GENERAL WORK SCOPE Clause Samples

GENERAL WORK SCOPE. Outlined within this Section is a brief listing of the Work to be done by the Contractor. These descriptions are intended to be summary in nature only and are shall not be interpreted to represent the complete substance of the Work. The Work outlined herein includes process, mechanical, piping, civil, structural, instrumentation and control, electrical, architectural and pipeline tie-ins. The Work includes, but is not limited to the following: • Mobilize Contractor personnel, equipment, and material to the site(s) • Establish Contractor’s temporary facilities, security and infrastructure required for the work • Provide general site security for all sites • Receive, inventory, manage, safeguard and account for all Owner-furnished equipment and materials after free-issue to Contractor at the site(s) or Contractor designated off-site fabrication locations. Inspect all materials for damage or shortage. Any damage or shortages shall be reported to Owner immediately. After acceptance, any damage or loss will be charged to Contractor account. • Haul materials from the ▇▇▇▇ Material Yard to the site • Provide materials not furnished by Owner at Contractor’s expense. (See SECTION V) • Provide temporary lighting and utilities, if required for construction. Electrical service will not be available from the public utility until May 2017. Contractor’s generator use shall be needed until public utility power is available. • Provide civil works including all foundations, drainage and other activities • Set, level, assemble and align as required, all equipment per manufacturer specifications • Provide and erect all structural steel supports, pipe supports, racks, panel racks, cable tray supports, sono-tubes, concrete slabs, and other structures • Erect and finish all buildings and skids • Fabricate and install complete piping systems • Furnish and install all paint, insulation, coating, and heat tracing (if required) • Furnish and install all electrical systems • Install all instrument, automation and control systems • Test all installations for integrity and compliance with specifications and drawings • Pick up all construction debris from each site and dispose of in a manner approved by the OSR • Clean-up all work sites and de-mobilize Contractor’s personnel, temporary buildings, accommodations, equipment and other construction-related equipment and materials • Repair damage done at all sites due to construction and bring all sites to finished grade • Maintain one (1) “...
View Source

Related to GENERAL WORK SCOPE

  • General Scope of Work The Scope of Work and projected level of effort required for these SERVICES is described in Exhibit “A” attached hereto and by this reference made a part of this AGREEMENT. The General Scope of Work was developed utilizing performance based contracting methodologies.

  • General specifications For the purpose of this Regulation, the vehicle shall fulfil the following requirements:

  • General Scope Except for matters on which the Members’ approval is required by the Act or this Agreement, the Manager has full power, authority and discretion to manage and direct the Company’s business, affairs and properties, including the specific powers referred to in paragraph (b), below.

  • Project Scope The physical scope of the Project shall be limited to only those capital improvements as described in Appendix A of this Agreement. In the event that circumstances require a change in such physical scope, the change must be approved by the District Committee, recorded in the District Committee's official meeting minutes, and provided to the OPWC Director for the execution of an amendment to this Agreement.

  • Construction Phase Services 3.1.1 – Basic Construction Services