Minimum Dimension definition

Minimum Dimension means the minimum dimension of an organism based upon the dimensions of that organism’s body, ignoring e.g., the size of spines, flagellae, or antenna. The minimum dimension should therefore be the smallest part of the “body”, i.e. the smallest dimension between main body surfaces of an individual when looked at from all perspectives. For spherical shaped organisms, the minimum dimension should be the spherical diameter. For colony forming species, the individual should be measured as it is the smallest unit able to reproduce that needs to be tested in viability tests.
View Source
Minimum Dimension means the minimum dimension of an organism based upon the di mensions of that organism’s body, ignoring e.g., the size of spines, flagellae, or antenna.The
View Source

Related to Minimum Dimension

  • Minimum DSCR means, with respect to a Supplemental Loan, (i) if the Senior Indebtedness bears interest at a fixed rate, 1.25:1, or (ii) if the Senior Indebtedness bears interest at a floating rate, 1.10:1.

  • Minimum Improvements means the acquisition of land and construction of a 152-unit market rate residential apartment building, construction of a stormwater pond and related improvements. The Minimum Improvements are more fully depicted in Exhibit B, which is attached hereto and incorporated herein.

  • Minimum Term means the minimum initial period of service for each Service as shown on the Service Agreement and Order Schedule, such period to start on the date on which the relevant Service is first made available to you for use. For the avoidance of doubt, unless otherwise agreed the minimum term will be 12 months from your contract commencement date or other such date as may be notified to you in accordance with paragraph 19.2.

  • Maximum design heat input means the ability of a unit to combust a stated maximum amount of fuel per hour on a steady state basis, as determined by the physical design and physical characteristics of the unit.

  • Minimum Level (ML) means the concentration at which the entire analytical system must give a recognizable signal and an acceptable calibration point. The ML is the concentration in a sample that is equivalent to the concentration of the lowest calibration standard analyzed by a specific analytical procedure, assuming that all the method-specified sample weights, volumes and processing steps have been followed.