Extension of Defects Liability Period The Defects Liability Period shall be deemed to be extended till the identified Defects under Clause 17.2 have been remedied or rectified.
Defect Liability Period The defect liability period (if any) shall be as per Special Conditions of Contract of Part-B.
Defects Liability Period Defects liability period shall start for Instructed works immediately the works are certified as Complete by the Engineer. The period of Defects liability shall be prescribed in the Appendix to the Contract. SUBCLAUSE 49.2 – COMPLETION OF OUTSTANDING WORK AND REMEDYING DEFECTS Add At the time of End of Defects Liability Inspection, no defect arising from the permanent works existing shall be acceptable for taking over. The Inspection team shall verify and satisfy themselves that all the outstanding works and defects arising out of the works have been attended to sufficiently. Routine Maintenance works/PBC Works shall also be inspected at the time of End of Defects Liability Inspection and should comply to the specifications of the PBC Works.
Cost of remedying Defects Any repair or rectification undertaken in accordance with the provisions of Clause 17.2, including any additional testing, shall be carried out by the Contractor at its own risk and cost, to the extent that such rectification or repair is attributable to:
Title Defects If: (i) the Title Commitment reflects any exceptions to title which are not acceptable to Buyer, in Buyer’s sole discretion; (ii) the Survey discloses any state of fact not acceptable to Buyer, in Buyer’s sole discretion; or (iii) at any time prior to the Closing, title to the Property is encumbered by any exception to title not acceptable to Buyer, in Buyer’s sole discretion (with any such exception or unacceptable state of fact being referred to herein as a “Title Defect”); then Buyer may, on or before the Satisfaction Date (or, in the case of a Title Defect not disclosed by the Title Commitment prior to the Satisfaction Date, within fifteen (15) days after Buyer receives notice of such Title Defect), provide Seller with written notice of such Title Defect. Seller shall have the right, but not the obligation (except as specifically set forth below), during the thirty (30) day period after receipt of such notice, but not later than the Closing, to remove such Title Defect or obtain affirmative title insurance coverage acceptable to Buyer, insuring and defending Buyer against any loss, cost, or expense arising out of or related to such Title Defect (“Affirmative Coverage”). If Seller elects to do so, then on or before the Closing Date (as defined below), Seller shall provide Buyer with reasonable evidence of such removal or provide reasonable evidence that such Title Defect will be removed or that such Affirmative Coverage will be obtained. Notwithstanding anything contained herein to the contrary, Seller shall be obligated to expend whatever sums are required to cure or obtain Affirmative Coverage for the following Title Defects prior to, or at, the Closing:
Drawings Submitted During the Contract Term Where required to develop, maintain and deliver diagrams or other technical schematics regarding the scope of work, Contractor shall do so on an ongoing basis at no additional charge, and must, as a condition of payment, update drawings and plans during the Contract term to reflect additions, alterations, and deletions. Such drawings and diagrams shall be delivered to the Authorized User’s representative.
Certification Regarding Debarment, Suspension, Ineligibility and Voluntary Exclusion - Lower Tier Covered Transactions (a) The prospective lower tier participant certifies, by submission of this proposal, that neither it nor its principals is presently debarred, suspended, proposed for debarment, declared ineligible, or voluntarily excluded from participation in this transaction by any federal department or agency.
Correction of Defective Work 2.10.1 Design-Builder agrees to correct any Work that is found to not be in conformance with the Contract Documents, including that part of the Work subject to Section 2.9 hereof, within a period of one (1) year from the date of Final Acceptance of the Work or any portion of the Work, or within such longer period to the extent required by the Contract Documents or applicable Legal Requirements or Government Approvals.
Correction of Defects 35.1 The Engineer shall give notice to the Contractor of any Defects before the end of the Defects Liability Period, which begins at Completion and is defined in the Contract Data. The Defects Liability Period shall be extended for as long as Defects remain to be corrected.
Returns, Damaged or Defective Goods Our policy in relation to Returns, Damaged or Defective Goods shall be as specified in Our standard Terms and Conditions for the supply of Goods and Services. We shall not accept returns for change of mind or if You make a wrong decision unless due to our negligence or incorrect information supplied by Ourselves. Copyright and Trademarks The contents of this Website are at all times the copyright or trademark property of either Ourselves, Our suppliers or linked third parties and You may not distribute, reproduce, display, publish any trademark or other content of this Website for any purpose whatsoever without the prior written approval of Us, Our suppliers or linked third parties (each as applicable). Furthermore You agree to indemnify Us against any claims, costs, damages or losses incurred by Us should You fail to comply with this clause. Advertisers and Linked Sites The display on Our Website of any advertiser or the provision of a link to third party Websites does not constitute Our endorsement of either the advertiser or third party provider or any of their Website content or business practices. As We do not have any control of the content of any third party Websites, access to such Websites is at Your sole risk and We recommend that You thoroughly review the terms and conditions of use and the Privacy policies of any third party Website immediately once You access such a Website. We shall accept no liability in regards to any dealings, promotions or activities between Yourself and advertisers or third party providers. Specifications and Information Specifications and information provided on this Website are given in good faith based on Our knowledge, experience, or information provided to Us by manufacturers and/or suppliers, or derived from sources believed to be accurate at the time the information is received by Us, therefore it is recommended if You have any concerns as to the suitability of Goods or Services provided through this Website in respect of the use of the Goods or Services or their suitability for a particular use that You contact Us or seek external professional opinion. You acknowledge and accept that colours of items displayed on the Website may not reflect the true and actual colour of such items as this may be affected by external influences such as the quality of images supplied to Us for use, or the quality, age or settings on Your monitor. If colour is a major factor in Your decision making We recommend You contact Us before purchase. On-Line Ordering Display on this Website does not guarantee the availability of any particular Good(s) therefore all orders placed through this Website shall be subject to confirmation of acceptance by Us. Orders for Services shall be subject to confirmation of suitable timeframes between You and Ourselves for provision of the Services. Continuous Service Due to the inherent nature of Websites We cannot guarantee uninterrupted or continuous availability of this Website and You accept that the Website may also be unavailable from time to time for maintenance or scheduled upgrades. Where able We shall give You advanced warning of the same. We shall accept no liability in relation to Website downtime whether scheduled or otherwise.
