Peak Usage Pricing Sample Clauses

Peak Usage Pricing. A Peak Usage circuit is provisioned as a full circuit giving Customer the ability to use the entire port. If a minimum port usage (Mbps) commitment is identified on the Customer's Service Order, the monthly recurring charge is equal to the usage charge for the commitment level and no static port charge is applied. If no minimum port usage commitment is identified, the monthly recurring charge is a static port charge. At the end of the month, Xxxxxxxx reconciles Customer's port usage to determine if usage charges apply. Usage charges are applied to the following month's invoice based on Customer's port usage for the preceding month. Usage charges may vary from month to month and are calculated by multiplying the port usage (Mbps) by the usage rate ($/Mbps). If a minimum port usage commitment is identified, the port usage is equal to the difference between Customer's port usage and the usage commitment. If the Customer's port usage is less than the minimum port usage commitment, Customer's monthly recurring charge will not change. The Customer's port usage in a given month shall be the higher of either inbound or outbound traffic measured at the ninety-fifth percentile (95%) (remove top 5% of total traffic readings) based on traffic sampled every two and one-half (2.5) minutes and aggregated in fifteen (15) minute increments, as determined by Xxxxxxxx.
Sample 1
AutoNDA by SimpleDocs

Related to Peak Usage Pricing

  • Maximum Total Leverage Ratio Permit the Total Leverage Ratio as of the end of any fiscal quarter ending on or after September 30, 2006, to be greater than the ratio set forth below opposite the fiscal quarter end: Fiscal Quarter Ending Ratio on or prior to December 31, 2008 6.50 to 1.0 thereafter but on or prior to December 31, 2010 6.00 to 1.0 after December 31, 2010 5.50 to 1.0

  • Maximum Consolidated Total Leverage Ratio The Borrower will cause the Consolidated Total Leverage Ratio to be less than (a) 4.00 to 1.00 at all times during the period from the Effective Date to and including December 30, 2009, (b) 3.75 to 1.00 at all times during the period from December 31, 2009 to and including December 30, 2010 and (c) less than 3.50 to 1.00 at all times thereafter.

  • Consolidated Total Net Leverage Ratio Permit the Consolidated Total Net Leverage Ratio on the last day of any fiscal quarter occurring during any period set forth below, to be greater than the ratio set forth below opposite such period: Period Maximum Consolidated Total Net Leverage Ratio Closing Date through and including September 30, 2014 7.25:1.00 December 31, 2014 through and including September 30, 2015 6.75:1.00 December 31, 2015 and thereafter 6.50:1.00

  • Maximum Leverage Ratio As of the last day of each fiscal quarter, the Borrower shall not permit the ratio (the "Leverage Ratio") of (i) Consolidated Funded Indebtedness to (ii) EBITDA of the Borrower and its Subsidiaries, as at the end of and for the period of four consecutive fiscal quarters ending on such day, to be greater than (i) 2.00 to 1.00.

  • Applicable Margins The ABR Applicable Margin and the LIBOR Applicable Margin to be used in calculating the interest rate applicable to different Types of Advances shall vary from time to time in accordance with the long-term unsecured debt ratings from Xxxxx’x, and Fitch of the General Partner and the Borrower. In the event the General Partner and the Borrower have different ratings, the rating of the higher rated entity shall be used. In the event the rating agencies are split on the rating for the higher rated entity, the lower rating for such entity shall be deemed to be the applicable rating (e.g., if the higher rated entity’s Xxxxx’x debt rating is Baa1, and its Fitch’s rating is BBB, then the Applicable Margins shall be computed based on the Fitch rating), and the Applicable Margins shall be adjusted effective on the next Business Day following any change in the higher rated entity’s Xxxxx’x debt rating, and/or Fitch’s debt rating, as the case may be. The applicable debt ratings and the Applicable Margins are set forth in the table attached as Exhibit A. In the event that Fitch or Xxxxx’x shall discontinue their ratings of the REIT industry, the General Partner or the Borrower, a mutually agreeable substitute rating agency (or two mutually agreeable substitute agencies if both existing rating agencies discontinue such ratings) shall be selected by the Required Lenders and the Borrower. If the Required Lenders and the Borrower cannot agree on a substitute rating agency or substitute rating agencies within thirty (30) days after such discontinuance, or if Fitch and Xxxxx’x shall discontinue their ratings of the REIT industry, the Borrower, or the General Partner, the Applicable Margin to be used for the calculation of interest on Advances hereunder shall be the highest Applicable Margin for each Type. If a rating agency downgrade or discontinuance results in an increase in the ABR Applicable Margin, the LIBOR Applicable Margin, or Facility Fee Rate and if such downgrade or discontinuance is reversed and the affected Applicable Margin is restored within ninety (90) days thereafter, at the Borrower’s request, the Borrower shall receive a credit against interest next due the Lenders equal to interest accrued from time to time during such period of downgrade or discontinuance and actually paid by the Borrower on the Advances at the differential between such Applicable Margins, and the differential of the Facility Fee paid during such period of downgrade. If a rating agency upgrade results in a decrease in the ABR Applicable Margin, LIBOR Applicable Margin or Facility Fee Rate and if such upgrade is reversed and the affected Applicable Margin is restored within ninety (90) days thereafter, Borrower shall be required to pay an amount to the Lenders equal to the interest differential on the Advances and the differential on the Facility Fees during such period of upgrade.

  • Total Net Leverage Ratio The Borrower will not permit the Total Net Leverage Ratio as of the end of any Fiscal Quarter to exceed 3.50 to 1.00.

  • Adjusted Leverage Ratio The Borrower shall not permit the Adjusted Leverage Ratio as at the end of any Fiscal Quarter to be greater than the following for the respective periods set forth below: Period Adjusted Leverage Ratio Closing Date to and including March 27, 2004 3.75:1.00 March 28, 2004 to and including June 26, 2004 4.75:1.00 June 27, 2004 to and including July 2, 2005 5.60:1:00 July 3, 2005 and any time thereafter 5.25:1.00

  • Maximum Leverage Permit, as of any fiscal quarter end, the ratio of (a) Adjusted Portfolio Equity as of such fiscal quarter end to (b) Funded Debt as of such fiscal quarter end, to be less than 5.00 to 1.00.

  • Minimum Consolidated Adjusted EBITDA The Borrowers will maintain, as of the last day of each Fiscal Quarter commencing with the Fiscal Quarter ending December 31, 2009, Consolidated Adjusted EBITDA for the four Fiscal Quarters then ended of not less than $22,500,000.

  • Maximum Consolidated Leverage Ratio As of the last day of each Fiscal Quarter of the Borrower (commencing with the Fiscal Quarter ending March 31, 2018), the Borrower shall not permit the Consolidated Leverage Ratio to be greater than 0.60 to 1.00.

Time is Money Join Law Insider Premium to draft better contracts faster.