Electrical Tests on 11 kV Cables after Installation Sample Clauses

Electrical Tests on 11 kV Cables after Installation. The Contractor shall give the Employer at least two days’ notice of when the completed installation will be ready for inspection and site testing. Each cable including its joints and terminations shall be subject to the test as specified by SANS 97.
AutoNDA by SimpleDocs

Related to Electrical Tests on 11 kV Cables after Installation

  • Provisioning of High Frequency Spectrum and Splitter Space 3.2.1 BellSouth will provide <<customer_name>> with access to the High Frequency Spectrum as follows:

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.

  • MAINTENANCE, REPAIRS, OR ALTERATIONS The Tenant shall, at their own expense and at all times, maintain premises in a clean and sanitary manner, and shall surrender the same at termination hereof, in as good condition as received, normal wear and tear excepted. The Tenant may not make any alterations to the leased premises without the consent in writing of the Landlord. The Landlord shall be responsible for repairs to the interior and exterior of the building. If the Premises includes a washer, dryer, freezer, dehumidifier unit and/or air conditioning unit, the Landlord makes no warranty as to the repair or replacement of units if one or all shall fail to operate. The Landlord will place fresh batteries in all battery-operated smoke detectors when the Tenant moves into the premises. After the initial placement of the fresh batteries it is the responsibility of the Tenant to replace batteries when needed. A monthly "cursory" inspection may be required for all fire extinguishers to make sure they are fully charged.

  • Maintenance, Repairs and Alterations Landlord hereby covenants that the Premises shall be in reasonably good and usable condition as of the effective date of this Agreement. Replacements made by Landlord, if any, shall belong to it. Landlord shall keep access to the Premises free and clear of any and all obstructions including snow and ice. ** Portions of this agreement have been omitted and filed separately with the SEC pursuant to a confidential treatment request CONFIDENTIAL EXECUTION VERSION In the event of an emergency, Tenant shall have the right to perform any obligation of Landlord under this Agreement and recover from Landlord any reasonable amounts so expended by Tenant within thirty (30) days of the date of demand or, in the alternative, to offset amounts so expended against Rent. Landlord shall, at its sole expense, make structural repairs and replacements to the footings, foundation and structural elements of walls and roofs of the Premises and also shall be responsible for maintenance, repairs and replacements, at its sole expense, of heating, ventilating, air conditioning systems, plumbing systems, and electrical systems, provided, however, that Tenant, at its sole expense, shall be responsible for maintenance, repairs and replacements regarding the irrigation system on the Premises as well as Tenant's occupancy costs as described above in Section 4 of this Agreement and shall also be responsible for maintenance, repairs or replacements necessitated by Tenant's actions. Contact information for the Landlord in case of any maintenance, repair or replacement issues is as follows: [**]1 Additions, improvements and alterations made by Tenant, whether temporary or permanent in nature, shall be subject to the prior approval of Landlord and upon completion shall belong to Tenant, provided that removal may be made without damage to the Premises at the expiration of the Agreement term. If removal of the improvements or alterations would cause damage to the Premises, said improvements and alterations shall automatically become the property of Landlord. Tenant, at its sole expense, shall be responsible for maintenance, repairs and replacements of any additions, improvements or alterations made by Tenant on, in or to the Premises. Tenant shall keep the Premises in good order, repair and condition at all times during the Agreement term, except for ordinary wear and tear.

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Collocation of Switching Equipment CLEC may collocate any equipment that is necessary for Interconnection or access to Unbundled Network Elements.

  • No Installing Generator Not to install or keep or run any generator in the Said Apartment.

  • Provisioning Line Splitting and Splitter Space 3.8.1 The Data LEC, Voice CLEC or BellSouth may provide the splitter. When EZ Phone or its authorized agent owns the splitter, Line Splitting requires the following: a non-designed analog Loop from the serving wire center to the NID at the End User’s location; a collocation cross connection connecting the Loop to the collocation space; a second collocation cross connection from the collocation space connected to a voice port; the high frequency spectrum line activation, and a splitter. The Loop and port cannot be a Loop and port combination (i.e. UNE-P), but must be individual stand-alone Network Elements. When BellSouth owns the splitter, Line Splitting requires the following: a non designed analog Loop from the serving wire center to the NID at the End User’s location with CFA and splitter port assignments, and a collocation cross connection from the collocation space connected to a voice port.

  • Provisioning of Line Sharing and Splitter Space 3.2.1 BellSouth will provide ONS with access to the High Frequency Spectrum as follows:

  • Equipment Installation In order to meet its obligations under this Agreement, a Party that owns, rents, or leases equipment (the equipment owner) may require installation of such equipment on property owned by another Party (the property owner), provided that the property is being used for an electric utility purpose and that the property owner shall not be required to do so if it would thereby be prevented from performing its own obligations or exercising its rights under this Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.