Fishing gear means any item or piece of equipment that is used in fishing or aquaculture to target, capture or rear marine biological resources or that is floating on the sea surface, and is deployed with the objective of attracting and capturing or of rearing such marine biological resources;
Landing Gear means the installed main and nose landing gear, components and their associated actuators, side braces and parts.
Engine Manufacturer means CFM International, Inc.
Spares means a part or a sub-assembly or assembly for substitution which is ready to replace an identical or similar part or sub-assembly or assembly including a component or an accessory;
Propeller means for a device for propelling an aircraft that has blades on a powerplant driven shaft and that, when rotated, produces by its action on the air, a thrust approximately perpendicular to its plane of rotation and it includes control components normally supplied by its manufacturer, but does not include main and auxiliary rotors or rotating airfoils of powerplants;
Satellite Manufacturer means, with respect to any Satellite, the prime contractor and manufacturer of such Satellite.
Compression Ignition Engine means an internal combustion engine with operating characteristics significantly similar to the theoretical diesel combustion cycle. The regulation of power by controlling fuel supply in lieu of a throttle is indicative of a compression ignition engine.
Faux finishing coating means a coating labeled and formulated as a stain or a glaze to create artistic effects including, but not limited to, dirt, old age, smoke damage, and simulated marble and wood grain.
explosive actuated fastening device means a tool that is activated by an explosive charge and that is used for driving bolts, nails and similar objects for the purpose of providing fixing;
Polystyrene foam adhesive means an aerosol adhesive designed to bond polystyrene foam to substrates.
High voltage bus means the electrical circuit, including the coupling system for charging the REESS that operates on a high voltage.
Engine degreaser means a cleaning product designed to remove grease, grime, oil and other contaminants from the external surfaces of engines and other mechanical parts.
Cannabis cultivation facility means a person that:
Commercial Fishing Worker means Commercial fishing worker as defined in Section 420.503, F.S.
APU means the auxiliary power unit of the Aircraft.
NACE means National Association of Corrosion Engineers
Modular building manufacturer means a person or corporation who owns or operates a
Plasma arc incinerator means any enclosed device using a high intensity electrical discharge or arc as a source of heat followed by an afterburner using controlled flame combustion and which is not listed as an industrial furnace.
Stinger-steered automobile or watercraft transporter means an automobile or watercraft transporter
Filtering facepiece (dust mask) means a negative pressure particulate respirator with a filter as an integral part of the facepiece or with the entire facepiece composed of the filtering medium, not equipped with elastomeric sealing surfaces and adjustable straps.
Original manufacturer means the original component manufacturer, the original equipment manufacturer, or the contract manufacturer.
Tight-fitting facepiece means a respiratory inlet covering that forms a complete seal with the face.
Improvement warranty period means a period:
Overhaul means the full reconditioning of the Aircraft, an Engine, APU, Landing Gear, module or Part, as the case may be, in which such equipment has been fully disassembled; cleaned; thoroughly inspected; and returned to the highest standard specified by the applicable manufacturer's manual.
Gestational carrier means an adult woman who enters into an agreement to have an embryo implanted in her and bear the resulting child for intended parents, where the embryo is conceived by using the egg and sperm of the intended parents.
Built-Up Area and/or “Covered Area” in relation to a Flat shall mean the floor area of that Flat including the area of balconies and terraces, if any attached thereto, and also the thickness of the walls (external or internal) and the columns and pillars therein Provided That if any wall, column or pillar be common between two Flats, then one-half of the area under such wall column or pillar shall be included in the built-up area of each such Flat.