Rate Adjustment (a) An employee who is set back to a lower paid job because of mechanization, technological change or automation will receive the rate of his regular job at the time of the setback for a period of three (3) months and for a further period of three (3) months he will be paid an adjusted rate which will be midway between the rate of his regular job at the time of the setback and the rate of his new regular job. At the end of this 6-month period the rate of his new regular job will apply. However, such employee will have the option of terminating his employment and accepting severance pay as outlined in Section 5 below, providing he exercises this option within the above-referred-to 6-month period.
Non pre-priced Adjustment Factor To be applied to Work deemed not to be included in the CTC but within the general scope of the work:
RATE ADJUSTMENTS 1. Taxes applicable to the gas delivered to Buyer hereunder as are in effect on January 1,\ immediately preceding the effective date of these terms and conditions shall be added to Buyer's bill. The term 'tax' as used herein shall mean any tax, license fee, or charge applicable to the gas delivered hereunder, imposed on Seller by any governmental authority on such gas. If the existing rate of any such tax in effect on January 1'\, immediately preceding the effective date of these terms and conditions, be hereafter increased or decreased, or if any tax heretofore in effect or hereafter be imposed or repealed, the resulting increase or decrease In such taxes, computed on a cents per dekatherm basis, shall be renected, as the case may be, on Buyer's bill.
First Year Wage Adjustment Effective July 1, 2017, all salary ranges and rates shall be increased by two percent (2.0%), rounded to the nearest cent. The compensation grids for classes covered by this Agreement are contained in Appendix E-1. Employees shall convert to the new compensation grid as provided in Section 2.
Reallocation to a Class with a Lower Salary Range Maximum 1. If the employee meets the skills and abilities requirements of the position and chooses to remain in the reallocated position, the employee retains existing appointment status and has the right to be placed on the Employer’s internal layoff list for the classification occupied prior to the reallocation.
Wage Adjustment Notwithstanding any provision in this Agreement on the contrary, the wages of employees shall be reduced by the amount of employee contributions made by the employer pursuant to the provisions hereof.
Change in pension value This is the change in present value of defined benefit and actuarial pension plans.
Reallocation to a Class with an Equal Salary Range Maximum 1. If the employee meets the skills and abilities requirements of the position, the employee remains in the position and retains existing appointment status.
Rate Redetermination for Market Change In the event of delay or interruption, exceeding 90 days, under B8.33, Contracting Officer shall make an appraisal to determine for each species the difference between the appraised unit value of Included Timber immediately prior to the delay or interruption and the appraised unit value of Included Timber immediately after the delay or interruption. The appraisal shall be done after any rate redetermination done pursuant to B3.31, using remaining volumes. Tentative Rates and Flat Rates in effect at the time of delay or interruption or established pursuant to B3.31 will be reduced, if appraised rates declined during the delay or interruption, to become Current Contract Rates. Increases in rates will not be considered. Accordingly, Base Rates shall be adjusted to correspond to the redetermined rates if redetermined rates are less than the original Base Rates, subject to a new Base Rate limitation of the cost of essential reforestation or 25 cents per hundred cubic feet or equivalent, whichever is larger. However, existing Base Indices shall not be changed under this Subsection. Redetermined rates shall be considered established under B3.1 for timber Scaled subsequent to the delay or interruption.
Non-Pre-Priced Markup If the material being utilized for a project cannot be found in the RS Means Price Book, what is your materials markup? Remember that this is a ceiling markup. You may markup a lesser percentage, but not a greater percentage.
