How to Obtain Warranty Service The Warranty Holder must inspect the Flooring for Manufacturing Defects caused by improper milling, grading, staining and coating, and report any such defects to Cali Bamboo, prior to installation of the Flooring. To obtain warranty service, the Warranty Holder must contact Cali Bamboo’s Customer Experience Department: xxxxxxxxxxxxxxx@xxxxxxxxxx.xxx/ 000-000-0000. Warranty claims must be received within 30 calendar days after the Warranty Holder identifies the Manufacturing Defect or other basis for a warranty claim. To be covered under this Cali Bamboo limited warranty, the Warranty Holder must provide documentation of sales order and proof that the Flooring was properly installed in accordance with the Installation Guide (defined below). Cali Bamboo reserves the right to retain a certified and independent flooring inspector to verify the Warranty Holder’s warranty claims. The determination of the flooring inspector regarding the warranty claim is not binding on either Cali Bamboo or on the Warranty Holder. A determination that does not verify the warranty claim shall not affect the Warranty Holder’s right to submit its claim to arbitration in accordance with the terms of the Arbitration Agreement (as defined in Cali Bamboo’s Terms and Conditions of Purchase). The performance of the inspection, however, if requested by Xxxx Xxxxxx and assuming that Xxxx Xxxxxx advances the full cost of the inspection as described above, is a requirement for the Warranty Holder to submit a warranty claim to arbitration under the Arbitration Agreement. For specific instructions on how to obtain warranty service for defective Flooring, visit the Cali Bamboo website xxxxx://xxx.xxxxxxxxxx.xxx/geowood-flooring-warranty/. Warranty Exclusions and Limitations: This limited warranty covers Flooring that is both (i) installed with strict adherence to Cali Bamboo’s GeoWood flooring installation guide found online at xxxxx://xxx.xxxxxxxxxx.xxx/flooring-installation/ (the “Installation Guide”) and (ii) maintained in accordance with Cali Bamboo’s GeoWood flooring care and maintenance guidelines found online at xxxxx://xxx.xxxxxxxxxx.xxx/floor-care-and-maintenance/ (the “Maintenance Guide”). Cali Bamboo will provide copies of these guides upon request by the Warranty Holder. This limited warranty only applies when the Flooring is used under normal traffic and other usage conditions. The limited warranty for Manufacturing Defects does not apply after the Warranty Holder has installed the Flooring, and product variation or error that does not exceed the 5% industry standard is not considered a Manufacturing Defect for purposes of this limited warranty. This limited warranty does not extend to or cover:
Application for Use a. The Employer agrees to accept properly executed leave applications within six (6) months of the first day of the period of leave being requested.
New Application for Licensure Any time after the three-month period has lapsed from the Effective Date of this Agreement and Respondent has paid the Administrative Penalty set forth in Section III, Paragraph 1 of this Order, Respondent may apply for a new mortgage loan originator license or, as applicable, petition for the reinstatement of an MLO Activity Endorsement in any or all of the Participating States with the understanding that each State Mortgage Regulator reserves the rights to fully investigate such application for licensure or petition for reinstatement of an MLO Activity Endorsement and may either approve or deny such application or petition pursuant to the normal process for such licensing or endorsement investigations. No license application or petition described in this paragraph will be denied solely based on the facts, circumstances, or consensual resolution provided for in this Agreement. Respondent further agrees that Respondent must satisfy the Administrative Penalty provision prior to submitting an application for a new mortgage loan originator license or, as applicable, petition for the reinstatement of an MLO Activity Endorsement.
YOUR BILLING RIGHTS - KEEP THIS NOTICE FOR FUTURE USE This notice tells you about your rights and our responsibilities under the Fair Credit Billing Act.
HHS Single Audit Unit will notify Grantee to complete the Single Audit Determination Form If Grantee fails to complete the form within thirty (30) calendar days after receipt of notice, Grantee maybe subject to sanctions and remedies for non-compliance.
We provide Message Boards for the use of Our Website users The Message Boards may not be used to promote Websites or any commercial or business activity. We are not responsible for any of the opinions expressed in the Message Boards. By posting a message to the message board You agree to take full legal responsibility and liability for your comments, including for offensive or defamatory statements. Feedback: Feedback is provided for the purpose of facilitating trading by You on Our Website. Feedback provided on other parties must not contain offensive, defamatory, retaliatory or inappropriate language or content. We may remove any feedback that is considered to be offensive, defamatory, retaliatory or inappropriate. You may only give feedback that relates to a specific transaction. You must not post feedback on a transaction that does not relate to that specific transaction. You must not post feedback about Yourself or include any contact details or Personal Information in Your feedback.
Objection Right for New Sub-processors Client may reasonably object to Data Processor’s use of a new Sub-processor for reasons related to the GDPR by notifying Data Processor promptly in writing within three (3) business days after receipt of Data Processor’s notice in accordance with the mechanism set out in Section 5.2 and such written objection shall include the reasons related to the GDPR for objecting to Data Processor’s use of such new Sub-processor. Failure to object to such new Sub-processor in writing within three (3) business days following Data Processor’s notice shall be deemed as acceptance of the new Sub-Processor. In the event Client reasonably objects to a new Sub-processor, as permitted in the preceding sentences, Data Processor will use reasonable efforts to make available to Client a change in the Services or recommend a commercially reasonable change to Client’s use of the Services to avoid Processing of Personal Data by the objected-to new Sub-processor without unreasonably burdening the Client. If Data Processor is unable to make available such change within a reasonable period of time, which shall not exceed thirty (30) days, Client may, as a sole remedy, terminate the applicable Agreement and this DPA with respect only to those Services which cannot be provided by Data Processor without the use of the objected- to new Sub-processor by providing written notice to Data Processor provided that all amounts due under the Agreement before the termination date with respect to the Processing at issue shall be duly paid to Data Processor. Until a decision is made regarding the new Sub-processor, Data Processor may temporarily suspend the Processing of the affected Personal Data. Client will have no further claims against Data Processor due to the termination of the Agreement (including, without limitation, requesting refunds) and/or the DPA in the situation described in this paragraph.
Updated Information Submission by Interconnection Customer The updated information submission by the Interconnection Customer, including manufacturer information, shall occur no later than one hundred eighty (180) Calendar Days prior to the Trial Operation. The Interconnection Customer shall submit a completed copy of the Electric Generating Unit data requirements contained in Appendix 1 to the LGIP. It shall also include any additional information provided to the Participating TO and the CAISO for the Interconnection Studies. Information in this submission shall be the most current Electric Generating Unit design or expected performance data. Information submitted for stability models shall be compatible with the Participating TO and CAISO standard models. If there is no compatible model, the Interconnection Customer will work with a consultant mutually agreed to by the Parties to develop and supply a standard model and associated information. If the Interconnection Customer's data is materially different from what was originally provided to the Participating TO and the CAISO for the Interconnection Studies, then the Participating TO and the CAISO will conduct appropriate studies pursuant to the LGIP to determine the impact on the Participating TO’s Transmission System and affected portions of the CAISO Controlled Grid based on the actual data submitted pursuant to this Article 24.3. The Interconnection Customer shall not begin Trial Operation until such studies are completed and all other requirements of this LGIA are satisfied.
Examination of an application for an industrial design 1. A formal examination of the application for an industrial design received by the federal executive authority for intellectual property is carried out which includes checks on presence of the documents specified in clause 2 of Article 1377 of the Civil Code of the Russian Federation and its compliance with the established requirements. If the result of the formal examination is positive, then a substantive examination of an application for an industrial design is carried out, which includes: information search in relation to the claimed industrial design to determine the publicly available information, which shall be taken into account when examining the design patentability; examination of the claimed industrial design for the compliance with the requirements under Article 1231.1, clause 4 of Article 1349 of the Civil Code of the Russian Federation, and the patentability criteria under the first paragraph of clause 1, clause 5 of Article 1352 of the Civil Code of the Russian Federation; examination of the claimed industrial design for the compliance with the patentability criteria under the second paragraph of clause 1 of Article 1352 of the Civil Code of the Russian Federation. An information search in relation to the objects specified in sub-clause 4 of clause 4 of Article 1349 of the Civil Code of the Russian Federation shall not be carried out, and the federal executive authority on intellectual property notifies the applicant about it. 2. If, as a result of the substantive examination of an application for an industrial design, it is found that the claimed industrial design represented on the reproductions of an external appearance of the article does not relate to the objects specified in Article 1231.1 or clause 4 of Article 1349 of the Civil Code of the Russian Federation and meets the patentability criteria under Article 1352 of the Civil Code of the Russian Federation, the federal executive authority for intellectual property makes a decision to grant a patent for an industrial design. The date of filing of the application for the industrial design and the priority date of the industrial design shall be specified in the decision. If, during the process of substantive examination of an application for an industrial design, it is found that the claimed object does not meet at least one of the requirements or patentability criteria specified in paragraph one of this clause, the federal executive authority for intellectual property makes a decision to refuse the issuance of a patent.
Terminating Switched Access Detail Usage Data A category 1101XX record as defined in the EMI Telcordia Practice BR-010-200- 010.
