Common use of Telemetry Clause in Contracts

Telemetry. Seller shall send via a means of transmission approved by the Operating Committee and consistent with Good Utility Practice and the PJM Agreements the specific telemetry data points required for the Project, as measured by the Project Meter, including: MW, MVAR, MWH, MVARH, isolation breaker open/closed status, interconnection bus voltage, and amp flow. A data line will be required to send this data to Buyer. These telemetry data point requirements are outlined in Buyer’s “Technical Considerations Covering Parallel Operations of Customer Owned Generation of One Megawatt or Greater and Interconnected with the Conectiv Power Delivery System.” The MWH and MVARH values that are telemetered to Buyer must originate from the Project Meter. Seller shall have the obligation to accurately and completely send meter telemetry into the PJM eMeter system. Seller shall establish, in consultation with Buyer, a system allowing Buyer and Seller to provide real-time dynamic signals sufficient to fulfill the scheduling parameters of this Agreement and applicable PJM rules, including enabling Seller to provide real-time dynamic signals to Buyer regarding the types and amounts of Products that are to be delivered pursuant to this Agreement and enabling Seller to provide Buyer real-time dynamic signals specifying the amount of Delivered Energy that is being delivered to the Delivery Point at all times.

Telemetry. Seller shall send via a means of transmission approved by the Operating Committee and consistent with Good Utility Practice and the PJM Agreements the Agreements. The specific telemetry data points required for the Project, as measured by the Project Meter, includingare: MW, MVAR, MWH, MVARH, isolation breaker open/closed status, interconnection bus voltage, and amp flow. A data line will be required to send this data to Buyer. These telemetry data point requirements are outlined in Buyer’s “Technical Considerations Covering Parallel Operations of Customer Owned Generation of One Megawatt or Greater and Interconnected with the Conectiv Power Delivery System.” The MWH and MVARH values that are telemetered to Buyer must originate from the Project Meter. Seller shall have the obligation to accurately and completely send meter telemetry into the PJM eMeter system. Seller shall establish, in consultation with Buyer, a system allowing Buyer and Seller to provide real-time dynamic signals sufficient to fulfill the scheduling parameters of this Agreement and applicable PJM rules, including enabling Seller to provide real-time dynamic signals to Buyer regarding the types and amounts of Products that are to be delivered pursuant to this Agreement and enabling Seller to provide Buyer real-time dynamic signals specifying the amount of Delivered Energy that is being delivered to the Delivery Point at all times.