Even-aged Stocking Standards Sample Clauses

Even-aged Stocking Standards. ‌ Even-aged stocking standards, for the appropriate biogeoclimatic zone and site series, will be applied, as permitted under this FSP, where timber harvesting that is being carried out on the cutblock removes > 40% of the basal area of the stand that was on the cutblock before timber harvesting. Refer to Appendix A for Even-aged stocking standards.
AutoNDA by SimpleDocs
Even-aged Stocking Standards. Even-aged stocking standards for the appropriate biogeoclimatic zone and site series will be applied, as permitted under this FSP, where no significant residual tree retention has been identified. Even-aged stocking standards are specified in Table 2. No operations are planned in the ESSF, MS, or the BG subzones, so no stocking standards are specified for these subzones.

Related to Even-aged Stocking Standards

  • Licensing Standards The Contractor, its employees and subcontractors shall comply with all applicable licensing standards, certification standards, accrediting standards and any other laws, rules, or regulations governing services to be provided by the Contractor pursuant to this Contract. The State will not pay the Contractor for any services performed when the Contractor, its employees or subcontractors are not in compliance with such applicable standards, laws, rules, or regulations. If any license, certification or accreditation expires or is revoked, or any disciplinary action is taken against an applicable license, certification, or accreditation, the Contractor shall notify the State immediately and the State, at its option, may immediately terminate this Contract.

  • Manufacturing Standards All forest products except poles, produced and sold under this contract will be manufactured to maximize the amount of logs meeting preferred log lengths and to achieve the average log length listed. Agreement No. Sort # Scaling Rule 97318 3 WS Average Log Length Preferred Log Lengths "WS" indicates that west side scaling rules apply. Minimum trim is 8 inches per scaling segment for west side scaling rules. "ES" indicates that east side scaling rules apply. Minimum trim is 4 inches per scaling segment for east side scaling rules. Poles produced under this contract will be manufactured to ANSI specifications (American National Standard Specifications and Dimensions for Wood Poles), in force at the time of signing this contract.

  • Accounting Standards The Subrecipient agrees to comply with 2 CFR 200 and agrees to adhere to the accounting principles and procedures required therein, utilize adequate internal controls, and maintain necessary source documentation for all costs incurred.

  • Maintaining standards When using an Electronic Service you must:

  • MINISTRY/SCHOOL BOARD INITIATIVES ETFO will be an active participant in the consultation process to develop a Ministry of Education PPM regarding Ministry/School Board Initiatives.

  • MOST FAVORED PUBLIC ENTITY If the Contractor’s prices decline, or should the Contractor at any time during the term of this Contract provide the same goods or services under similar quantity and delivery conditions to the State of California or any county, municipality, or district of the State at prices below those set forth in this Contract, then such lower prices shall be immediately extended to the County.

  • OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.

  • Codification Section was enacted as part of the Water Resources Development Act of 1986, and not as part of the Water Resources Planning Act which comprises this chapter.

  • National Treatment and Most Favoured Nation 1. For all matters relating to the treatment of investments of investors of either Contracting Party shall enjoy, in the territory of the other party, of national treatment and most-favoured-nation treatment.

  • National Treatment and Most-favoured-nation Treatment (1) Each Contracting Party shall accord to investments of investors of the other Contracting Party, treatment which shall not be less favourable than that accorded either to investments of its own or investments of investors of any third State.

Time is Money Join Law Insider Premium to draft better contracts faster.