Controls and Temperature Uniformity Sample Clauses

Controls and Temperature Uniformity. The HVAC system excluding the operator's heater/defroster shall be centrally controlled with an advanced electronic/diagnostic control system with provisions for extracting/reading data. After manual selection and/or activation of climate control system operation mode, all interior climate control system requirements for the selected mode shall be attained automatically to within ±2°F of specified temperature control set-point. The operators control panel shall display the interior set point, return air and exterior ambient temperatures. The climate control system shall have the provision to allow driver to adjust the temperature control set- point at a minimum of between 66°F and 76°F, from then on, all interior climate control system requirements shall be attained automatically, unless re-adjusted by driver. The operator shall have full control over the defroster and operator's heater. The operator shall be able to adjust the temperature in the operator's area through air distribution and fans. The interior climate control system shall switch automatically to the ventilating mode if the refrigerant compressor or condenser fan fails. Interior temperature distribution shall be uniform to the extent practicable to prevent hot and/or cold spots. After stabilization with doors closed, the temperatures between any two points in the same vertical plane in the passenger compartment, from 6 inches to 72 inches above the floor, shall not vary by more than 5°F with doors closed. The interior temperatures, measured at the same height above the floor, shall not vary more than ± 5°F, from the front to the rear, from the average temperature determined in accordance to APTA Recommended Instrumentation and Performance Testing for Transit Bus Air Conditioning System. Variations of greater than ± 5°F will be allowed for limited, localized areas provided the majority of the measured temperatures fall within the specified requirement. The air conditioning system shall be equipped with the following protective controls: High pressure cutout switch Low pressure cutout switch on pressure transducer Ambient sensing switch These switches will interrupt the compressor energizing circuit. Both the high and low-pressure switches will energize a fault lamp at the operator's information panel. The HVAC system shall utilize a reheat system. No modes of the HVAC System shall operate unless the generator is charging.
AutoNDA by SimpleDocs

Related to Controls and Temperature Uniformity

  • TOOLS AND CLOTHING 30.1 An employee shall be required to provide himself with the ordinary hand tools of his trade, based on established trade union practices at the time of signing of this Agreement. EPSCA and the Union shall establish an appropriate tool list for each trade. Each Employer will provide, insofar as is practical, separate facilities for storing the tools of each trade, but shall not be held responsible for losses, except as noted hereunder:

  • Tools and Equipment As established by current practices, the Employer may determine and provide necessary tools, tool allowance, equipment and foul weather gear. The Employer will repair or replace employer-provided tools and equipment if damaged or worn out beyond usefulness in the normal course of business. Employees are accountable for equipment and/or tools assigned to them and will maintain them in a clean and serviceable condition.

  • UNIFORMS, TOOLS AND EQUIPMENT 23.1 Uniforms‌ The Employer may require employees to wear uniforms. Where required, the Employer will determine and provide the uniform or an equivalent clothing allowance. The Employer will follow their policy regarding the provision and maintenance of required uniforms, specialized clothing and footwear. The cost of normal wear and tear and loss of required uniforms, specialized clothing and footwear due to workplace conditions is the responsibility of the Employer.

  • Access Controls a. Authorized Access - DST shall have controls that are designed to maintain the logical separation such that access to systems hosting Fund Data and/or being used to provide services to Fund will uniquely identify each individual requiring access, grant access only to authorized personnel based on the principle of least privileges, and prevent unauthorized access to Fund Data.

  • For Information/Tools and Other Research Studies  Outcome of project.  Published documents, including date, title, and periodical name.  A discussion of policy development. State if the project has been cited in government policy publications or technical journals, or has been used to inform regulatory bodies.  The number of website downloads.  An estimate of how the project information has affected energy use and cost, or have resulted in other non-energy benefits.  An estimate of energy and non-energy benefits.  Data on potential job creation, market potential, economic development, and increased state revenue as a result of project.  A discussion of project product downloads from websites, and publications in technical journals.  A comparison of project expectations and performance. Discuss whether the goals and objectives of the Agreement have been met and what improvements are needed, if any. • Respond to CAM questions regarding responses to the questionnaires. The Energy Commission may send the Recipient similar questionnaires after the Agreement term ends. Responses to these questionnaires will be voluntary. Products: • Kick-off Meeting Benefits Questionnaire • Mid-term Benefits Questionnaire • Final Meeting Benefits Questionnaire

  • Internal Controls The Company shall maintain a system of internal accounting controls sufficient to provide reasonable assurances that: (i) transactions are executed in accordance with management’s general or specific authorization; (ii) transactions are recorded as necessary in order to permit preparation of financial statements in accordance with GAAP and to maintain accountability for assets; (iii) access to assets is permitted only in accordance with management’s general or specific authorization; and (iv) the recorded accountability for assets is compared with existing assets at reasonable intervals and appropriate action is taken with respect to any differences.

  • Accreditation of Public Schools and Adoption and Implementation of School Plans The District will implement a system of accrediting all of its schools, as described in section 22-11- 307, C.R.S., which may include measures specifically for those schools that have been designated as Alternative Education Campuses, in accordance with the provisions of 1 CCR 301-57. The District will ensure that plans are implemented for each school in compliance with the requirements of the State Board pursuant to 1 CCR 301-1.

  • Skills and Abilities (i) Ability to communicate effectively both verbally and in writing.

  • Security Controls for State Agency Data In accordance with Senate Bill 475, Acts 2021, 87th Leg., R.S., pursuant to Texas Government Code, Section 2054.138, Contractor understands, acknowledges, and agrees that if, pursuant to this Contract, Contractor is or will be authorized to access, transmit, use, or store data for System Agency, Contractor is required to meet the security controls the System Agency determines are proportionate with System Agency’s risk under the Contract based on the sensitivity of System Agency’s data and that Contractor must periodically provide to System Agency evidence that Contractor meets the security controls required under the Contract.

  • Accounting Controls The Company and its Subsidiaries maintain systems of “internal control over financial reporting” (as defined under Rules 13a-15 and 15d-15 under the Exchange Act Regulations) that comply with the requirements of the Exchange Act and have been designed by, or under the supervision of, their respective principal executive and principal financial officers, or persons performing similar functions, to provide reasonable assurance regarding the reliability of financial reporting and the preparation of financial statements for external purposes in accordance with GAAP, including, but not limited to, internal accounting controls sufficient to provide reasonable assurance that (i) transactions are executed in accordance with management’s general or specific authorizations; (ii) transactions are recorded as necessary to permit preparation of financial statements in conformity with GAAP and to maintain asset accountability; (iii) access to assets is permitted only in accordance with management’s general or specific authorization; and (iv) the recorded accountability for assets is compared with the existing assets at reasonable intervals and appropriate action is taken with respect to any differences. Except as disclosed in the Registration Statement, the Pricing Disclosure Package and the Prospectus, the Company is not aware of any material weaknesses in its internal controls. The Company’s auditors and the Audit Committee of the Board of Directors of the Company have been advised of: (i) all significant deficiencies and material weaknesses in the design or operation of internal controls over financial reporting which are known to the Company’s management and that have adversely affected or are reasonably likely to adversely affect the Company’ ability to record, process, summarize and report financial information; and (ii) any fraud known to the Company’s management, whether or not material, that involves management or other employees who have a significant role in the Company’s internal controls over financial reporting.

Time is Money Join Law Insider Premium to draft better contracts faster.