Safety Inspection During inspection of County facilities conducted by the State Division of Occupational Safety and Health for the purpose of determining compliance with the California OSHA requirements, an OCEA designated employee shall be allowed to accompany the inspector while the inspector is in the employee's agency/department. The employee so designated shall suffer no loss of pay when this function is performed during the employee's regularly scheduled work hours.
IN INSPECTION Before, at the time of the Tenant accepting possession, or shortly thereafter, the Landlord and Tenant: (check one) ☐ - Agree to inspect the Premises and write any present damages or needed repairs on a move-in checklist. ☐ - Shall not inspect the Premises or complete a move-in checklist.
Final Inspection Contractor shall complete the list of items identified on the pre-final Punchlist prior to requesting a final inspection. Unless otherwise specified, or otherwise agreed in writing by the parties as documented on the Certificate of Substantial Completion, Contractor shall complete and/or correct all Work within thirty (30) days of the Substantial Completion date. Upon completion of the pre-final Punchlist work, Contractor shall give written notice to ODR and A/E that the Work will be ready for final inspection on a specific date. Contractor shall accompany this notice with a copy of the updated pre-final Punchlist indicating resolution of all items. On the date specified or as soon thereafter as is practicable, ODR, A/E and Contractor will inspect the Work. A/E will submit to Contractor a final Punchlist of open items that the inspection team requires corrected or completed before final acceptance of the Work.
Physical Inspection Subject to the limitations set forth in this Section 4.1(c) and notwithstanding any provision to the contrary in this Agreement, commencing on the Effective Date and continuing through the Closing or any earlier termination of this Agreement, Buyer shall have the right, at Buyer’s expense, to make inspections (including tests, surveys and other studies) of the Real Property and all matters relating thereto, including, but not limited to, soils and geologic conditions, location of property lines, utility availability and use restrictions, environmental conditions, the manner or quality of the construction of the Improvements, the habitability, merchantability, marketability, profitability or fitness for a particular purpose of the Real Property, the effect of applicable planning, zoning and subdivision statutes, ordinances, regulations, restrictions and permits, the character and amount of any fees or charges that must be paid to further develop, improve and/or occupy the Real Property and all other matters relating to the Real Property. Prior to Closing, Buyer and its agents, contractors and subcontractors shall have the right to enter upon the Real Property, at reasonable times during ordinary business hours, to make inspections and tests as Buyer deems reasonably necessary and which may be accomplished without causing any material damage to the Real Property including, without limitation, the right to conduct a phase I environmental audit and an investigation with respect to the Real Property’s compliance with the requirements of Title III of the Americans with Disabilities Act of 1990. Notwithstanding the foregoing, in no event shall Buyer, its agents, contractors or subcontractors conduct any invasive testing on the Real Property without Seller’s prior written approval, which approval shall not be unreasonably withheld, conditioned or delayed. Buyer shall not materially interfere with any Tenant, occupant or invitee of the Real Property in making such inspections or tests, and shall return and restore the Property to substantially its original condition prior to such inspections or tests. Buyer shall not permit any liens or encumbrances to be placed against the Real Property in connection with Buyer’s investigation and inspection of the Real Property and/or in connection with Buyer’s activities on the Real Property. Buyer hereby agrees to and shall indemnify, defend and hold harmless Seller and Seller’s members, managers, partners, officers, directors, shareholders, employees, agents, representatives, invitees, successors and assigns (each, a “Seller Group Indemnitee”), from and against any and all claims, demands, and causes of action for personal injury or property damage, and all damages, judgments, liabilities, costs, fees and expenses (including reasonable attorneys’ fees) resulting therefrom, arising out of any entry onto the Real Property by Buyer, its agents, employees, contractors and/or subcontractors, pursuant to this Section 4.1(c) hereof, provided, however, Buyer shall not be obligated to indemnify, defend or hold harmless Seller or any Seller Group Indemnitee for any such claims, demands and/or causes of action or any such damages, judgments, liabilities, costs, fees or expenses caused by: (i) the discovery of conditions that were present before Buyer or its representatives entered onto the Real Property, or the accidental or inadvertent release of any Hazardous Materials that were in, on or under the Real Property prior to such entry; or (ii) the negligent or willful misconduct of Seller or any Seller Group Indemnitee. The covenants, agreements and obligations of Buyer set forth in this Section 4.1(c) shall survive the termination of this Agreement and the Closing, as applicable.
MOVE-IN INSPECTION Before, at the time of the Tenant accepting possession, or shortly thereafter, the Landlord and Tenant: (check one) ☐ - Agree to inspect the Premises and write any present damages or needed repairs on a move-in checklist. ☐ - Shall not inspect the Premises or complete a move-in checklist.
Goods Inspection The Commissioner of DAS, in consultation with the Client Agency, shall determine the manner and prescribe the inspection of all Goods and the tests of all samples submitted to determine whether they comply with all of the specifications in the Contract. If any Goods fail in any way to meet the specifications in the Contract, the Client Agency or the Commissioner of DAS may, in its sole discretion, either reject it and owe nothing or accept it and pay for it on an adjusted price basis, depending on the degree to which the Goods meet the specifications. Any decision pertaining to any such failure or rejection shall be final and binding.
SITE INSPECTION Where a site inspection is required by the Bid Specifications or Project Definition, Bidder shall be required to inspect the site, including environmental or other conditions for pre-existing deficiencies that may affect the installed Product, equipment, or environment or services to be provided and, which may affect Bidder’s ability to properly deliver, install or otherwise provide the required Product. All inquiries regarding such conditions shall be made in writing. Bidder shall be deemed to have knowledge of any deficiencies or conditions which such inspection or inquiry might have disclosed. Bidder must provide a detailed explanation with its Bid if additional work is required under this clause in order to properly complete the delivery and installation of the required Product or provide the requested service.
Equipment Testing and Inspection 2.1.1 The Interconnection Customer shall test and inspect its Small Generating Facility and Interconnection Facilities prior to interconnection. The Interconnection Customer shall notify the NYISO and the Connecting Transmission Owner of such activities no fewer than five Business Days (or as may be agreed to by the Parties) prior to such testing and inspection. Testing and inspection shall occur on a Business Day. The Connecting Transmission Owner may, at its own expense, send qualified personnel to the Small Generating Facility site to inspect the interconnection and observe the testing. The Interconnection Customer shall provide the NYISO and Connecting Transmission Owner a written test report when such testing and inspection is completed. The Small Generating Facility may not commence parallel operations if the NYISO, in consultation with the Connecting Transmission Owner, finds that the Small Generating Facility has not been installed as agreed upon or may not be operated in a safe and reliable manner.
Inspection of Equipment The Contractor’s equipment is inspected by an authorised Eskom employee on arrival at the site. The following documentation is required to accompany the equipment where applicable: copies of all test certificates and maintenance records. Lifting equipment and electrical equipment must be marked with a unique number, code or colour code for identification. If the equipment is found to be in an unsatisfactory condition or if insufficient maintenance has been carried out on the equipment then it will not be approved for use on Site. A list of all lifting equipment and electrical equipment must be submitted to the Employer at least 2 days prior to the occupation date. This list must indicate the unique number and description of the equipment. Training requirements must comply with the Works Information and statutory requirements.
Property Inspection The Servicer is required to inspect each Delinquent Mortgaged Property at such time and in such manner as is in accordance with Prudent Servicing Practices. The Servicer must prepare a Property Inspection Report following each inspection. All Property Inspection Reports must be retained by the Servicer and copies thereof must be forwarded to the Master Servicer promptly upon request. All expenses related to the foregoing shall be recoverable by the Servicer from the Principal or from Liquidation Proceeds, Insurance Proceeds, payments on the related Mortgage Loan or any other source relating to the related Mortgage Loan or the related Mortgaged Property. The foregoing shall not preclude the Servicer from recovering such expenses from the Borrower to the extent permitted by applicable law and the related Mortgage Loan Documents.
