Security and Validation Procedures Sample Clauses

Security and Validation Procedures. The Scheduling Coordinator shall apply to the Meter Data of the Scheduling Coordinator Metered Entities that it represents the security and validation procedures prescribed by the relevant Local Regulatory Authority. If the relevant Local Regulatory Authority has not prescribed any such procedures, the Scheduling Coordinator shall apply the procedures set forth in the CAISO Tariff. Meter Data submitted by a Scheduling Coordinator for Scheduling Coordinator Metered Entities shall conform to these standards unless the CAISO has, at its discretion, exempted the Scheduling Coordinator from these standards.
Sample 1Sample 2Sample 3See All (39)
AutoNDA by SimpleDocs
Security and Validation Procedures. The SC shall apply to the Meter Data of the SC Metered Entities that it represents, the security and validation procedures prescribed by the relevant Local Regulatory Authority. If the relevant Local Regulatory Authority has not prescribed any such procedures, the SC shall apply the procedures set forth in the Metering Protocol of the ISO Tariff. Meter Data submitted by an SC for SC Metered Entities shall conform to these standards unless the ISO has, at its discretion, exempted the SC from these standards.
Sample 1Sample 2Sample 3See All (39)
Security and Validation Procedures. The security measures and the validation, editing and estimation procedures that the CAISO will apply to Meter Data made available to the CAISO by the CAISO Metered Entity shall be as referred to in the CAISO Tariff.
Sample 1Sample 2Sample 3See All (37)
Security and Validation Procedures. The security measures and the validation, editing and estimation procedures that the ISO will apply to Meter Data made available to the ISO by the ISO Metered Entity shall be as referred to in the Metering Protocol of the ISO Tariff.
Sample 1Sample 2Sample 3See All (7)
Security and Validation Procedures. The security measures and the validation, editing and estimation procedures that the ISO CAISO will apply to Meter Data made available to the ISO CAISO by the ISO CAISO Metered Entity shall be as referred to in the ISO CAISO Tariff.
Sample 1

Related to Security and Validation Procedures

  • Application Procedures a) An employee applies for a listing on the system-wide registry through the employee’s Human Resources Department by completing the form in Appendix B.

  • Security and Safety A. The Contractor warrants it is and shall remain in compliance with all applicable local, state and federal laws, regulations, codes and ordinances relating to fire, construction, building, health, food service and safety, including but not limited to the Hotel and Motel Fire Safety Act of 1990, Public Law 101-391. The Judicial Council may terminate this Agreement, pursuant to the termination for cause provision set forth herein, without penalty or prejudice if the Contractor fails to comply with the foregoing requirements.

  • System Security and Data Safeguards When SAP is given access to Licensee’s systems and data, SAP shall comply with Licensee’s reasonable administrative, technical, and physical safeguards to protect such data and guard against unauthorized access. In connection with such access, Licensee shall be responsible for providing Consultants with user authorizations and passwords to access its systems and revoking such authorizations and terminating such access, as Licensee deems appropriate from time to time. Licensee shall not grant SAP access to Licensee systems or personal information (of Licensee or any third party) unless such access is essential for the performance of Services under the Agreement. The parties agree that no breach of this provision shall be deemed to have occurred in the event of SAP non-conformance with the aforementioned safeguard but where no personal information has been compromised.

  • SUPERVISION AND CONSTRUCTION PROCEDURES 4.3.1 The Contractor shall supervise and direct the Work, using his / her best skill and attention. The Contractor shall be solely responsible for all construction means, methods, techniques, sequences and procedures and for coordinating all portions of the Work under the Contract. All aspects of the Project shall be subject to the inspection and approval of the State. Contractor guarantees to repair, replace, re-execute or otherwise correct any defect in workmanship, materials, or the like that fails to conform to the requirements of this Contract or that appears during the progress of the Work or within one year of final acceptance by the State.

  • COMPLIANCE WITH NEW YORK STATE INFORMATION SECURITY BREACH AND NOTIFICATION ACT Contractor shall comply with the provisions of the New York State Information Security Breach and Notification Act (General Business Law Section 899-aa; State Technology Law Section 208).

  • Safety and Security Procedures Contractor shall maintain and enforce, at the Contractor Work Locations, industry-standard safety and physical security policies and procedures. While at each Court Work Location, Contractor shall comply with the safety and security policies and procedures in effect at such Court Work Location.

  • Notification Procedures To address non-compliance, the receiving Competent Authority would notify the providing Competent Authority pursuant to Article 5 of the IGA. The notification procedures would differ depending upon whether the receiving Competent Authority seeks to address administrative or other minor errors or significant non-compliance.

  • T1 IDENTIFICATION PROCEDURES During the restoration of service after a disaster, BellSouth may be forced to aggregate traffic for delivery to a CLEC. During this process, T1 traffic may be consolidated onto DS3s and may become unidentifiable to the Carrier. Because resources will be limited, BellSouth may be forced to "package" this traffic entirely differently then normally received by the CLECs. Therefore, a method for identifying the T1 traffic on the DS3s and providing the information to the Carriers is required.

  • Security and Data Privacy Each party will comply with applicable data privacy laws governing the protection of personal data in relation to their respective obligations under this Agreement. Where Siemens acts as Customer’s processor of personal data provided by Customer, the Data Privacy Terms available at xxxxx://xxx.xxxxxxx.xxx/dpt/sw, including the technical and organizational measures described therein, apply to the use of the relevant Learning Services and are incorporated herein by reference.

  • Security Procedures The Fund shall comply with data access operating standards and procedures and with user identification or other password control requirements and other security procedures as may be issued from time to time by State Street for use of the System on a remote basis and to access the Data Access Services. The Fund shall have access only to the Fund Data and authorized transactions agreed upon from time to time by State Street and, upon notice from State Street, the Fund shall discontinue remote use of the System and access to Data Access Services for any security reasons cited by State Street; provided, that, in such event, State Street shall, for a period not less than 180 days (or such other shorter period specified by the Fund) after such discontinuance, assume responsibility to provide accounting services under the terms of the Custodian Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.