Select Block Sample Clauses

Select Block. The selected elements are isolated. To de-isolate the elements again, repeat all previous steps but select Un- block in step 6. C
AutoNDA by SimpleDocs
Select Block. Caution! The system does not transmit any information as to whether it was possible to isolate the selected element. To monitor the operation, check the element. 12 Bypass‌ This chapter contains information about the following points: – Bypassing and un-bypassing elements, page 56 – Displaying and un-bypassing bypassed element groups, page 57 – Displaying list of all bypassed elements, page 57 – Bypassing/Un-bypassing buzzer, page 58 ! Warning! Bypassed detectors: Alarm messages from bypassed detectors are no longer displayed, only faults. Isolated detectors: Isolated detectors are not analyzed.

Related to Select Block

  • Panel Selection 1. The Parties shall apply the following procedures in selecting a Panel: (a) the Panel shall comprise 3 members; (b) within 15 days following the date of the establishment of the Panel, each Party shall nominate a Panelist; (c) the Parties shall endeavor

  • Supplier Selection If Customer selects a seat or galley supplier that is not on the Boeing recommended list, such seat or galley will become BFE and the provisions of Exhibit A, Buyer Furnished Equipment Provisions Document, of the AGTA will apply.

  • Site Selection The District shall be solely responsible for all costs associated with the project site, including acquisition, environmental remediation, and unanticipated site conditions.

  • Selection Criteria Each Contract is secured by a new or used Motorcycle. No Contract has a Contract Rate less than 1.00%. Each Contract amortizes the amount financed over an original term no greater than 84 months (excluding periods of deferral of first payment). Each Contract has a Principal Balance of at least $500.00 as of the Cutoff Date.

  • Procurement Method (a) Quality-Based Selection (b) Selection under a Fixed Budget

  • Recruitment and Selection Swedish Medical Center will recruit and hire the most qualified applicants to meet the staffing needs of the Center and thereafter transfer, promote, and retain such persons as employees. All such actions and decisions shall comply with the Center’s desire to promote from within whenever qualified candidates are identified, interested, and available.

  • Selection Lessee acknowledges that it has selected the Equipment and disclaims any reliance upon statements made by the Lessor, other than as set forth in the Schedule.

  • Selection Procedure 10.2.4.1 Internal applicants shall be defined as all applicants with seniority in accordance with Article 12.5.

  • STATEWIDE CONTRACT MANAGEMENT SYSTEM If the maximum amount payable to Contractor under this Contract is $100,000 or greater, either on the Effective Date or at any time thereafter, this section shall apply. Contractor agrees to be governed by and comply with the provisions of §§00-000-000, 00-000-000, 00-000-000, and 00- 000-000, C.R.S. regarding the monitoring of vendor performance and the reporting of contract information in the State’s contract management system (“Contract Management System” or “CMS”). Contractor’s performance shall be subject to evaluation and review in accordance with the terms and conditions of this Contract, Colorado statutes governing CMS, and State Fiscal Rules and State Controller policies.

  • Least-cost Selection Services for assignments which the Association agrees meet the requirements of paragraph 3.6 of the Consultant Guidelines may be procured under contracts awarded on the basis of Least-cost Selection in accordance with the provisions of paragraphs 3.1 and 3.6 of the Consultant Guidelines.

Time is Money Join Law Insider Premium to draft better contracts faster.