Introduction of Additional Non-HAP Chemicals Without Established AAAQGs Sample Clauses

Introduction of Additional Non-HAP Chemicals Without Established AAAQGs. Section II(A)(3) of the FPA provides a special procedure that Intel has committed to follow in the event that the Company introduces new chemicals to the Site in the future which generate air emissions and have not already been evaluated under the FPA, or under the AAAQG screen modeling procedure set forth above, and which present potential concerns to human health or the environment. In such a case, Intel agrees to consult with XXXXX and ADHS to determine if emissions from such a chemical may pose a health risk based on screen modeling of potential property line concentrations. As stated in the FPA, if it is determined that an emissions limit for the chemical is necessary to protect human health, Intel will limit its annual emissions below the limit which is identified.
Sample 1
AutoNDA by SimpleDocs

Related to Introduction of Additional Non-HAP Chemicals Without Established AAAQGs

  • Additional mechanisms within the Programme 5.1 Pre-defined projects

  • Distribution of UDP and TCP queries DNS probes will send UDP or TCP “DNS test” approximating the distribution of these queries.

  • Emergency Action on Imports of Particular Products Where any product is being imported in such increased quantities and under such conditions as to cause, or threaten to cause:

  • Limitation on Market Access Limitation on National Treatment Additional Commitments (b) Accounting and auditing and bookkeeping services (CPC 862) (1) None. (2) None. (3) None. (4) Unbound, except as indicated in the horizontal section. (1) None. (2) None. (3) None. (4) Unbound, except as indicated in the horizontal section.

  • BUY AMERICA REQUIREMENT (Applies only to Federally Funded Highway and Transit Projects) With respect to products purchased by Customer for use in federally funded highway projects, Contractor shall comply with all federal procurement laws and regulations with respect to such projects, including the Buy American provisions set forth in 23 U.S.C. Section 313, 23 C.F.R. Section 635.410, as amended, and the Steel and Iron Preference provisions of Texas Transportation Code Section 223.045, to the extent applicable. Contractor agrees to provide all certifications required by Customer regarding such programs. With respect to products purchased by Customer for use in federally funded transit projects, Contractor shall comply with all federal procurement laws and regulations with respect to such projects, including the Buy American provisions set forth in 49 U.S.C. Section 5323(j)(1), 49 C.F.R. Sections 661.6 or 661.12, to the extent applicable. Contractor agrees to provide all certifications required by Customer regarding such programs.

  • CFR PART 200 Domestic Preferences for Procurements As appropriate and to the extent consistent with law, the non-Federal entity should, to the greatest extent practicable under a Federal award, provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). The requirements of this section must be included in all subawards including all contracts and purchase orders for work or products under this award. For purposes of 2 CFR Part 200.322, “Produced in the United States” means, for iron and steel products, that all manufacturing processes, from the initial melting stag through the application of coatings, occurred in the United States. Moreover, for purposes of 2 CFR Part 200.322, “Manufactured products” means items and construction materials composed in whole or in part of non-ferrous metals such as aluminum, plastics and polymer-based products such as polyvinyl chloride pipe, aggregates such as concrete, class, including optical fiber, and lumber. Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, Vendor certifies that to the greatest extent practicable Vendor will provide a preference for the purchase, acquisition, or use of goods, products, or materials produced in the United States (including but not limited to iron, aluminum, steel, cement, and other manufactured products). Does vendor agree? Yes

  • Commingling of Resold Services with Unbundled Network Elements and Combinations of Unbundled Network Elements 6.7.1 To the extent it is Technically Feasible and pursuant to the terms of Section 9.1, CLEC may Commingle Telecommunications Services purchased on a resale basis with an Unbundled Network Element or combination of Unbundled Network Elements.

  • Sector Sub-Sector Industry Classification Level of Government Type of Obligation Description of Measure Source of Measure All sectors : : - : Central : National Treatment Senior Management and Board of Directors : National Treatment and the Senior Management and Board of Directors obligations shall not apply to any measure relating to small and medium sized domestic market enterprise2. Foreign equity is restricted to a maximum of 40% for domestic market enterprises with paid-in equity capital of less than the equivalent of USD 200,000 Note: Members of the Board of Directors or governing body of corporation or associations shall be allowed in proportion to their allowable participation or share in the capital of such enterprises. : -1987 Constitution of the Republic of the Philippines. - Foreign Investments Act of 1991 (R.A. No. 7042, as amended by R.A. No. 8179). -Presidential and Administrative Issuances. ∞ 2 The concept of a small and medium sized domestic market enterprise is an enterprise with paid in equity capital of less than the equivalent of USD 200,000.00.

  • How Are Distributions from a Xxxx XXX Taxed for Federal Income Tax Purposes Amounts distributed to you are generally excludable from your gross income if they (i) are paid after you attain age 59½, (ii) are made to your beneficiary after your death, (iii) are attributable to your becoming disabled, (iv) subject to various limits, the distribution is used to purchase a first home or, in limited cases, a second or subsequent home for you, your spouse, or you or your spouse’s grandchild or ancestor, or (v) are rolled over to another Xxxx XXX. Regardless of the foregoing, if you or your beneficiary receives a distribution within the five-taxable-year period starting with the beginning of the year to which your initial contribution to your Xxxx XXX applies, the earnings on your account are includable in taxable income. In addition, if you roll over (convert) funds to your Xxxx XXX from another individual retirement plan (such as a Traditional IRA or another Xxxx XXX into which amounts were rolled from a Traditional IRA), the portion of a distribution attributable to rolled-over amounts which exceeds the amounts taxed in connection with the conversion to a Xxxx XXX is includable in income (and subject to penalty tax) if it is distributed prior to the end of the five-tax-year period beginning with the start of the tax year during which the rollover occurred. An amount taxed in connection with a rollover is subject to a 10% penalty tax if it is distributed before the end of the five-tax-year period. As noted above, the five-year holding period requirement is measured from the beginning of the five-taxable-year period beginning with the first taxable year for which you (or your spouse) made a contribution to a Xxxx XXX on your behalf. Previously, the law required that a separate five-year holding period apply to regular Xxxx XXX contributions and to amounts contributed to a Xxxx XXX as a result of the rollover or conversion of a Traditional IRA. Even though the holding period requirement has been simplified, it may still be advisable to keep regular Xxxx XXX contributions and rollover/ conversion Xxxx XXX contributions in separate accounts. This is because amounts withdrawn from a rollover/conversion Xxxx XXX within five years of the rollover/conversion may be subject to a 10% penalty tax. As noted above, a distribution from a Xxxx XXX that complies with all of the distribution and holding period requirements is excludable from your gross income. If you receive a distribution from a Xxxx XXX that does not comply with these rules, the part of the distribution that constitutes a return of your contributions will not be included in your taxable income, and the portion that represents earnings will be includable in your income. For this purpose, certain ordering rules apply. Amounts distributed to you are treated as coming first from your non-deductible contributions. The next portion of a distribution is treated as coming from amounts which have been rolled over (converted) from any non-Xxxx IRAs in the order such amounts were rolled over. Any remaining amounts (including all earnings) are distributed last. Any portion of your distribution which does not meet the criteria for exclusion from gross income may also be subject to a 10% penalty tax. Note that to the extent a distribution would be taxable to you, neither you nor anyone else can qualify for capital gains treatment for amounts distributed from your account. Similarly, you are not entitled to the special five- or ten- year averaging rule for lump-sum distributions that may be available to persons receiving distributions from certain other types of retirement plans. Rather, the taxable portion of any distribution is taxed to you as ordinary income. Your Xxxx XXX is not subject to taxes on excess distributions or on excess amounts remaining in your account as of your date of death. You must indicate on your distribution request whether federal income taxes should be withheld on a distribution from a Xxxx XXX. If you do not make a withholding election, we will not withhold federal or state income tax. Note that, for federal tax purposes (for example, for purposes of applying the ordering rules described above), Xxxx IRAs are considered separately from Traditional IRAs.

  • ECR Number Environmental Commitment Record Requirements Description of ADOT Responsibilities TMP-3 The following measures will be implemented for the Selected Alternative: • All equipment exhaust systems will be in good working order. Properly designed engine enclosures and intake silencers will be used. • Equipment will be maintained on a regular basis. New equipment will be subject to new product emission standards. • Stationary equipment will be located as far away from sensitive receivers as possible. • Construction-related noise generators will be shielded from noise receivers (e.g., use temporary enclosures to shield generators or crushers, take advantage of site conditions to provide topographic separation). • Construction alerts will be distributed to keep the public informed of construction activities, and a toll-free number for construction-related complaints will be provided. • During the design phase, hours of operation will be evaluated to minimize disruptions during construction. ADOT to oversee for compliance TMP-4 Congestion from construction-related traffic will create temporary impacts in the project vicinity. The magnitude of these impacts will vary depending on the location of the sources of the fill material and of the disposition sites for surplus material, the land uses along the routes, the duration of hauling operations, staging locations, and the construction phasing. To identify acceptable routes and times of operation, ADOT, or its representative, will prepare an agreement with local agencies regarding hauling of construction materials on public streets. ADOT to oversee for compliance TP Attachment 000-0 Xxxxx Xxxxxxxx Xxxxxxx Project Record of Decision (ROD) Developer’s Environmental Commitment Requirements The following table includes the Project-specific environmental commitments as written in the ROD, with minor modifications for clarification purposes. As it relates to these Technical Provisions, references to freeway, project, South Mountain Freeway, proposed action, proposed freeway, and Selected Alternative mean the Project, and references to contractor mean Developer. Developer shall comply with and perform all of the contractor and ADOT requirements, including the ADOT obligations, commitments, and responsibilities, identified in the following table, except to the extent of those requirements that are specifically identified in the third column, entitled “Description of ADOT Responsibilities,” which are not delegated to Developer.

Time is Money Join Law Insider Premium to draft better contracts faster.