Non-Shrink Grout Sample Clauses

Non-Shrink Grout. 2.3.1 Non-shrink grout shall be non-metallic and shall develop a minimum compressive strength of 40 MPa in 28 days.
AutoNDA by SimpleDocs
Non-Shrink Grout. Non-Shrink Grout Placement During the pours, our inspector will periodically monitor the placement. Our inspector will be performing the following duties: • Determine the adequacy of placement and vibratory equipment; • Observe proper delivery rate of non-shrink grout and monitor batch times; • Observe that the correct mix is being utilized; • Record temperature of air and concrete; • Cast cubes for compression tests at the specified frequency. Compression Testing We will transport all samples to our laboratory for testing in strict accordance with the American Society for Testing and Materials (ASTM) requirements. Reports of compression tests will be distributed to the appropriate parties.

Related to Non-Shrink Grout

  • Voice Grade Unbundled Copper Sub-Loop Unbundled Sub-Loop Distribution – Intrabuilding Network Cable (aka riser cable)

  • Open Source Software The Software product may include certain open source components that are subject to open source licenses (“Open Source Software”), in which case, the embedded Open Source Software is owned by a third party. The Open Source Software is not subject to the terms and conditions of this XXXX. Instead, each item of Open Source Software is licensed under its applicable license terms which accompanies such Open Source Software. Nothing in this XXXX limits your rights under, nor grants you rights that supersede, the terms and conditions of any applicable license terms for the Open Source Software. Any fees charged by GC in connection with the SOFTWARE, do not apply to the Open Source Software for which fees may not be charged under the applicable license terms. The terms and conditions of the applicable license for the Open Source Software are available on the LICENSE.txt file, which is provided with the SOFTWARE.

  • Unbundled Voice Loop – SL2 (UVL-SL2 Loops may be 2-wire or 4-wire circuits, shall have remote access test points, and will be designed with a DLR provided to NewPhone. SL2 circuits can be provisioned with loop start, ground start or reverse battery signaling. OC is provided as a standard feature on XX0 Xxxxx. The OC feature will allow NewPhone to coordinate the installation of the Loop with the disconnect of an existing customer’s service and/or number portability service. In these cases, BellSouth will perform the order conversion with standard order coordination at its discretion during normal work hours.

  • Unbundled Voice Loops (UVLs) 2.2.1 BellSouth shall make available the following UVLs:

  • Unbundled Voice Loops (UVL) may be provisioned using any type of facility that will support voice grade services. This may include loaded copper, non-loaded copper, digital loop carrier systems, fiber/copper combination (hybrid loop) or a combination of any of these facilities. BellSouth, in the normal course of maintaining, repairing, and configuring its network, may also change the facilities that are used to provide any given voice grade circuit. This change may occur at any time. In these situations, BellSouth will only ensure that the newly provided facility will support voice grade services. BellSouth will not guarantee that Azul Tel will be able to continue to provide any advanced services over the new facility. BellSouth will offer UVL in two different service levels - Service Level One (SL1) and Service Level Two (SL2).

  • Mail Order Catalog Warnings In the event that, the Settling Entity prints new catalogs and sells units of the Products via mail order through such catalogs to California consumers or through its customers, the Settling Entity shall provide a warning for each unit of such Product both on the label in accordance with subsection 2.4 above, and in the catalog in a manner that clearly associates the warning with the specific Product being purchased. Any warning provided in a mail order catalog shall be in the same type size or larger than other consumer information conveyed for such Product within the catalog and shall be located on the same display page of the item. The catalog warning may use the Short-Form Warning content described in subsection 2.3(b) if the language provided on the Product label also uses the Short-Form Warning.

  • Drop Shipped Off loaded by carrier to an Agency loading dock or designated area. There will be no charge to the ordering Agency for this delivery method.

  • Rubric The rubrics are a scoring tool used for the Educator’s self-assessment, the formative assessment, the formative evaluation and the summative evaluation. The districts may use either the rubrics provided by ESE or comparably rigorous and comprehensive rubrics developed or adopted by the district and reviewed by ESE.

  • Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters).

  • Unbundled Voice Xxxx XX0 (XXX-XX0) Loops are 2-wire Loop start circuits, will be non-designed, and will not have remote access test points. OC will be offered as a chargeable option on XX0 Xxxxx when reuse of existing facilities has been requested by ONS. ONS may also order OC-TS when a specified conversion time is requested. OC-TS is a chargeable option for any coordinated order and is billed in addition to the OC charge. An Engineering Information (EI) document can be ordered as a chargeable option. The EI document provides Loop Make-Up information which is similar to the information normally provided in a Design Layout Record (DLR). Upon issuance of a non-coordinated order in the service order system, XX0 Xxxxx will be activated on the due date in the same manner and time frames that BellSouth normally activates POTS-type Loops for its End Users.

Time is Money Join Law Insider Premium to draft better contracts faster.