WHAT IS NOT COVERED (A) Products not originally covered by a manufacturer’s warranty; (B) Products with less than an original ninety (90) days manufacturer’s parts and labor limited warranty (C) Product repairs that should be covered by the manufacturer’s warranty or are a result of a recall, regardless of the manufacturer’s ability to pay for such repairs; (D) Cleaning; Periodic checkups; preventive maintenance; (E) Any and all pre-existing conditions that occur prior to the effective date of this Agreement and/or any product sold used or “AS-IS”, including but not limited to floor models, demonstrations models, etc.; (F) Part or repairs due to normal wear and tear unless tied to a breakdown, and items normally designed to be periodically replaced by You during the life of the product, including but not limited to batteries, light bulbs, etc.; (G) Damage from abuse, misuse, mishandling, introduction of foreign objects into the Covered Product, unauthorized modifications or alterations to a Covered Product; failure to follow the manufacturer’s instructions for operation and care of the Covered Product; external causes of any kind, including third party actions; fire; theft; insects; animals; exposure to weather; windstorm; sand; dirt; hail; earthquake; flood; water; acts of God or consequential loss of any nature; (H) Loss or damage caused by invasion; rebellion; riot; strike; labor disturbance; lockout; or civil commotion; (I) Incidental, consequential or secondary damages or delay in rendering service under this Agreement; loss of use during the period that the Covered Product is at an authorized service center or awaiting parts; (J) Any product used in a commercial setting or rental basis unless You purchased a Commercial Coverage Plan; (K) Failures that occur outside of the 50 states of the United States of America and the District of Columbia; (L) Non-functional or aesthetic parts including but not limited to frames, cabinets, doors, hinges, plastic parts, knobs, rollers, baskets; scratches, peeling & dents; (M) Unauthorized repairs and/or parts; (N) Cost of installation, setup, diagnostic charges, of the Covered Product, except as provided herein; (O) Accessories used in conjunction with a Covered Product including remote controls; (P) Any other loss other than a covered breakdown; (Q) Service where no problem can be found; noises; squeaks; breakdowns which are not reported during the term of this Agreement; (R) any breakdown or condition that results from abnormal usage of the Covered Product; (S) coin mechanisms.
o Check if Transfer is Pursuant to Other Exemption (i) The Transfer is being effected pursuant to and in compliance with an exemption from the registration requirements of the Securities Act other than Rule 144, Rule 903 or Rule 904 and in compliance with the transfer restrictions contained in the Indenture and any applicable blue sky securities laws of any State of the United States and (ii) the restrictions on transfer contained in the Indenture and the Private Placement Legend are not required in order to maintain compliance with the Securities Act. Upon consummation of the proposed Transfer in accordance with the terms of the Indenture, the transferred beneficial interest or Definitive Note will not be subject to the restrictions on transfer enumerated in the Private Placement Legend printed on the Restricted Global Notes or Restricted Definitive Notes and in the Indenture. This certificate and the statements contained herein are made for your benefit and the benefit of the Company. [Insert Name of Transferor] By: Name: Title: Dated: ANNEX A TO CERTIFICATE OF TRANSFER
¨ Check if Transfer is Pursuant to Other Exemption (i) The Transfer is being effected pursuant to and in compliance with an exemption from the registration requirements of the Securities Act other than Rule 144, Rule 903 or Rule 904 and in compliance with the transfer restrictions contained in the Indenture and any applicable blue sky securities laws of any State of the United States and (ii) the restrictions on transfer contained in the Indenture and the Private Placement Legend are not required in order to maintain compliance with the Securities Act. Upon consummation of the proposed Transfer in accordance with the terms of the Indenture, the transferred beneficial interest or Definitive Note will not be subject to the restrictions on transfer enumerated in the Private Placement Legend printed on the Restricted Global Notes or Restricted Definitive Notes and in the Indenture. This certificate and the statements contained herein are made for your benefit and the benefit of the Company. [Insert Name of Transferor] By: Name: Title: Dated: ANNEX A TO CERTIFICATE OF TRANSFER
Opinion of Cayman Islands Counsel for the Company The Representatives shall have received an opinion of Xxxxxx and Calder (Hong Kong) LLP, Cayman Islands counsel for the Company, dated such Closing Date, as the case may be, in form and substance reasonably satisfactory to the Representatives.
As the Accounting Agent The Accounting Agent shall provide the following services, in each case, subject to the control, supervision and direction of the respective Trust and its Board and in accordance with procedures which may be established from time to time between the Trust and the Accounting Agent (including the procedures established in the “Service Level Agreement” as defined in Section V of this Agreement):
Trust Not a Partnership; Taxation It is hereby expressly declared that a trust and not a partnership is created hereby. No Trustee hereunder shall have any power to bind personally either the Trust's officers or any Shareholder. All persons extending credit to, contracting with or having any claim against the Trust or the Trustees shall look only to the assets of the appropriate Portfolio or, until the Trustees shall have established any separate Portfolio, of the Trust for payment under such credit, contract or claim; and neither the Shareholders, the Trustees, nor the Trust's officers nor any of the agents of the Trustees whether past, present or future, shall be personally liable therefor. It is intended that the Trust, or each Portfolio if there is more than one Portfolio, be classified for income tax purposes as an association taxable as a corporation, and the Trustees shall do all things that they, in their sole discretion, determine are necessary to achieve that objective, including (if they so determine), electing such classifications on Internal Revenue Form 8832. The Trustees, in their sole discretion and without the vote or consent of the Shareholders, may amend this Agreement to ensure that this objective is achieved.
Increasing Seat Belt Use in the United States Pursuant to Executive Order 13043, 62 FR 19217 (Apr. 18, 1997), Recipient should encourage its contractors to adopt and enforce on-the- job seat belt policies and programs for their employees when operating company-owned, rented or personally owned vehicles.
Please see the current Washtenaw Community College catalog for up-to-date program requirements Secondary / Post-Secondary Program Alignment Welding HIGH SCHOOL COURSE SEQUENCE 9th Grade 10th Grade 11th Grade 12th Grade English 9 Algebra I World History/Geography Biology World Language Phys Ed/Health English 10 Geometry U.S. History/Geography Physics or Chemistry World Language Visual/Performing/Applied Arts English 11 Algebra II Civics/Economics Welding English 12 Math Credit Science Credit Welding WASHTENAW COMMUNITY COLLEGE Welding Associate in Applied Science Semester 1 Math Elective(s)* 3 WAF 105 Introduction to Welding Processes 2 WAF 111 Oxy-fuel Welding 4 WAF 112 Shielded Metal Arc Welding 4 Semester Total 13 Semester 2 Speech Elective(s) 3 WAF 106 Blueprint Reading for Welders 3 WAF 123 Advanced Oxy-fuel Welding 4 WAF 124 Advanced Shielded Metal Arc Welding 4 Semester Total 14 Semester 3 Arts/Human. Elective(s) 3 Computer Lit. Elective(s) 3 WAF 215 Advanced Gas Tungsten Arc Welding 4 WAF 288 Gas Metal Arc Welding 4 Semester Total 14 Semester 4 WAF 200 Layout Theory Welding 3 WAF 210 Welding Metallurgy 3 Soc. Sci. Elective(s) 3 WAF 226 Specialized Welding Procedures 4 Semester Total 13 Semester 5 Nat. Sci. Elective(s) 4 WAF 227 Basic Fabrication 3 WAF 229 Shape Cutting Operations 3 Writing Elective(s) 3 Semester Total 13 Program Totals 67
Potential Conflicts and Compliance With Mixed and Shared Funding Exemptive Order 7.1. The Board of Trustees of the Fund (the “Board”) will monitor the Fund for the existence of any material irreconcilable conflict between the interests of the Contract owners of all separate accounts investing in the Fund. An irreconcilable material conflict may arise for a variety of reasons, including: (a) an action by any state insurance regulatory authority; (b) a change in applicable federal or state insurance, tax, or securities laws or regulations, or a public ruling, private letter ruling, no-action or interpretative letter, or any similar action by insurance, tax, or securities regulatory authorities; (c) an administrative or judicial decision in any relevant proceeding; (d) the manner in which the investments of any Portfolio is being managed; (e) a difference in voting instructions given by variable annuity contract and variable life insurance contract owners or by contract owners of different Participating Insurance Companies; or (f) a decision by a Participating Insurance Company to disregard the voting instructions of Contract owners. The Board shall promptly inform the Company if it determines that an irreconcilable material conflict exists and the implications thereof.
WHAT IS COVERED 1. Mechanical & Electrical failures
