Deposit of Fund Assets in U.S. Securities Systems The Custodian may deposit and/or maintain securities owned by a Portfolio in a U.S. Securities System in compliance with the conditions of Rule 17f-4 under the 1940 Act, as amended from time to time.
Liability of Foreign Sub-Custodians and Foreign Securities Systems Each agreement pursuant to which the Custodian employs as a Foreign Sub-Custodian shall, to the extent possible, require the Foreign Sub-Custodian to exercise reasonable care in the performance of its duties and, to the extent possible, to indemnify, and hold harmless, the Custodian from and against any loss, damage, cost, expense, liability or claim arising out of or in connection with the Foreign Sub-Custodian’s performance of such obligations. At the Fund’s election, the Funds shall be entitled to be subrogated to the rights of the Custodian with respect to any claims against a Foreign Sub-Custodian as a consequence of any such loss, damage, cost, expense, liability or claim if and to the extent that the Funds have not been made whole for any such loss, damage, cost, expense, liability or claim.
Deposit of Fund Assets in Securities Systems The Custodian may deposit and/or maintain securities owned by a Portfolio in a clearing agency registered with the Securities and Exchange Commission under Section 17A of the Securities Exchange Act of 1934, which acts as a securities depository, or in the book-entry system authorized by the U.S. Department of the Treasury and certain federal agencies, collectively referred to herein as "Securities System" in accordance with applicable Federal Reserve Board and Securities and Exchange Commission rules and regulations, if any, and subject to the following provisions:
Incorporation of Prompt Payment Policy Statement into Contracts The provisions of this Exhibit shall apply to all Payments as they become due and owing pursuant to the terms and conditions of this Agreement, notwithstanding that NYSERDA may subsequently amend its Prompt Payment Policy by further rulemaking.
CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes
Ownership of Common Securities by Depositor (a) On the Closing Date, the Depositor shall acquire, and thereafter shall retain, beneficial and record ownership of the Common Securities. Neither the Depositor nor any successor Holder of the Common Securities may transfer less than all the Common Securities, and the Depositor or any such successor Holder may transfer the Common Securities only (i) in connection with a consolidation or merger of the Depositor into another Person, or any conveyance, transfer or lease by the Depositor of its properties and assets substantially as an entirety to any Person (in which event such Common Securities will be transferred to such surviving entity, transferee or lessee, as the case may be), pursuant to Section 8.1 of the Indenture or (ii) to the Depositor or an Affiliate of the Depositor, in each such case in compliance with applicable law (including the Securities Act, and applicable state securities and blue sky laws). To the fullest extent permitted by law, any attempted transfer of the Common Securities other than as set forth in the immediately preceding sentence shall be void. The Administrative Trustees shall cause each Common Securities Certificate issued to the Depositor to contain a legend stating substantially “THIS CERTIFICATE IS NOT TRANSFERABLE EXCEPT IN COMPLIANCE WITH APPLICABLE LAW AND SECTION 5.11 OF THE TRUST AGREEMENT.”
Portfolio Securities Portfolio securities of the Issuer may be bought or sold by or through Distributors, and Distributors may participate directly or indirectly in brokerage commissions or "spreads" for transactions in portfolio securities of the Issuer.
Recent Securities Transactions, etc Except as contemplated in the Prospectus, subsequent to the respective dates as of which information is given in the Registration Statement and the Prospectus, and except as may otherwise be indicated or contemplated herein or therein, the Company has not: (i) issued any securities or incurred any liability or obligation, direct or contingent, for borrowed money; or (ii) declared or paid any dividend or made any other distribution on or in respect to its capital stock.
Special Permit from Relevant Ministerial/ Government Agencies and Foreign Capital Ownership Limitation Raw Material for Explosives (Ammonium Nitrate) with maximum foreign equity ownership of 49% and a special permit from the Minister of Defense (ISIC 2411) Industry of explosive materials and its components for industry need with maximum foreign equity ownership of 49% and a special permit from the Minister of Defense (ISIC 2429) Sugar Industry (Xxxxx Xxxxxxx Sugar, Refined Crystal Sugar and Raw Crystal Sugar) with maximum foreign equity ownership of 95% and a special permit from the Minister of Industry and the Minister of Agriculture, and it has to be integrated with the sugar plantation. The manufacturing of raw crystal sugar is required for any sugar manufacturer with sugarcane input capacity exceeding 8000 tons per day (ISIC 1542) Processing of plantation product industry (similar capacity or exceeding a certain capacity, according to Regulation of Minister of Agriculture Number 26 of 2007 with maximum foreign capital ownership of 95% with a special permit from Minister of Agriculture. - Fiber and Seed Cotton Industry (ISIC1514, 1711) - Crude oil industry (edible oil) from vegetable and animal, coconut oil industry, palm oil industry, rubber to be sheet, thick latex, crumb rubber industry, raw castor oil industry, sugar, sugar cane and sugar cane residue industry, black tea/green tea industry, dry tobacco leaves industry, Copra, Fiber, Coconut Charcoal, Dust, Nata de coco industry, Coffee sorting, cleaning and peeling industry, Cocoa cleaning, peeling and drying industry, cleaning and peeling seed other than coffee and cacao industry, cashew to be dry seed cashew and Cashew Nut Shell Liquid (CNSL) Industry, Peppercorn to be dry white pepper and dry black pepper industry (ISIC 1514, 2429, 1542, 1549, 1600, 2519, 1531)
THE DEPOSITARY, THE CUSTODIANS AND THE COMPANY SECTION 5.1
