Alternative Excavation Methods. The City may consider alternative excavation methods as deemed appropriate by both Parties. The City’s approval of such methods shall be on the same terms as other utility installations using such methods.
Alternative Excavation Methods Sample Clauses
Related to Alternative Excavation Methods
Construction Methods No four course of brick-work, with three joints, shall exceed in height, when built, one inch more than the same bricks piles upon one another without mortar. The bricks are to be well soaked in water before use on works, in proper through so as to be thoroughly wet when layed. The Cessation of the bubbles through the water is an irldication of saturation being complete. For ensuring thorough soaking of the bricks every one or two bricklayers or more as necessary, shall be provided with tubs for use The wall of structures shall be carried up regularly in all cases 1` when the nature of the work will admit of it not leaving any part 915mm (3 feet) lower than another. Horizontal courses shalI be straight, level and even and faces of walls smooth and plumb. A straight edge and a plumb- xxx shall be used for constant checking during progress of the work. No brick-bats shall be permitted to be used except when necessary for obtaining the dimension of the different course or for obtaining the specified bond. All unfinished work must be raked back in course unless otherwise directed arid when new work is to be jointed to it the surface of unfinished work must be cleaned and wetted. The bricks shall be laid by placing sufficient mortar on the wall and forcing every brick into it in such a manner as to completely fill every joint with moratar whether at the bottom, side or end of the brick. The mortar to be used shall be that specified for the relevant schedule items and shall comply with the specification for the mortar specified. The bound used shall be English and shall be carried throughout the work. At all angles forming the junction of any two walls, the bricks shall, at each alternate course be carried into each of the respective walls, so as to thoroughly unite the work. V'Jhen the faces are to be plastered, the joints shall be well raked out before any plaster is laid on should the plaster from want of proper joint ranking detach and 7 fall off from the brick work, the contractor shall strip off the plaster bodily to the extent ordered by Superintending Engineer and shall re-do the work properly at his own expense. All requisite scaffolding shall be provided at the contractor's expense and shall be double i.e., must it have two sets of upright supports Care must be taken to ensure the safety of the work people and the contractor must comply with such instructions as the Superintending Engineer may issue to ensure such safety. The contractor will be entirely responsible for any damage or injuries to person or property resulting from ill-erected scaffolding, defective ladders, or otherwise arising out of his default in this respect. The brick work for the retaining wall shall proceed side by side with the depositing and compacting of earth between the retaining walls. At no time shall the brick-work be constructed more than 405mm (1'-4") above Y the compacted earth. In the retaining wall weep-holes shall be provided at suitable intervals as instructed during execution, with the inner surface of the weep-holed plastered 20mm (3/4") thick in cement mortar 1:4 crouched rock of grades in different layer shall be provided at the inner end of the weep-holes to prevent the choking of the weep-holes to have full drainage. No extra payment will be made for this and no deductions will be made for this in the brick-work.
Allocation Method The Plan Administrator will allocate a Plan-Designated QNEC using the following method (Choose one of a., b., c., or d.):
Alternative Resolution Methods Any time during the grievance process, by mutual consent, the parties may use alternative methods to resolve the dispute. If the parties agree to use alternative methods, the time frames in this Article are suspended. If the selected alternative method does not result in a resolution, the Union may return to the grievance process and the time frames resume. Any expenses and fees of alternative methods will be shared equally by the parties.
Alternative Work Schedule An alternate forty (40) hour work schedule (other than five (5) uniform and consecutive eight (8) hour days in a seven (7) day period), or for hospital personnel an eighty (80) hour workweek in a fourteen (14) day period and other mutually agreed upon schedules that comply with applicable federal and state law. Employee work schedules normally include two (2) consecutive days off.
Alternative Structure Notwithstanding any provision of this Agreement to the contrary, Parent may at any time modify the structure of the acquisition of the Company set forth herein, subject to the prior written consent of the Company, which consent shall not be unreasonably withheld or delayed, provided that (i) the Merger Consideration to be paid to the holders of Company Common Stock is not thereby changed in kind or reduced in amount as a result of such modification, (ii) such modification will not adversely affect the tax treatment of the Company's shareholders as a result of receiving the Merger Consideration and (iii) such modification will not materially delay or jeopardize receipt of any required approvals of Governmental Authorities.
Open Source Components The DS Offerings may include open source components. Whenever notices (such as acknowledgment, copies of licenses or attribution notice) are required by the original licensor, such notices are included in the Documentation of the DS Offerings. Moreover, some open source components may not be distributed and licensed under the terms of the Agreement but under the terms of their original licenses as set forth in the Documentation of the DS Offerings themselves. Source code for open source software components licensed under terms and conditions that mandate availability of such source code is available upon request. Except for components mentioned in the section EXCLUSIONS below, the warranty and indemnification provided by DS under the Agreement apply to all open source software components and shall be provided by DS and not by the original licensor, but only for the use of the DS Offerings that is in compliance with the terms of the Agreement, and in conjunction with the DS Offerings. The original licensors of said open source software components provide them on an “as is” basis and without any liability whatsoever to Customer.
Single Source Selection Services for tasks in circumstances which meet the requirements of paragraph 3.10 of the Consultant Guidelines for Single Source Selection, may, with the Association's prior agreement, be procured in accordance with the provisions of paragraphs 3.9 through 3.13 of the Consultant Guidelines.
Collection Allocation Mechanism On the CAM Exchange Date, (a) the Commitments shall automatically and without further act be terminated as provided in Article VII, (b) each Lender shall become obligated to fund, within one Business Day, all participations in outstanding Swingline Loans held by it (it being agreed that the CAM Exchange shall not result in a reallocation of such funding obligations, but only of the funded participations resulting therefrom) and (c) the Lenders shall automatically and without further act be deemed to have made reciprocal purchases of interests in the Designated Obligations such that, in lieu of the interests of each Lender in the particular Designated Obligations that it shall own as of such date and immediately prior to the CAM Exchange, such Lender shall own an interest equal to such Lender’s CAM Percentage in each Designated Obligation. Each Lender, each person acquiring a participation from any Lender as contemplated by Section 11.04 and each Borrower hereby consents and agrees to the CAM Exchange. Each Borrower and each Lender agrees from time to time to execute and deliver to the Administrative Agent all such promissory notes and other instruments and documents as the Administrative Agent shall reasonably request to evidence and confirm the respective interests and obligations of the Lenders after giving effect to the CAM Exchange, and each Lender agrees to surrender any promissory notes originally received by it hereunder to the Administrative Agent against delivery of any promissory notes so executed and delivered; provided that the failure of any Borrower to execute or deliver or of any Lender to accept any such promissory note, instrument or document shall not affect the validity or effectiveness of the CAM Exchange. As a result of the CAM Exchange, on and after the CAM Exchange Date, each payment received by the Administrative Agent pursuant to any Loan Document in respect of the Designated Obligations shall be distributed to the Lenders pro rata in accordance with their respective CAM Percentages (to be redetermined as of each such date of payment or distribution to the extent required by the next paragraph), but giving effect to assignments after the CAM Exchange Date, it being understood that nothing herein shall be construed to prohibit the assignment of a proportionate part of all an assigning Lender’s rights and obligations in respect of a single Class of Commitments or Loans. In the event that, after the CAM Exchange, the aggregate amount of the Designated Obligations shall change as a result of the making of an LC Disbursement of either Tranche by an Issuing Bank that is not reimbursed by the applicable Borrower, then (a) each Lender of such Tranche shall, in accordance with Section 2.05(d), promptly purchase from the applicable Issuing Bank a participation in such LC Disbursement in the amount of such Lender’s Tranche One Percentage or Tranche Two Percentage, as the case may be, of such LC Disbursement (without giving effect to the CAM Exchange), (b) the Administrative Agent shall redetermine the CAM Percentages after giving effect to such LC Disbursement and the purchase of participations therein by the applicable Lenders, and the Lenders shall automatically and without further act be deemed to have made reciprocal purchases of interests in the Designated Obligations such that each Lender shall own an interest equal to such Lender’s CAM Percentage in each of the Designated Obligations and (c) in the event distributions shall have been made in accordance with the preceding paragraph, the Lenders shall make such payments to one another as shall be necessary in order that the amounts received by them shall be equal to the amounts they would have received had each LC Disbursement been outstanding immediately prior to the CAM Exchange. Each such redetermination shall be binding on each of the Lenders and their successors and assigns and shall be conclusive absent manifest error.
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
Validation Mechanism To be eligible for articulation, the student must show evidence of their CompTIA A+ certification and it must have been issued within three (3) years prior to their enrollment in the program.
