Common use of Collection, Integrity and Identification of Specimen Clause in Contracts

Collection, Integrity and Identification of Specimen. After a test subject has been properly identified, and briefed about the reason for the test, the mechanics of the collection process shall be explained. The Sample Collector shall require the test subject to remove any unnecessary outer garment (e.g., coats, jackets, etc.) and shall visually check for signs of concealed items that might be used to adulterate or substitute a sample. Personal belongings such as briefcases, purses, and weapons/holsters, etc., must remain with the subject’s other outer garments. The subject shall retain control of his/her wallet. The test subject shall wash and dry his/her hands prior to providing a urine specimen. There shall be no further access to water, soap, any chemical agent, or other materials which would be used to adulterate the specimen until after it has been provided. The Sample Collector shall place a toilet bluing agent in the toilet bowl and, if the toilet is so equipped, in the reservoir tank. The purpose of this procedure is to deter the dilution of the specimen. The test subject shall be required to provide a specimen in a large, wide mouthed, easily carried, plastic non-reusable cup, unobserved and in the privacy of a stall or otherwise partitioned area. Unusual behavior shall be noted by the Sample Collector. The test subject will be provided two laboratory-approved specimen bottles (samples A and B.) The containers will have affixed to them specially prepared labels showing the test subject’s confidential identification number. The subject shall then be ordered to provide a urine specimen and to divide it equally between the two bottles in the presence of the Sample Collector. A minimum of 50 milliliters (1.7 fluid ounces) must be provided or the specimen will be considered incomplete. If the Sample Collector determines that there is an insufficient amount of urine (less than 50 milliliters total) in each specimen bottle, additional urine shall be collected. In this instance, the test subject shall remain under the supervision of the Sample Collection. The subject shall be asked to drink fluids to aid in urination and shall be allowed a reasonable amount of time to furnish additional urine. W hen additional specimens are provided, third and fourth bottles shall be labeled, and fastened to the original specimen bottles with clear tape. Immediately after a specimen collection, the Sample Collector shall ensure the temperature is between 90 and 100 degrees Fahrenheit. The Sample Collector shall also inspect the specimen for signs of adulteration (e.g., contaminants, color, etc.) Unusual findings should be noted. In the presence of the Sample Collector, the test subject shall secure lids on the specimen bottles. The Sample Collector shall then seal the lids with evidence tape. If at the time of collection, there is reason to believe that the specimens have been diluted, adulterated, substituted, or in any way tampered with, the Sample Collector shall report the matter on the Log Sheet. The Sample Collector shall report those observations in writing to the lab, which shall analyze the suspect specimens. The results of those analyses shall be reported in the written laboratory report to the MRO for further action, if any is appropriate.

Collection, Integrity and Identification of Specimen. After a test subject has been properly identified, and briefed about the reason for the testtest and has completed the Pre-test Declaration form, the mechanics of the collection process shall be explained. The Sample Collector Collection Site Supervisor shall require the test subject to remove any unnecessary outer garment (e.g., coats, jackets, etc.) and shall visually check for signs of concealed items that might be used to adulterate or substitute a sample. Personal belongings such as briefcases, purses, and weapons/holsters, etc., must remain with the subject’s 's other outer garments. The subject shall retain control of his/her wallet. The test subject shall wash and dry his/her hands prior to providing a urine specimen. There shall be no further access to water, soap, any chemical agent, or other materials which would be used to adulterate the specimen until after it has been provided. The Sample Collector Collection Site Supervisor shall place a toilet bluing agent in the toilet bowl and, if the toilet is so equipped, in the reservoir tank. The purpose of this procedure is to deter the dilution of the specimen. The test subject shall be required to provide a specimen in a large, wide mouthed, easily carried, plastic non-reusable cup, unobserved and in the privacy of a stall or otherwise partitioned area. Unusual behavior shall be noted by the Sample CollectorCollection Site Supervisor on the Collection Log Sheet. The test subject will be provided two laboratory-LASD or Bureau approved specimen bottles (samples A and B.) B). The containers will have affixed to them specially prepared labels showing the test subject’s 's confidential identification number. The subject's right thumb print will be rolled onto the labels by the Collection Site Supervisor. The subject shall then be ordered to provide a urine specimen and to divide it equally between the two bottles in the presence of the Sample CollectorCollection Site Supervisor. A minimum of 50 milliliters (1.7 fluid ounces) must be provided or the specimen will be considered incomplete. If the Sample Collector Collection Site Supervisor determines that there is an insufficient amount of urine (less than 50 milliliters total) in each the specimen bottlebottles, additional urine shall be collected. In this instance, the test subject shall remain under the supervision of the Sample CollectionCollection Site Supervisor. The subject shall be asked to drink fluids to aid in urination and shall be allowed a reasonable amount of time to furnish additional urine. W hen When additional specimens are provided, third and fourth bottles shall be labeled, be affixed with another thumbprint label and be fastened to the original specimen bottles with clear tape. Immediately tape immediately after a specimen collection, the Sample Collector Collection Site Supervisor shall ensure the temperature is between 90 and 100 degrees Fahrenheit. The Sample Collector Collection Site Supervisor shall also inspect the specimen for signs of adulteration (e.g., contaminants, color, etc.) ). Unusual findings should be notednoted in the remarks section of the Collection Log Sheet. In the presence of the Sample Collector, Collection Site Supervisor the test subject subject, shall secure lids on the specimen bottles. The Sample Collector Collection Site Supervisor shall then seal the lids with evidence tape. If at the time of collection, there is reason to believe that the specimens have been diluted, adulterated, substituted, or in any way tampered with, the Sample Collector Collection Site Supervisor shall report the matter on the Collection Log Sheet. The Sample Collector shall Collection Site Supervisor may report those observations in writing to the lab, which shall may analyze the suspect specimens. The results of those analyses shall be reported in the written laboratory report to the MRO for further action, if any is appropriateneeded.

Collection, Integrity and Identification of Specimen. ‌ After a test subject has been properly identified, identified and briefed about the reason for the test, the mechanics of the collection process shall be explained. The Sample Collector shall require the test subject to remove any unnecessary outer garment (e.g., coats, jackets, etc.) and shall visually check for signs of concealed items that might be used to adulterate or substitute a sample. Personal belongings such as briefcases, purses, and weapons/holsters, etc., must remain with the subject’s other outer garments. The subject shall retain control of his/her wallet. The test subject shall wash and dry his/her their hands prior to providing a urine specimen. There shall be no further access to water, soap, any chemical agent, or other materials materials, which would be used to adulterate the specimen until after it has been provided. The Sample Collector shall place a toilet bluing agent in the toilet bowl and, if the toilet is so equipped, in the reservoir tank. The purpose of this procedure is to deter the dilution of the specimen. The test subject shall be required to provide a specimen in a large, wide mouthed, easily carried, plastic non-reusable cup, unobserved and in the privacy of a stall or otherwise partitioned area. Unusual behavior shall be noted by the Sample Collector. The test subject will be provided two laboratory-approved specimen bottles (samples A and B.) B). The containers will have affixed to them specially prepared labels showing the test subject’s confidential identification number. The subject shall then be ordered to provide a urine specimen and to divide it equally between the two bottles in the presence of the Sample CollectorCollector or the Sample Collector will divide the specimen in the presence of the subject. A minimum of 50 milliliters (1.7 fluid ounces) must be provided or the specimen will be considered incomplete. If the Sample Collector determines that there is an insufficient amount of urine (less than 50 milliliters total) in each specimen bottle, additional urine shall be collected. In this instance, the test subject shall remain under the supervision of the Sample CollectionCollector. The subject shall be asked to drink fluids to aid in urination and shall be allowed a reasonable amount of time to furnish additional urine. W hen When additional specimens are provided, third and fourth bottles shall be labeled, labeled and be fastened to the original specimen bottles with clear tape. Immediately after a specimen collection, the Sample Collector shall ensure the temperature is between 90 and 100 degrees Fahrenheit. The Sample Collector shall also inspect the specimen for signs of adulteration (e.g., contaminants, color, etc.) Unusual findings should be noted. In the presence of the Sample Collector, the test subject shall secure lids on the specimen bottles. The Sample Collector shall then seal the lids with evidence tape. If at the time of collection, there is reason to believe that the specimens have been diluted, adulterated, substituted, or in any way tampered tempered with, the Sample Collector shall report the matter on the Log Sheet. The Sample Collector shall report those observations in writing to the lab, which shall analyze the suspect specimens. The results of those analyses analysis shall be reported in the written laboratory report to the MRO for further action, if any is appropriate.

Collection, Integrity and Identification of Specimen. After a test subject has been properly identified, and briefed about the reason for the testtest and has completed the Pre-test Declaration form, the mechanics of the collection process shall be explained. The Sample Collector Collection Site Supervisor shall require the test subject to remove any unnecessary outer garment (e.g., coats, jackets, etc.) and shall visually check for signs of concealed items that might be used to adulterate or substitute a sample. Personal belongings such as briefcases, purses, and weapons/holsters, etc., must remain with the subject’s 's other outer garments. The subject shall retain control of his/her wallet. The test subject shall wash and dry his/her hands prior to providing a urine specimen. There shall be no further access to water, soap, any chemical agent, or other materials which would be used to adulterate the specimen until after it has been provided. The Sample Collector Collection Site Supervisor shall place a toilet bluing agent in the toilet bowl and, if the toilet is so equipped, in the reservoir tank. The purpose of this procedure is to deter the dilution of the specimen. The test subject shall be required to provide a specimen in a large, wide mouthed, easily carried, plastic non-reusable cup, unobserved and in the privacy of a stall or otherwise partitioned area. Unusual behavior shall be noted by the Sample CollectorCollection Site Supervisor on the Collection Log Sheet. The test subject will be provided two laboratory-LASD or Bureau approved specimen bottles (samples A and B.) B). The containers will have affixed to them specially prepared labels showing the test subject’s 's confidential identification number. The subject's right thumbprint will be rolled onto the labels by the Collection Site Supervisor. The subject shall then be ordered to provide a urine specimen and to divide it equally between the two bottles in the presence of the Sample CollectorCollection Site Supervisor. A minimum of 50 milliliters (1.7 fluid ounces) must be provided or the specimen will be considered incomplete. If the Sample Collector Collection Site Supervisor determines that there is an insufficient amount of urine (less than 50 milliliters total) in each the specimen bottlebottles, additional urine shall be collected. In this instance, the test subject shall remain under the supervision of the Sample CollectionCollection Site Supervisor. The subject shall be asked to drink fluids to aid in urination and shall be allowed a reasonable amount of time to furnish additional urine. W hen When additional specimens are provided, third and fourth bottles shall be labeled, be affixed with another thumbprint label and be fastened to the original specimen bottles with clear tape. Immediately after a specimen collection, the Sample Collector Collection Site Supervisor shall ensure the temperature is between 90 and 100 degrees Fahrenheit. The Sample Collector Collection Site Supervises shall also inspect the specimen for signs of adulteration (e.g., contaminants, color, etc.) ). Unusual findings should be notednoted in the remarks section of the Collection Log Sheet. In the presence of the Sample Collector, Collection Site Supervisor the test subject subject, shall secure lids on the specimen bottles. The Sample Collector Collection Site Supervisor shall then seal the lids with evidence tape. If at the time of collection, there is reason to believe that the specimens have been diluted, adulterated, substituted, or in any way tampered with, the Sample Collector Collection Site Supervisor shall report the matter on the Collection Log Sheet. The Sample Collector shall Collection Site Supervisor may report those observations in writing to the lab, which shall may analyze the suspect specimens. The results of those analyses shall be reported in the written laboratory report to the MRO for further action, if any is appropriateneeded.