragraph X. When Iron Workers are employed around high voltage on crane hot rails the power shall be disconnected to a minimum distance of fifty (50) feet from the nearest Iron Worker. Safety lights to be strung across bay, and safety dogs secured to crane rails until completion of work. When Iron Workers are employed around high tension or power lines, a minimum distance of fifty (50) feet shall be kept between the Iron Worker or crane and such lines. FLOATS Paragraph Y. Floats shall be 3-1/2 feet x 6 feet x ¾ inch marine or exterior plywood reinforced with two by fours with a 1 inch manila line (or hemp) with a 1 inch board on edge to hold material and tools from dropping off said float. (See diagram on page 74) TOWER ERECTION
Sample 1
AutoNDA by SimpleDocs

Related to High Voltage

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where EveryCall has requested an Unbundled Loop and BellSouth uses Integrated Digital Loop Carrier (IDLC) systems to provide the local service to the end user and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to EveryCall. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for EveryCall (e.g. hairpinning):

  • One-Way Interconnection Trunks 2.3.1 Where the Parties use One-Way Interconnection Trunks for the delivery of traffic from CBB to Verizon, CBB, at CBB’s own expense, shall:

  • Switching All of the negotiated rates, terms and conditions set forth in this Section pertain to the provision of local and tandem switching.

  • Two-Way Interconnection Trunks 2.4.1 Where the Parties have agreed to use Two-Way Interconnection Trunks for the exchange of traffic between Verizon and ICG, ICG shall order from Verizon, and Verizon shall provide, the Two-Way Interconnection Trunks, and the Entrance Facility on which such Trunks will ride, and transport and multiplexing, in accordance with the rates, terms and conditions set forth in this Agreement and Verizon’s applicable Tariffs.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Generators Temporary installation of generators, and permanent installation of generators that are placed inside existing non-residential buildings or that occupy an area under 50 square feet behind the building they serve.

  • Local Switching Interfaces 4.2.13.1 Deland Actel shall order ports and associated interfaces compatible with the services it wishes to provide as listed in Exhibit A. BellSouth shall provide the following local switching interfaces:

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Electrical Service Electrical service for new construction or a renovated existing building shall be 480/277-volt, 3-phase, 4-wire or approved equal. Service shall be sized for HVAC and other mechanical system(s) loads, lighting, general building services, and dedicated computer based office equipment loads. 5 xxxxx per square foot shall be provided for lighting and general service receptacles. Size of neutral conductor of 3- phase circuits shall be twice that of phase conductor to accommodate potential harmonic currents associated with computer system electronic power supplies and fluorescent lighting fixtures electronic ballasts. An adequately sized 3 phase “wye” wound step down transformer shall be provided to supply 208/120-volt, 3 phase power, for lighting, general service receptacles and dedicated computer based office equipment. Dedicated, isolated ground circuits shall be supplied from separate isolated ground power distribution panel(s). Lighting circuits shall be supplied from separate lighting panel(s). Panels shall have 20% spare capacity and be complete with 10% spare breakers of each size, but no less than 1 spare. No more than 4 duplex receptacles shall be connected to any single 20-amp dedicated isolated ground circuit or general service circuit.

  • Vaccine Passports Pursuant to Texas Health and Safety Code, Section 161.0085(c), Contractor certifies that it does not require its customers to provide any documentation certifying the customer’s COVID-19 vaccination or post-transmission recovery on entry to, to gain access to, or to receive service from the Contractor’s business. Contractor acknowledges that such a vaccine or recovery requirement would make Contractor ineligible for a state-funded contract.

Time is Money Join Law Insider Premium to draft better contracts faster.