COSTS DISTRIBUTED THROUGH COUNTYWIDE COST ALLOCATIONS The indirect overhead and support service costs listed in the Summary Schedule (attached) are formally approved as actual costs for fiscal year 2020-21, and as estimated costs for fiscal year 2022-23 on a “fixed with carry-forward” basis. These costs may be included as part of the county departments’ costs indicated effective July 1, 2022, for further allocation to federal grants and contracts performed by the respective county departments.
Cost Allocation Cost allocation of Generator Interconnection Related Upgrades shall be in accordance with Schedule 11 of Section II of the Tariff.
Project Cost Overruns In the event that the Recipient determines that the moneys granted pursuant to Section II hereof, together with the Local Subdivision Contribution, are insufficient to pay in full the costs of the Project, the Recipient may make a request for supplemental assistance to its District Committee. The Recipient must demonstrate that such funding is necessary for the completion of the Project and the cost overrun was the result of circumstances beyond the Recipient's control, that it could not have been avoided with the exercise of due care, and that such circumstances could not have been anticipated at the time of the Recipient's initial application. Should the District Committee approve such request the action shall be recorded in the District Committee's official meeting minutes and provided to the OPWC Director for the execution of an amendment to this Agreement.
Cost Overruns The Borrower shall ensure that all cost-overruns over the estimated construction costs of the Project as certified by a quantity surveyor or the Architect or as ascertained by the Lender as and when they occur shall be funded by the Borrower’s own equity;
Equipment Return You may use the Leased Equipment provided under this plan only while you remain an active customer in good standing and in compliance with this Agreement (including, without limitation, the RCA). You must return all Leased Equipment in good operating condition, normal wear and tear excepted, within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment. If you acquired your Leased Equipment from a retailer, then you must return all Leased Equipment to: (A) your original retailer, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming; or (B) DISH, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs after such 30-day period. You are responsible for and shall bear all costs, expenses and risk of returning your Leased Equipment, including, without limitation, risk of loss during shipment. You are not responsible under the terms and conditions of this Agreement for the return of equipment other than your Leased Equipment. Following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment (unless you acquired your Leased Equipment from a retailer and the cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming and you returned Leased Equipment to such retailer within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment), DISH will send you one or more return labels or empty boxes (depending on your Leased Equipment) to be used by you in returning your Leased Equipment and DISH will charge you up to $20.00 for each such return label or empty box (“Box Return Fee”). The Box Return Fee is subject to change at any time. Unless you are a resident of a Remote Area of Alaska, you also have the option of contacting DISH by calling 000-000-XXXX (000-000-0000) to request that DISH or our designee(s) perform an in-home service call to remove your Leased Equipment at DISH’s then-current in-home service call rate, which rate is subject to change at any time. Leased Equipment will not be deemed returned until received by DISH. DISH Protect ===> Signature: DISH Protect is an optional service program currently priced as set forth in the table below. DISH Protect is offered in two (2) plans: Dish Protect and Plus. The services offered in each plan can be viewed at xxxxxx.xxx/xxxxxxxxxxx. If you enroll in a DISH Protect plan, you will receive an initial six (6) month trial offer of DISH Protect if you are eligible and if such plans are otherwise available to you at the time you sign this Agreement. During the trial offer period, you will be charged the monthly Trial Offer Price set forth below. By signing above, you are accepting the terms of this trial offer and understand that you may cancel or change your DISH Protect plan at any time by calling 000- 000-XXXX (3474) or by emailing xxxxxxxxxxxxxxxxxxxxxxxx@xxxx.xxx. You also agree that if you do not cancel your DISH Protect plan during the initial six (6) month trial offer period, DISH will automatically begin billing you the then-current monthly Regular Price of your DISH Protect plan upon the expiration of the six (6) month trial offer period until you cancel your DISH Protect plan. Not all DISH Protect plans are available to all customers. DISH Protect is not available to residents of Remote Areas of Alaska and/or residents of some Shared Dish MDU Properties. If you reside in a Shared Dish MDU Property and you are not sure if you qualify for DISH Protect, then please call 000-000-0000 to determine if you qualify. Plan Regular Price/month Trial Offer Price/month DISH Protect $10.99 $0.00 DISH Protect Plus $10.99 $0.00
CAISO Monthly Billed Fuel Cost [for Geysers Main only] The CAISO Monthly Billed Fuel Cost is given by Equation C2-1. CAISO Monthly Billed Fuel Cost Equation C2-1 = Billable MWh ◆ Steam Price ($/MWh) Where: • Steam Price is $16.34/MWh. • For purposes of Equation C2-1, Billable MWh is all Billable MWh Delivered after cumulative Hourly Metered Total Net Generation during the Contract Year from all Units exceeds the Minimum Annual Generation given by Equation C2-2. Equation C2-2 Minimum Annual Generation = (Annual Average Field Capacity ◆ 8760 hours ◆ 0.4) - (A+B+C) Where: • Annual Average Field Capacity is the arithmetic average of the two Field Capacities in MW for each Contract Year, determined as described below. Field Capacity shall be determined for each six-month period from July 1 through December 31 of the preceding calendar year and January 1 through June 30 of the Contract Year. Field Capacity shall be the average of the five highest amounts of net generation (in MWh) simultaneously achieved by all Units during eight-hour periods within the six-month period. The capacity simultaneously achieved by all Units during each eight-hour period shall be the sum of Hourly Metered Total Net Generation for all Units during such eight-hour period, divided by eight hours. Such eight-hour periods shall not overlap or be counted more than once but may be consecutive. Within 30 days after the end of each six-month period, Owner shall provide CAISO and the Responsible Utility with its determination of Field Capacity, including all information necessary to validate that determination. • A is the amount of Energy that cannot be produced (as defined below) due to the curtailment of a Unit during a test of the Facility, a Unit or the steam field agreed to by CAISO and Owner. • B is the amount of Energy that cannot be produced (as defined below) due to the retirement of a Unit or due to a Unit’s Availability remaining at zero after a period of ten Months during which the Unit’s Availability has been zero. • C is the amount of Energy that cannot be produced (as defined below) because a Force Majeure Event reduces a Unit’s Availability to zero for at least thirty (30) days or because a Force Majeure Event reduces a Unit’s Availability for at least one hundred eighty (180) days to a level below the Unit Availability Limit immediately prior to the Force Majeure Event. • The amount of Energy that cannot be produced is the sum, for each Settlement Period during which the condition applicable to A, B or C above exists, of the difference between the Unit Availability Limit immediately prior to the condition and the Unit Availability Limit during the condition.
Deposit Pay ment of The Fixed Reserve Price 5.1. E-Bidders must make deposit payment as required under the Conditions of Sale attached to Proclamation of Sale, i.e. 10% of the reserve price.
Global Access Transport Charges (U S. Bridged): Per-minute per-bridge port usage charges, based on availability of service, zone and origination access type. Bridging charges are additional and are priced at Customer's applicable Toll Meet Meet-Me Access rate per minute. Freephone (IFN) Transport Zone A – G. Discounts:
Fire Suppression Costs Purchaser’s obliga- tions for cost of fire suppression vary according to three classifications of fires as follows:
Temporary Credit for Unamortized Specified Road Construction Cost When, under B8.33, Contracting Officer orders a delay or interruption of Purchaser’s Operations for more than 30 days when scheduled operations would be occurring but for the order, the Contracting Officer shall credit the unamortized cost of Specified Roads to Purchaser’s Timber Sale Account, upon the written request of Purchaser or at the discretion of Contracting Officer. The amount credited to Purchaser shall be limited to stumpage paid above Base Rates. Any Specified Road construction cost credited to Purchaser pursuant to this Subsection may be refunded or transferred at the request of Purchaser. However, if Purchaser has outstanding debt owing the United States, Contracting Officer must apply the amount of credit that could be refunded to the debt owed in accordance with the Debt Collection Improvement Act of 1996, as amended. Upon written notice from Contracting Officer that the basis for the delay or interruption no longer exists, Purchaser shall pay for timber a per unit amount, in addition to Current Contract Rates, that is equal to the amount credited to Purchaser’s Timber Sale Account divided by 80 percent of the estimated remaining volume of the contract, until the full amount credited to Purchaser has been returned.
