Use of Verizon Telecommunications Services 2.1 Verizon Telecommunications Services may be purchased by Connectel under this Resale Attachment only for the purpose of resale by Connectel as a Telecommunications Carrier. Verizon Telecommunications Services to be purchased by Connectel for other purposes (including, but not limited to, Connectel’s own use) must be purchased by Connectel pursuant to other applicable Attachments to this Agreement (if any), or separate written agreements, including, but not limited to, applicable Verizon Tariffs.
Network Services Local Access Services In lieu of any other rates and discounts, Customer will pay fixed monthly recurring local loop charges ranging from $1,200 to $2,000 for TDM-based DS-3 Network Services Local Access Services at 2 CLLI codes mutually agreed upon by Customer and Company.
Information and Services Required of the Owner § 3.1.1 The Owner shall provide information with reasonable promptness, regarding requirements for and limitations on the Project, including a written program which shall set forth the Owner’s objectives, constraints, and criteria, including schedule, space requirements and relationships, flexibility and expandability, special equipment, systems, sustainability and site requirements.
Procurement of Goods and Services (a) If the HSP is subject to the procurement provisions of the BPSAA, the HSP will abide by all directives and guidelines issued by the Management Board of Cabinet that are applicable to the HSP pursuant to the BPSAA.
RECIPROCITY AND SANCTIONS PROVISIONS Bidders are hereby notified that if their principal place of business is located in a country, nation, province, state or political subdivision that penalizes New York State vendors, and if the goods or services they offer will be substantially produced or performed outside New York State, the Omnibus Procurement Xxx 0000 and 2000 amendments (Chapter 684 and Chapter 383, respectively) require that they be denied contracts which they would otherwise obtain. NOTE: As of May 15, 2002, the list of discriminatory jurisdictions subject to this provision includes the states of South Carolina, Alaska, West Virginia, Wyoming, Louisiana and Hawaii. Contact NYS Department of Economic Development for a current list of jurisdictions subject to this provision.
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
USE OF NASA NAME AND NASA EMBLEMS A. NASA Name and Initials Partner shall not use "National Aeronautics and Space Administration" or "NASA" in a way that creates the impression that a product or service has the authorization, support, sponsorship, or endorsement of NASA, which does not, in fact, exist. Except for releases under the "Release of General Information to the Public and Media" Article, Partner must submit any proposed public use of the NASA name or initials (including press releases and all promotional and advertising use) to the NASA Associate Administrator for the Office of Communications or designee ("NASA Communications") for review and approval. Approval by NASA Office of Communications shall be based on applicable law and policy governing the use of the NASA name and initials.
Third-Party Information; Privacy or Data Protection Laws Each Party acknowledges that it and members of its Group may presently have and, following the Effective Time, may gain access to or possession of confidential or proprietary information of, or personal information relating to, Third Parties (i) that was received under confidentiality or non-disclosure agreements entered into between such Third Parties, on the one hand, and the other Party or members of such Party’s Group, on the other hand, prior to the Effective Time; or (ii) that, as between the two Parties, was originally collected by the other Party or members of such Party’s Group and that may be subject to and protected by privacy, data protection or other applicable Laws. Each Party agrees that it shall hold, protect and use, and shall cause the members of its Group and its and their respective Representatives to hold, protect and use, in strict confidence the confidential and proprietary information of, or personal information relating to, Third Parties in accordance with privacy, data protection or other applicable Laws and the terms of any agreements that were either entered into before the Effective Time or affirmative commitments or representations that were made before the Effective Time by, between or among the other Party or members of the other Party’s Group, on the one hand, and such Third Parties, on the other hand.
Emergency Standby for Goods and/or Services If any Federal or State official, having authority to do so, declares an emergency or the occurrence of a natural disaster within the State of Connecticut, DAS and the Client Agency may request the Goods and Services on an expedited and prioritized basis. Upon receipt of such a request the Contractor shall make all necessary and appropriate commercially reasonable efforts to reallocate its staffing and other resources in order to give primary preference to Performing this Contract ahead of or prior to fulfilling, in whole or in part, any other contractual obligations that the Contractor may have. The Contractor is not obligated to make those efforts to Perform on an expedited and prioritized basis in accordance with this paragraph if doing so will make the Contractor materially breach any other contractual obligations that the Contractor may have. Contractor shall acknowledge receipt of any request made pursuant to this paragraph within 2 hours from the time that the Contractor receives it via purchase order or through a request to make an expedited or prioritized purchase through the State of Connecticut Purchasing Card (MasterCard) Program (the “P-Card Program”). If the Contractor fails to acknowledge receipt within 2 hours, confirm its obligation to Perform or actually Perform, as set forth in the purchase order or through the P-Card Program, then DAS and the Client Agency may procure the Performance from another source without further notice to Contractor and without creating any right of recourse at law or in equity against DAS or Client Agency.
Technical and Organizational Measures The following sections define SAP’s current technical and organizational measures. SAP may change these at any time without notice so long as it maintains a comparable or better level of security. Individual measures may be replaced by new measures that serve the same purpose without diminishing the security level protecting Personal Data.
