Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria
Prescription Drug Quantity Limits We limit the quantity of certain prescription drugs that you can get at one time for safety, cost-effectiveness and medical appropriateness reasons. Our clinical criteria for quantity limits are subject to our periodic review and modification. Quantity limits may restrict: • the amount of pills dispensed per thirty (30) day period; • the number of prescriptions ordered in a specified time period; or • the number of prescriptions ordered by a provider, or multiple providers. Our formulary indicates which prescription drugs have a quantity limit. Types of Pharmacies Prescription drugs and diabetic equipment or supplies can be bought from the following types of pharmacies: • Retail pharmacies. These dispense prescription drugs and diabetic equipment or supplies. • Mail order pharmacies. These dispense maintenance and non-maintenance prescription drugs and diabetic equipment or supplies. • Specialty pharmacies. These dispense specialty prescription drugs, defined as such on our formulary. For information about our network retail, mail order, and specialty pharmacies, visit our website or call our Customer Service Department.
Dangerous Goods, Special Wastes, Pesticides and Harmful Substances Where employees are required to work with or are exposed to any dangerous good, special waste, pesticide or harmful substance, the Employer shall ensure that the employees are adequately trained in the identification, safe handling, use, storage, and/or disposal of same.
Primary Frequency Response Developer shall ensure the primary frequency response capability of its Large Generating Facility by installing, maintaining, and operating a functioning governor or equivalent controls. The term “functioning governor or equivalent controls” as used herein shall mean the required hardware and/or software that provides frequency responsive real power control with the ability to sense changes in system frequency and autonomously adjust the Large Generating Facility’s real power output in accordance with the droop and deadband parameters and in the direction needed to correct frequency deviations. Developer is required to install a governor or equivalent controls with the capability of operating: (1) with a maximum 5 percent droop ± 0.036 Hz deadband; or (2) in accordance with the relevant droop, deadband, and timely and sustained response settings from an approved Applicable Reliability Standard providing for equivalent or more stringent parameters. The droop characteristic shall be: (1) based on the nameplate capacity of the Large Generating Facility, and shall be linear in the range of frequencies between 59 and 61 Hz that are outside of the deadband parameter; or (2) based on an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. The deadband parameter shall be: the range of frequencies above and below nominal (60 Hz) in which the governor or equivalent controls is not expected to adjust the Large Generating Facility’s real power output in response to frequency deviations. The deadband shall be implemented: (1) without a step to the droop curve, that is, once the frequency deviation exceeds the deadband parameter, the expected change in the Large Generating Facility’s real power output in response to frequency deviations shall start from zero and then increase (for under-frequency deviations) or decrease (for over-frequency deviations) linearly in proportion to the magnitude of the frequency deviation; or (2) in accordance with an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. Developer shall notify NYISO that the primary frequency response capability of the Large Generating Facility has been tested and confirmed during commissioning. Once Developer has synchronized the Large Generating Facility with the New York State Transmission System, Developer shall operate the Large Generating Facility consistent with the provisions specified in Articles 9.5.5.1 and 9.5.5.2 of this Agreement. The primary frequency response requirements contained herein shall apply to both synchronous and non-synchronous Large Generating Facilities.
Pesticides In accordance with Section 17-1209 of the Administrative Code, to the extent that the Contractor or any Subcontractor applies pesticides to any property owned or leased by the City, the Contractor and any Subcontractor shall comply with Chapter 12 of the Administrative Code.
Fire, Life Safety, and Accessibility Codes The following codes, in the versions approved by the Georgia State Fire Marshal/Fire Safety Commissioner and Department of Human Resources, shall be used. The Design Professional will designate any additional codes or special modifications in the Supplementary General Conditions.
Non-Emergency Transportation Routine medical transportation to and from Medicaid-covered scheduled medical appointments is covered by the non-emergency medical transportation (NEMT) broker Medicaid program. This includes transportation via multi-passenger van services and common carriers such as public railways, buses, cabs, airlines, ambulance as appropriate, and private vehicle transportation by individuals. The NEMT broker must approve ambulance, multi-passenger van services, and transportation by common carriers. The MCO must inform enrollees of how to access non-emergency transportation as appropriate.
Food Service Waste Reduction Requirements Contractor shall comply with the Food Service Waste Reduction Ordinance, as set forth in San Francisco Environment Code Chapter 16, including but not limited to the remedies for noncompliance provided therein.
Emergency Transportation Ambulance services for emergencies.
Student Evaluation A. All unit members shall be subject to student evaluations each semester in each course taught.
