Apprentice An apprentice is an em ployee who is in training to become a Jour xxxxxx Meat Cutter. Apprentices must be at least sixteen (16) years of age. Apprentices may be employed at a ratio of not exceeding three (3) for each seven (7) Journeymen employed by the Employer within the jurisdiction of the Local. A quar terly report covering the number of Appren tices employed in relationship to the number of Journeymen shall be furnished the Union. The Employer agrees to rotate all Appren tices in his markets so as to give them suffi cient, well-rounded experience to qualify them as Journeymen at the end of the three
Adult Apprentices People who are 21 years of age or over at the time of entering into an apprenticeship with the Employer will be paid as per the wage rates set out in the appropriate Appendix to this Agreement. Where special or unusual circumstances occur or apply and where the parties to this Agreement and the adult apprentice agree in writing, the adult apprentice may be paid at a lesser rate, provided that the lesser rate will not be less than the rate for a junior apprentice set out in the appropriate Appendix to this Agreement.
APPRENTICES 6.36.1 The Contractor acknowledges and agrees that, if this Contract involves a dollar amount greater than or a number of working days greater than that specified in Labor Code Section 1777.5, this Contract is governed by the provisions of Labor Code Section 1777.5. It shall be the responsibility of the Contractor to ensure compliance with this Article and with Labor Code Section 1777.5 for all apprenticeable occupations.
Apprentice Wages (a) Apprentices’ rates of pay are set out in Appendix B which includes the description of the calculations.
Apprenticeship 7.01 At such time, the parties agree to a training program, it is agreed to contact the California Nevada JATC to establish such program.
Apprenticeship Program 68. The parties agree to meet to discuss the development of mutually agreeable apprenticeship programs. The specific provisions of the apprenticeship programs shall be subject to agreement between the SFMTA, the Civil Service Commission (where appropriate), and the Union. Each apprenticeship program, however, shall contain at least the following terms:
Apprenticeship Requirements The Contractor shall comply with Section 230.1(A), California Code of Regulations as required by the Department of Industrial Relations, Division of Apprenticeship Standards by submitting DAS Form to the Joint Apprenticeship Committee of the craft or trade in the area of the site.
STUDENTS AND APPRENTICES Payments which a student or business apprentice who is or was immediately before visiting a Contracting State a resident of the other Contracting State and who is present in the first-mentioned State solely for the purpose of his education or training receives for the purpose of his maintenance, education or training shall not be taxed in that State, provided that such payments arise from sources outside that State.
Apprenticeship and Training It is agreed that all Employers covered by this Agreement shall contribute a sum as listed in Schedule "A" herein for each compensable man-hour of Carpenters, including supervisory employees when covered by this Agreement. Said contribution shall be made to xxx Xxxxxxxxxx- Employers Apprenticeship and Training Trust Fund of Washington-Idaho the manner as set forth in the Trust Agreement of said Trust. The details of such Apprenticeship and Training Plan established by this Trust Fund and this Trust Fund itself shall continue to be controlled and administered by a Joint Board of Trustees composed of equal representation of labor and management who are signators to the Trust Agreement of the aforesaid Trust Fund. Each Trustee appointed by the Union shall be a member of the Union and employed by the Union and each Management trustee shall be a salaried executive or officer of a signatory Employer, or an employee of an Employer association, on behalf of its member employers.
For Company bidder(s The E-bidder’s need to key in their company details for online registration and upload a certified true copy of The Company’s Memorandum And Articles Of Association (M&A), Forms 44, 24 and 49, Board Of Director Resolution (or its equivalent forms under the Companies Act 2016) and authorize bidding letter than upload to ESZAM AUCTIONEER SDN BHD website.
