Evaporators o Clean tubes bi-annually. Inspect tubes or fins annually, clean fins as required. o Check for rust and scale (quarterly). o Check and paint as needed.
Evaporators Sample Clauses
Related to Evaporators
Welding Welding and use of cutting torches or cutoff saws will be permitted only in areas that have been cleared or are free of all material capable of carrying fire. Flammable debris and vegetation must be removed from within a minimum 10-foot radius of all welding and cutting operations. A shovel and a 5-gallon standard backpack water container filled and with handpump attached shall be immediately available for use in the event of a fire start. C8.212 – MARKET-RELATED CONTRACT TERM ADDITION (11/08). The term of this contract may be adjusted when a drastic reduction in wood product prices has occurred in accordance with 36 CFR 223.52. The Producer Price Index used to determine when a drastic reduction in price has occurred is stated in A20. Purchaser will be notified whenever the Chief determines that a drastic reduction in wood product prices has occurred. If the drastic reduction criteria specified in 36 CFR 223.52 are met for 2 consecutive calendar quarters, after contract award date, Contracting Officer will add 1 year to the contract term, upon Purchaser’s written request. For each additional consecutive quarter such a drastic reduction occurs, Contracting Officer will, upon written request, add an additional 3 months to the term during Normal Operating Season, except that no single 3-month addition shall extend the term of the contract by more than one year. Contracting Officer must receive Purchaser’s written request for a market-related contract term addition before the expiration of this contract. No more than 3 years shall be added to a contract's term by market-related contract term addition unless the following conditions are met:
Emissions The provisions cited above do not prohibit emissions above a specified level. Without information on engine usage and emission rates, it is not practicable to quantify the excess emissions. However, since CARB has alleged that the vessel(s) did not meet the regulatory requirements, all of the emissions from it were excess and illegal.
Noise The Hirer shall ensure that the minimum of noise is made on arrival and departure, particularly late at night and early in the morning. The Hirer shall, if using sound amplification equipment, make use of any noise limitation device provided at the premises and comply with any other licensing condition for the premises.
Discharges 1) If the arbitrator finds that the order of discharge should be modified, the appellant shall be restored to a position in his or her former class subject to forfeiture of pay and fringe benefits for all or a portion of the period of time the appellant was removed from duty, as determined by the arbitrator.
KITCHEN Discard all leftover food in large trash receptacle in kitchen and empty any smaller trash receptacles if used into large trash can in kitchen. Empty large trash bin into the dumpster, (if feasible). If not, please notify front desk. Flatware is to be pre-soaked, washed in dishwasher, dried, returned to drawers and placed facing in the same direction. Dishes, glassware, chopping boards, cooking utensils, pots/pans, baking sheets etc. should be washed in accordance with the instructions on the dish washing machine and returned DRY to dish carts and cupboards. Please check for lipstick/chap stick marks and clean those off accordingly before putting glasses/cups away. Wipe down outside of dishwasher, empty dishwasher food trap into trash and wash out. Counters and sinks wiped down with the water and bleach solution. If used, please wipe inside and out microwave oven; wall/warming ovens, inside the refrigerator and refrigerator door. Run garbage disposal in large double sink by dishwashing machine to clear food waste (Please do not put any food waste in small sinks). Wipe out Alto-Shaam (Warming Ovens) and clean food trays if used. Rinse out any Dish Tubs. Empty any tubs of excess ice outside, if used. Sweep floor of food debris. Empty large trash bin into the dumpster (if feasible). If not please notify front desk. B BQ’s: Make sure propane is turned off after use Clean grill racks with wire brush and wipe up any spills /food debris from the BBQ Leave outside to cool. Please check with Front Desk regarding storage of cold and cleaned BBQ’s PATIO: Return outdoor umbrellas and furniture to original positions. Wipe down outdoor furniture if spills have occurred. Dispose of trash/food waste and cigarette butts in trash receptacles. The following applies if any food and/or beverages have been served in these rooms: GREAT ROOM: Wipe down tables with bleach /water solution. (Located under the sink in the kitchen next to the coffee maker). If linens have been used or rented, please shake off any food debris in trash receptacles and place linens in mesh bags provided. Sorting by color or type is not necessary. Notify front desk of any beverage spills as soon as they occur. Empty any trash receptacles into large trash can in kitchen and then empty that into the dumpster (if feasible). If not please notify front desk. Sweep/Vacuum carpet of any food debris. (These items are located in the cupboard next to Men’s restroom.
Garbage The Concessionaire will contract directly with the service provider for adequate dumpster capacity and wildlife resistance. The Department must pre- approve the location of dumpsters and frequency of pick-ups. The Concessionaire will provide recycle bins for use by Park visitors.
Baggage For the transportation of checked baggage and cargo THE CARRIER’s liability shall be limited to ten grams of pure gold per kilo of checked baggage or cargo per person, unless a special declaration of value has been made by the sender at the time cargo is of delivered to THE CARRIER and by paying a supplementary fee, if applicable. With respect to items under the Passenger’s custody, THE CARRIER’s liability shall be limited to two hundred grams of pure gold per person for all carry-on items.
Recycling If this Agreement provides for the purchase or use of goods specified in PCC 12207 (for example, certain paper products, office supplies, mulch, glass products, lubricating oils, plastic products, paint, antifreeze, tires and tire-derived products, and metal products), this section is applicable with respect to those goods. Without limiting the foregoing, if this Agreement includes (i) document printing, (ii) parts cleaning, or (iii) janitorial and building maintenance services, this section is applicable. Contractor shall use recycled products in the performance of this Agreement to the maximum extent doing so is economically feasible. Upon request, Contractor shall certify in writing under penalty of perjury, the minimum, if not exact, percentage of post consumer material as defined in the PCC 12200, in such goods regardless of whether the goods meet the requirements of PCC 12209. With respect to printer or duplication cartridges that comply with the requirements of PCC 12156(e), the certification required by this subdivision shall specify that the cartridges so comply.
Insulation In exterior walls? Yes No Unknown In ceiling/attic? Yes No Unknown In any other areas? Yes No Where? Comments:
Surface Grade and shape the road surface, turnouts, and shoulders to the original shape on the TYPICAL SECTION SHEET. Inslope or outslope as directed to provide a smooth, rut-free traveled surface and maintain surface water runoff in an even, unconcentrated manner. Blading shall not undercut the backslope or cut into geotextile fabric on the road. If required by the Contract Administrator, water shall be applied as necessary to control dust and retain fine surface rock. Surface material shall not be bladed off the roadway. Replace surface material when lost or worn away, or as directed by the Contract Administrator. Remove shoulder berms, created by grading, to facilitate drainage, except as marked or directed by the Contract Administrator. For roads with geotextile fabric: spread surface aggregate to fill in soft spots and wheel ruts (barrel spread) to prevent damage to the geotextile fabric.
